A nozzle discharges 155lit/sec with a velocity of 35m/s. The entire jet strikes a vane moving in the same direction as the jet with a velocity of 20m/s. Compute the Force exerted on the vane Choices: 1924.13 1942.13 1294.31 1429.13 Note:please base your answer on the given choices thanks for the help and please help me in this sampl question

Q: Determine the discharge of a flowing fluid from a nozzle, whose specific gravity is 1.3, the nozzle…

A:

Q: A cylindrical tank 1m in diameter and 3m tall weighs 3.86kN. Given: ylead = 100kN/m3. 14. Which of…

A:

Q: Problem 6-76 Oil is flowing upward through a Venturi meter as shown Assuming discharge coefficient…

A:

Q: Water flows from a hose bib at a rate of 15.8 gallons per minute. What is the rate in liters per…

A: Given data: Flow rate = 15.8 gallons per minute = 15.8 gallonsminute As we know, 1 gallon = 3.785412…

Q: An irrigation line carries water from a lake down into an arid valley 810 ft below the surface of…

A:

Q: A cylindrical tank 400 mm in diameter, discharges water through a 30 mm diamater orifice under a…

A: Given, Diameter of the cylindrical tank, D= 400mm Diameter of the orifice, d= 30mm Constant head, H=…

Q: Problem 9: Castor oil (SG = 0.96) A tank whose bottom is 18 inches x 18 inches is filled with 2 in.…

A: Give data: The unit weight of caster oil = specific gravity of caster oil x unit weight of water =…

Q: A liquid whose specific gravity is 2.0, is flowing in a 150mm diameter pipe. The total head at a…

A:

Q: The speed of the air passing through a pipe with a small diameter section of 10 cm2 is 4.12m / s.…

A: Given, area of section A1 = 10cm²                             Air speed v1 = 4.12m/s Now,  Magnified…

Q: The diving bell has the shape of a frustum of a cone (circular) with a closed flat top and open…

A: 1.The volume of empty =(π/3)*H[h12+h22+h1h1]…

Q: Two water tanks are connected to each other through a mercury manometer with inclined tubes. For a…

A:

Q: Water flows from a large reservoir at the rate of 1.20 ft/s through a pipe system as shown in Tigure…

A: To calculate the amount of energy loss (HL)-

Q: Three pipes of different lengths and diameters connected in series discharge 160 liters/s. If the f…

A:

Q: Water entering a pump through an 200mm diameter pipe at 27.6 kPa has a flow rate of 0.1 m^3/s. It…

A:

Q: As shown in the figure below, a Venturi meter is installed on a 300-mm diameter pipe whose maximum…

A:

Q: Oil of specific gravity 0.82 flows through an orifice at the vertical side of a closed cylindrical…

A:

Q: Pipe Length Diameter 1 947mm 250mm 583mm 275mm 3. 1026mm 180mm

A:

Q: plot the relationship between the total energy line and hydraulic gradient line Vs distance from the…

A:

Q: Oil (SG = 0.86) is passing through a horizontal pipe whose diameter increases from 150mm diameter at…

A:

Q: Water from a reservoir flowing through a non rigid 600mm diameter pipe with a velocity of 2.90m/s is…

A:

Q: 200mmø 690mm 300mm 400 mmø LHg (13.6) A 200mm diameter venturi meter is installed in a 400mm…

A:

Q: URGENT Please answer this problem in 30minutes. I need correct answers with complete and step by…

A:

Q: Q1) Water flows from a pressurized tank (in figure below), through a 10.0 cm diameter pipe, exits…

A: Bernoulli's equation has to be used for determining pressure in tank.This equation gives the…

Q: Calculate the discharge through the submerged orifice shown in the figure. Ans: 109 lit/sec 50 kPa…

A:

Q: The mass of the helicopter is 9350 kg. It takes off vertically at time t= 0. The pilot advances the…

A:

Q: Elev. 405.55 Elev. 336.24 20 Inv. 310.24 Inv. 277.05- B 250 575 S00 Question 1 Assuming the conduit…

A: head loss : The amount of head, pressure, or energy lost by water passing through a pipe or channel…

Q: M MEQ2 jpg 200mmø 690mm 300 mm 400 mmø Tit H20 LHg (13.6) A 200mm diameter venturi meter is…

A:

Q: A closed cylindrical tank 3m high and 1m in diameter contains 1.2m of oil (SG = 0.8), 1m of water…

A:

Q: 13. A circular orifice 15-mm diameter is located 0.35 m above the bottom of a rectangular tank 50 cm…

A:

Q: A closed cylindrical tank 2m in diameter and 5m tall has 1.5m of oil (SG = 0.80), 0.5m of an unknown…

A:

Q: 4. Based on the schematic view of the system provided below: a) find the pressure head, hp, that…

A:

Q: A closed cylindrical tank 5m high contains 2.5m of water. A 100mm diameter circular orifice is…

A: To find the air pressure above surface of water

Q: An open cylindrical tank 2m in diameter and 6m tall has 2m of oil (SG = 0.80), 1.2m of an unknown…

A:

Q: A nozzle of inner radius 1.06 mm is connected to a hose of inner radius 9.05 mm. The nozzle shoots…

A:

Q: A closed cylindrical tank 3m high and 1m in diameter contains 1.2m of oil (SG = 0.8), 1m of water…

A:

Q: ... 300 mmg 100 mmø H20, 500mm EHgC(13-6) A 100mm diameter venturi meter is installed in a 300mm…

A:

Q: glecting air resistance, if the maximum height of a vertical jet of water from a nozzle can reach…

A: h=5m To find diameter of nozzle

Q: ater from a reservoir flowing through a non rigid 600mm diameter pipe with a velocity of 2.90m/s is…

A:

Q: W.S (t-O) FIGURE H 1.5 m by 1.5 m T 1.20 m 0.60 m T orifice (1) orifice (2) T 1.

A:

Q: A venturimeter wth a throat diameter of 10 cm is connected to a 20 cm diameter main (0.1V3 carrying…

A: Given  Head loss between inlets and throat = 0.1v²/2g Throat diameter =10cm

Q: A venturi meter with diameter of 300mm is attached to a 600mm main pipe and has its axis inclined…

A:

Q: A cylindrical tank 1m in diameter and 6m high contains 2m of water, 1.50m of oil (specific gravity =…

A:

Q: 11. The velocity through a pipe of diameter 0.5 meters is 7.5 meters/sec. Total head (including…

A: given- dia of pipe d=0.5 mvelocity v=7.5 m/shead difference h=4.5 m

Q: 5- A pump has the following parameters N = 2133.5 RPM, Ns = 40 RPM, D = 37.1 cm and is used to pump…

A: speedN=2133.5 RPMspecific speedNs=40 RPMdiameterD=37.1 cm=0.371mareaA=π4d2A=π40.3712A=0.108…

Q: • Air flows in a pipe which has 5 cm diameter at a velocity of 4 m/s. dynamic viscosity=1.802x 10…

A: Solution:- Option (A) is correct.

Q: TIA the formula. 191 Air (y w0.20 bem ELABORATE 48 in Try to solving these problems: 30 1. Estimate…

A:

Q: An open cylindrical tank 2m in diameter and 6m tall has 2m of oil (SG = 0.80), 1.2m of an unknown…

A:

Length and Length related Variables

Length can de defined as the measurement or extent of physical quantities or objects from one terminal to another terminal. Stone age humans used finger length, step length, and so on to measure the size or displacement of an object. Nowadays, depending on how precise the measurement requires to be and the object’s size is measured, we use measuring devices for measurements like rulers and steel tape. Most people have used a ruler or tape measure to measure a particular distance or the size of an object. For more precise measurements of tiny objects, the development of measurement tools such as the Vernier caliper, which permits us to measure dimensions within 1/1000 of an inch. In the last few decades, electronic distance measuring instruments (EDMI) have been implemented that permit us to measure distances from a few feet to many miles with reasonable accuracy.