A pacemaker has an RC circuit that control the time of voltage giving out. A suitable time constant τ = 8 ms. The instant voltage after 8 ms is _____ % of start voltage. I keep getting 63.21% and it is wrong. I don't understand what I'm doing wrong.

Q: CE amplifier uses a BJT with B = 100 biased at IC = 0.5 mA and has a collector resistance RC = 15 kN...

A:

Q: +2 lim,0 3+2x В.

A:

Q: (a) As shown in Figure 1(a), a power transmission line carries current 180 A from a 6000 V generator...

A:

Q: An ideal 220/110-V transformer carries a (4+j5) ohms load at 110-V side. Under this condition, calcu...

A: Primary voltage, V1 = 220 V Secondary voltage, V2 = 110 V Load impedance, Z = 4 + j 5 Ω  

Q: 2: Calculate the thermal equilibrium electron ncentration in silicon at T=300K for the case ergy lev...

A:

Q: ectrician A says that a circuit breaker marked 120/240 V is acceptable for a circuit that doesn't ex...

A: Answer: B.  Electrician A is correct  

Q: What is the equivalent resistance of the circuit shown above if R1 9.0 Q and R2 6.0 Q? O0.67 2 O3.60...

A: The equivalent resistance can be calculated by removing the voltage source from the circuit and then...

Q: 2. A small island community in the Northern part of our country does not have electricity. However, ...

A: Resources of energy Coal for thermal power plant Wind speed for wind energy Kinetic energy of water...

Q: A CE amplifier uses a BJT with B = 100 biased at IC = 0.5 mA and has a collector resistance RC = 15 ...

A:

Q: A singer voice is sampled for 8 second by an 8-bit ADC at a sampling frequency of 20 kHz. The sample...

A:

Q: 8. Refer to the graphics appendix. What is the current flow through R3? 23.3 mA 21.85 mA 8.75 mA 71....

A:

Q: Magnetic fields are characterized by the existence of a detectable magnetic force at every point in ...

A: According to the question, Magnetic fields are characterized by the existence of a detectable magnet...

Q: if a transformer has a primary rated voltage of 480V and requires 40V to produce the rated current i...

A:

Q: i)Modulation process takes place in the modulator with two injection signals namely data or informat...

A: Please refer the attached images for the complete answer..

Q: A 4-pole, wave-wound, 750 rpm shunt generator has field resistances of 0.4 ohm and 200 ohms, respect...

A: The solution is given below 

Q: in a series circuit, one element is known to be 16 millihenry inductor and the others are unknown. T...

A:

Q: The circuit shown in the following in figure has: VIN 10 V, Vz 7.2 V@ Iz-40 mA, IzK =2 mA, Iz= 100 m...

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part ...

Q: What is the value of a C103 ceramic disk capacitor? (circle all that apply) 10 nF O 10 mF 10,000 pF ...

A: Here, the number of the capacitor is C103

Q: Problem 4 Use the definition of complex power to calculate real and reactive power for the load of R...

A: In this question we will find real and reactive power of load with the help of complex power....

Q: R1 3 R2 R3 10 V1 10 V2

A: The given circuit diagram is shown below:

Q: 5. Given the circuit, solve for the 0.2 0 a. Total resistance 0.10 b. Total current 12 V- 1.0 0 c. T...

A: Note:- As, it was asked to solve the (question-5) The solution can be obtained as follows. The given...

Q: The following figure shows: 21x Oa. A dependent current controlled current source Ob.A dependent cur...

A: The given figure is,

Q: A shunt generator delivers 195 A at a terminal p.d. of 250 V. The armature resistance and shunt fiel...

A: Given, Load current, IL=195 A Terminal voltage, V=250 V Armature resistance, Ra=0.02 Ω Shunt field r...

Q: Derive expressions for energy levels and wave functions for a particle of mass M on an infinitesimal...

A: A frequent application of a quantum mechanical model to a simplified system consists of a particle t...

Q: Question-4: Design a positive biased limiter circuit (use silicon or germanium diode) that limit the...

A:

Q: Calculate the value of Xc for the circuit. Please show

A: In this question we will find capacitive reactance from given voltage and current...

Q: Write atleast 2 diadvantages of PLC.

A: 1 . PLC is the Fixed circuit Operation 2.  There are limitations of operation of              PLC un...

Q: Region 1 (y 0) contains dielectric medium with e = 6 E, and p2 = 2.75 Ho- Draw a figure which defin...

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts fo...

Q: A series circuit conducting of a 30-uf capacitor and a 0.155-henry inductor is connected to a 120-vo...

A:

Q: The maximum flux density in the core of a 3000/240-V, 50 Hz single-phase distribution transformer is...

A:

Q: (c) Figure 3(c) shows a three-phase, positive sequence A-A connected circuit with a line impedance o...

A:

Q: What is the expected voltage measurement across C4 if VDc = 9V? C, C2 C3 Vpc H

A:

Q: 2. Apply Ohm's law to the following problems: a. A current of 0.0021 A flows to a resistor having a ...

A: By ohms law , Voltage across the resistor = current ×resistance.   

Q: 33. The equivalent resistance between points 1 and 2 of the circuit shown is: 1n: w 2 so

A: This question belongs to circuit theory . It is about calculation of equivalent resistance of the ci...

Q: 7-1 In a step-down converter, consider all components to be ideal. Let v, V, be held constant at 5 V...

A: As per guidelines, we can only provide the answer of first question in multiple type of question. He...

Q: i)Most electronic circuits in communication are used to process signals which can be in digital or a...

A:

Q: 1.Find I, in the cireuit of Figure 1. 1Ω 4 A 21. 8Ω 2Ω ww ww

A: Given circuit,

Q: IGNORE (NOT YẾT COVERED) Find maximum power across the terminals a-b, 62 6V 603 (b)를w (d)를 W (c) 2 W

A: Here, we have given an electrical circuit having no. of resistors in series and parallel manner.  A ...

Q: 8. The apparent power dissipated by the source is (in VA):

A:

Q: 1 The force of an electrostatic field f (x, y, z) has the direction of the gradient of f. Find Vf an...

A: Given  1. f = (x-1)2- (y+1)2, P(4,-3)  Find gradient of f and find its value at point P(4,-3). 2. Fi...

Q: 21. Given a capacitance of 30 nF and a voltage of 30 J, compute for the charge and energy.

A:

Q: Calculate the total capacitance in the series circuit

A: In this question series circuit of capacitances is given....We have to find out total capacitance......

Q: Using the following matrix, please come up with a state space representation with the following para...

A: Output response is given asy1t=2θ1ty2t=4θ1t+3θ2t+ςty1ty2t=2043θ1tθ2t+01ςt-----1This is state space r...

Q: what do you mean by loss of selectivity between two overcurrent relays in adjoining line sections? w...

A: Selectivity- It is a quality of a circuit or an element in which how quickly it responds to a partic...

Q: Given the circuit below. i, (t) = v210 cos(377t). Give your answer in four decimal places if it is n...

A:

Q: Figure 592 Z2 z1 v1(s) V2(s) R = R1 || R2 or not present V2(s) Ds + Es + F V1(s) Ds + Es + F V2(s) V...

A:

Q: 7. Given the following resistance R, = 10 Q, R2 = 6 N, R3 = 50, R, = 20 Q and voltag V, = 12V and V,...

A:

Q: Q9. Determine the voltmeter reading in Figure 2, if the 4.7 kN (R3) resistor is open. What is the re...

A: We will replace the voltmeters with the symbols for voltmeter. So, the simplified circuit will look ...

Q: What are the main differences between a capacitor and an inductor? Discuss FIVE of them.

A: The voltage current relationship of an inductor is vL = L diLdt The voltage current relationship of ...

Q: 2. Apply Ohm's law to the following problems: a. A current of 0.0021 A flows to a resistor having a ...

A: