A proposed office building will include a 10 ft x10 ft square, 3 ft deep (the footing height is also 3 feet) spread footing. The normally consolidated clay has the following engineering properties: Ydry = 115.0 pcf $'=24° c'=90.0 psf Cc/(1+eo) = 0.15 The soil stratum extends to a great depth, and the ground water table is 50 ft below the ground surface. Using the classical piece-wise log-linear method, estimate the total settlement of this footing considering only the allowable bearing pressures using ASD approach. The unit weight of concrete is 150 pcf. State any assumptions made.

A proposed office building will include a 10 ft x10 ft square, 3 ft deep (the footing height is also 3 feet) spread footing. The normally consolidated clay has the following engineering properties: Ydry = 115.0 pcf $'=24° c'=90.0 psf Cc/(1+eo) = 0.15 The soil stratum extends to a great depth, and the ground water table is 50 ft below the ground surface. Using the classical piece-wise log-linear method, estimate the total settlement of this footing considering only the allowable bearing pressures using ASD approach. The unit weight of concrete is 150 pcf. State any assumptions made.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

绘图编辑 3.12 For a strip foundation, the width is 1.2m, buried depth is 1.2m, the standard value of the load applied on the foundation F=155KN/m, the soil layer is distributed as follows: from the ground to the depth of 1.2m is the land fill, =18KN/m³; the depth in the range of 1.2~1.8m is silty clay, fak=155kPa, E,=8.1Mpa, y=19KN/m³; below the depth of 1.8m is the mucky clay, fak=102kPa, E,=2.7Mpa. Try to check the base pressure and the bearing capacity of the weak sub-layer. Ground F=155KN/m OLand fill 18KN/m³ 1.2m O Silty clay La-155kPa;E-8.1Mpa;y-19KN/m³ -0, 1.0 O Mucky clay -0, H1.0 Sak-102kPa;E,-2.7Mpa 1.2m
A 100'x50' mat foundation (also called slab-on-grade) will be placed at the site shown in Figure 1. Calculations show that the foundation will cause an average increase in vertical stress in the clay layer of (a) 850 psf under the foundation center, and (b) 350 psf under the foundation corner. Find the foundation settlement due to the consolidation of the clay layer both at the foundation center and the foundation corner. Can the resultant differential settlement be considered tolerable? Sand Clay Bedrock 2.5 ft 5 ft 5 ft 7-100pcf 122.5pcf, eo=1, op=1000psf Cc-0.5, Cs-C-0.1 Figure 1.
Please show all work and help me out! I will leave good response!
Ignoring the given Es-data and considering that the supporting soil is clean, normally consolidated sand with the following available data: A rigid shallow foundation 1x 2m is shown in the scheme. Cakulate the elastic setlement at the centre of the foundation. q=150Pa 1m 10000 Sand -03 2 8000 12000 www Scheme 1.2 Im Sand 2,m 0-25 7 25-65 11 65-10.0 14 Scheme 13 Assume the rodk layer exists at depth z- 10m. C Expand Transcribed Image Text A rigid shallow foundation 1x 2 m is shown in the scheme. Calculate the elastic settlement at the centre of the foundation. q= 150 kPa im E, (kPa) 1m. 110000 Sand Hs=0.3 2 8000 34 12000 Rock Scheme 3.21m g=150 kPa z, m Sand Hs =0.3 0-2.5 7 2.5- 6.5 11 6.5- 10.0 14 Scheme 3.3 Assume the rock layer exists at depth z= 10 m. (u) z
The following results were obtained from CU tests on a clay soil that is the foundation material for an embankment. 03 (kPa) 300 400 600 0₁-03 (kPa) 331 420 487 Au (kPa) 111 160 322 (a) Determine the total and effective principal stresses for all three tests (You may summarize them in a table). (b) Recommend the shear strength parameters to be used for short-term and long-term analyses. The maximum confining pressure (cell pressure) at the depth of interest is 300 kPa. (Note: the clay is a normally consolidated one).
A square footing 5 ft by 5 ft supported on a sandy stratum is designed to carry a column loading of 250,000 lb. The unit weight of the sands underlying the footing location vary between 120 and 125 pcf. Estimate the foundation settlement to be expected using the subgrade reaction method. (Neglect the weight of the footing.)
Show all work please be neat
Problem #4 At a development site in Cebu, City, a plate-load test was conducted on soil whose properties resemble that of sand. The plate used in this PLT is 62 cm square. The ultimate load per unit are (qu) for the test was found to be 620 kN/m2. What should be the maximum allowable load of a 2.5 m square footing? Use a factor of safety of 3. Answer in N.
According to Terzaghi's equation, the bearing capacity of strip footing resting on cohesive soil (C = 10kN/m2) per unit depth and unit width (Nc = 5.7) will be.
A new residence has a column load of 24000 kN. This is supported via a 3m by 4m rectangular footing whose bottom is 1m below the surface of this homogenous lateritic soil layer. 5m below the footing, there is a 6m thick clay layer. The clay layer has a unit weight of 18.0 kN/m³, void ratio (e) of 0.67, and compressibility index (Cc) of 0.237. The lateritic soil has a unit rate of 19 kN/m³ Find the vertical stress increment at the depth of Sm below the centre and corner of the loaded area.
Why the bearing capacity of soil reduces when the groundwater table rises up to the ground surface? point: a) Because the effective unit weight. of the soil below the footing will reduce by almost half. b) Because the effective stress at the level of the base of foundation will reduce significantly. c) Both a and b. d) Because groundwater produces seepage.