A rectangular waveguide is used to transmit power from a generator to a radar antenna. The guide has internal dimensions of 0.864 cm and 0.432 cm and operates at 23 GHz in TE10 mode. The transmitted power is 50 kW. Determine the magnitudes of the electric and magnetic field strengths in the guide.

Q: For L1=13 H, L2=10 H, L3=10 H, L4-30 H, L5=75 H, L6=30 H, L7=24 H & L8-59 H in the circuit shown…

A: Given: A network,  with, , and considering no energy stored in the inductors. To find: Equivalent…

Q: Question 6 Using superposition, find the current I through the 6 9 resistor of Fig. 6. + E₁ = 20 V Z…

A:

Q: In an n-type silicon sample, the donor concentration at 300 K is 5 x 1014/cm3 that corresponds to 1…

A: We need to find out the electrons and hole concentration of given sample .

Q: For the following circuit find currents through each light bulb in then find the source current Is…

A: For the given circuit, we need to find current through each bulb and the value of source current.

Q: X. دو Clock- Q₂ D₂ D using AND delay = 2 ol D₁ D determine the maximum clock frequency in…

A:

Q: The peak-to-peak voltage is 40V, its rms voltage is 14.1 V 11.4V 13.3V 12.3 V

A: Peak to peak voltage Vp−p=40 V.

Q: (b) Given the operational amplifier-based circuit below, and by assuming that Op-Amp is ideal,…

A:

Q: #Z) FIND Vc in the network VA/2 LV (I +VA -2K_2 V.

A: We need to find out the output voltage for given circuit.

Q: A. What is the cross over distortion in class B?

A: In the given questions we need to discuss about the cross over distortion in class B amplifier.

Q: 1. A certain conductor has a resistance of 0.5 ohm. Calculate the conductance of the conductor of…

A: Case 1: Resistance R1=0.5 Ω.. Let the initial length is L1=L.. Let the initial diameter D1=D. Case…

Q: 30 V 2 ΚΩ Obtain Vo in the circuit of Fig Q10 below. (Ans: 20V) +1 20 V 5 ΚΩ +1 4 ΚΩ + Vo

A:

Q: An electromagnet has a 30 Ω winding with an inductance of 106 mH that works at 240 VAC - 60 Hz.…

A: In this question we need to find the wattage of the given winding.

Q: An earth satellite has onboard a 12-v battery that supplies a continuous current of 0.5A. Solar…

A: Voltage of battery =12 v Continuous Current supplied by battery =0.5 A  Time the solar cells…

Q: Find the poles, zeros and the pole-zero representation of the system with the transfer function:

A: here we have to find the zeros and poles. and the pole-zero representation.

Q: Please solve No. 1 below. Please provide a clear and readable solution. I appreciate any help you…

A: From question Transfer in Signal flow graph

Q: Q3) The Voltage-divider bias circuit shown below is to be designed operate Efficiently stabilized.…

A: For the given voltage divider bias circuit the value of the bias resistor needs to be calculated.…

Q: The op amp in the circuit Figure 8 ΚΩ (Figure 1) is ideal. Suppose R = 15 kn 240 mV 60 ΚΩ 30 ΚΩ +…

A: We need to calculate the node voltage and branch current.

Q: 2. Use source transformation to find io. 4 Α 18 V| io 4 Ω Μ 3 Ω 10 Ω 2 Ω Μ 5Ω Μ 2 A

A:

Q: 28. A 3.00 uF and a 4.00 uF capacitor are connected in series, and this combination is connected in…

A: Asked to find Net capacitance Cnet  Voltage across each capacity Charge on each capacitor

Q: SW DETERMINE (a) fosc (6) B (c) Av (d) Rf THE FOLLOWING let C = C₁ = C₂ R = R₁ = R₁₂ = R3 C3 = 2 C

A: According to the question, for the given RC phase shift oscillator as shown below We need to…

Q: How many bits are required to represent 6 unique numbers? 6 02 -2.58 3

A: How many bites are required to represent 6 unique numbers

Q: 3. Consider the LED driver circuit to the right. Vcc=5V.Vin = SV, B= 200, and V, for the LED is 2 V…

A: Given Circuit: Given Data: β=200 VCC=5V Vin=5V Vf=2V for If=20mA   To determine: Value of R1 to…

Q: 1. Assuming the full adder drives a load L=1.5, determine the critical path and its corresponding…

A: According to the question, for the given circuit as shown below 1. Assuming the full adder drives a…

Q: Write a brief report on the electrical power subject that was studied in the second Explaining the…

A: Dear student, Since you have posted multiple questions, we will provide the solution only to the…

Q: 3. For the network of Figure 3, determine: a. V₁ b. ID and VGS c. VD and Vs d. VDs VG 910 ΚΩ + Vase…

A:

Q: What is a rectifier? 2. How does a diode act as a rectifier? 3. What is the significance of PIV?…

A:

Q: Calculate 11, 12, 13 and 14: 80 -j2Q 14 J40 10/0° A 60 12 h +1 50/30° V

A: Given: A network,    To find: Currents I1, I2, I3 and I4.

Q: Millimeter-wave radar generates a narrower beam than conventional microwave radar, making it less…

A:

Q: H(s): 6s² + 18s +12 2s³ +10s² +16s+12

A:

Q: Q1/ What is bit is the output voltage for digital-to-analog Convertor Consider Rf = 1k (1101) 5V-…

A:

Q: A long transmission line delivers a MVA at 124 KV, 50 Hz of 0.8 pf lagging B = 25.3√2 Resistance of…

A: Given data: Load (S) = 60 MVA Voltage (V) = 124 kV Power factor (pf) = 0.8 lagging Resistance (R) =…

Q: A 2300-V 1000-hp 0.8-PF leading 60-Hz two-pole Y-connected synchronous motor has a synchronous…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: A SSB signal is generated by modulating an 800 kHz carrier by signal m (t) = cos (2000nt) +2Sin…

A: According to the question, a SSB signal is generated by modulating an 800 kHz carrier by signal m…

Q: The op amp in the circuit shown in (Figure 1) is ideal. Figure 15 ΚΩ 30 ΚΩ 48 ΚΩ w +● {45 ΚΩ 10 V…

A: As per our company guidelines we can answer only first three sub parts please submit remaining sub…

Q: 7. Consider a circuit shown in figure switch was open for a long time and closed at t = 0. All…

A: In this question we need to find the maximum value of potential difference between points A & B

Q: In a certain delta-connected balanced load, with line voltages of 230 V and impedances of 60 35°…

A:

Q: Q2: Repeat Q1 for a band-stop filter having the ideal response: TT 1, |w|≤ = 0, Ha(w)= = 1, 7673…

A: Given: Frequency response of a digital filter,  Hdω=1;ω≤π60;π6<ω≤π31;π3≤ω≤π, To find: Coefficient…

Q: A 10 V amplitude sinusoidal signal is used as a modulating signal to generate an AM signal with…

A:

Q: Problem 2. If the signal, x(n), shown below is bandlimited to @Max-π/10 rad, what is the maximum…

A: The above question is based on Nyquist's sampling criterion. It states that the minimum sampling…

Q: 2-(XXXXX) (YY) (YY)

A:

Q: 4. For the network of Figure 4, VD = 12 V. Determine: a. lp 18 V b. Vs c. VDS d. VG e. VGS f. Vp 12…

A:

Q: Analyze the sinusoidal AC circuit and solve using KCL, KVL, or Nodal Analysis Solve for nodal…

A:

Q: Question # 2: One circuit of a single-phase transmission line is composed of three solid 0.5 cm…

A: The arrangement of conductors can be redrawn as, Inductance | phase | m L=2×10-7 lnDmDs H/m So, the…

Q: d. Determine A, (with r = ∞). e. Repeat parts (c) and (d) including ro = 50 kn in all calculations…

A:

Q: Homework D2.2. A charge of -0.3 μC second charge of 0.5 μC is at (b) P(15, 20, 50) cm. is located at…

A:

Q: Q: A transistor dissipates 50W in an ambient temperature of 60°C, the thermal resistances are 0-0.5…

A: The circuit diagram of transistor heating and cooling is  where,             Pavg =average rate of…

Q: Find the inverse Laplace transform of the function. In other words, find f(t). F(s) = 3+25+1

A:

Q: Qz/Write down the characteristics of the ideal op amp. 2/1

A:

Q: Find the impedance Zab in the circuit below if Z₁ = 10 + Sjo a Zab be O a. 277.7+138.8 m) O b.…

A:

Q: Consider a single chip package (SCP) with a minimum pitch (space between leads) of 0.4 mm and 1000…

A: A single chip package with a minimum pitch of 0.4 mm and 1000 leads