A non-ideal solution system at 120°F has the following overall composition as shown in Table 2. Table 2: Composition of system. Component % Mole Propane Butane Calculate: a. ته د ن م م C. Pentane e. Hexane The bubble point pressure. b. Composition of vapor (y) at bubble point pressure. The dew point pressure. d. Composition of liquid (x₁) at dew point pressure. Sketch phase diagram of the system. 50 25 15 10

Q: 1. [Flow equalisation, effect of equalisation on BOD mass loading rate]. Consider the volumetric…

A:

Q: What are (list and explain) some of the relationships between atomic scale and macro scale…

A: Understanding these relationships between atomic scale features and macro scale properties is…

Q: A racemic mixture consisting of component A and B displayed enantiomeric excess of 60% A. How much…

A: The amount of one enantiomer present in the mixture is expressed as enantiomeric excess.

Q: B: Samples collected from industrial wastewater with (500 ml) at nine o'clock, expected to contain…

A: It is given that samples are collected from the industrial wastewater and the following data is…

Q: a. Energy conversion based on hydrocarbon fuel combustion leads to the formation ofpollutants. In…

A: The main categories of pollutants produced by hydrocarbon fuel combustion are carbon monoxide (CO),…

Q: Given the molar property M = ΣΣxixi (1 - Xixz) Ci 1. For a quaternary mixture: (a) Find the partial…

A: Following equation is given , for a quaternary mixture.A molar property is an extensive…

Q: 3, A very fast chemical reaction A + 2B products take place in a thin film near the gas-liquid…

A: A very fast chemical reaction takes place i.e. .Overall film thickness andmolecular diffusivity are

Q: use this equation EI; = mi emmitted MF, burned To get this equation EI₁ = (x₁+Xco) · ( J XMwi MWf

A: Emission Index (EI) is the measure of pollutants emitted per unit of fuel burned.

Q: 1. An actual discharge from a reservoir takes place over a rectangular weir where the flow…

A: The objective of the question is to find the length of the weir and the ratio of actual discharge to…

Q: For an alloy of composition 52 wt% Zn-48 wt% Cu, cite the phases present and their mas fraction…

A: A phase diagram is a sort of chart that depicts the conditions under which thermodynamically…

Q: Four process units are in the plant. The units have FARS of 1, 0.5, 3, and 5, respectively. i) What…

A: Given data:Number of process units: 4The units have FARs of 1, 0.5, 3, and 5.

Q: Milk is pasteurized if it is heated to 63°C for 30 min, but if it is heated to 74°C it only needs 15…

A: The given data:

Q: The saponification reaction between NaOH and ethyl acetate is an irreversible second order reaction.…

A: The saponification reaction is given as:Order of the reactionInitially, ,, andtime taken, .

Q: A heat pump cycle is used to maintain the interior of a building at 15°C. At steady state, the heat…

A:

Q: You wish to separate two proteins, A and B, using precipitation with ammonium sulfate. Protein A has…

A: Two proteins A and B are given and are separated using precipitation with ammonium…

Q: A continuously operating distillation column is fed 40% ethanol and 60% propanol by weight at a…

A: A mixture of ethanol and propane is fed to a continuous distillation column, with the following…

Q: At the macro level, mechanically/physically, what causes materials to fail?

A: To ensure that materials and structures are safe and durable for their intended use, it is crucial…

Q: A sphere of radius Ro is brought into contact with a copious amount of air. Assume that the material…

A: It is given that a sphere with a radius  is brought into contact with a copious amount of air.The…

Q: Explain in detail about hydration and setting times of cement

A: The objective of the question is to understand the concepts of hydration and setting times of…

Q: Q1) A brick 1m high, 3m long, and 0.5m thick leaves an oven, where it has been heated to a uniform…

A: Taking.

Q: A vessel content, one mole of carbon dioxide is heated. The carbon dioxide is dissociated as: CO₂ →…

A: Given Reaction :Initial moles of CO2 = 1 molmole fraction of CO at equilibrium = 0.098

Q: 35 heat transfer area

A:

Q: The following data were obtained in a drying test of a solid food placed in a laboratory tray dryer.…

A: The following data is given from the drying test:initial moisture content(wet basis),bulk…

Q: What is the ideal work for the separation of an equimolar mixture of methan at 448.15 K (175°C) and…

A:

Q: Suppose that a fine metal wire of 1 mm diameter contains 0.005 wt% hydrogen. You wish to remove as…

A: This system can be taken as the lumped model as the thickness is very small.

Q: B/A piston cylinder contains air at 1000 kPa, 800 K with a volume of 0.05 m³. The piston is pressed…

A:

Q: Water at the surface of a column confined to a long narrow capillary tube, closed at the bottom. The…

A: Given data:The total pressure is 1 atm (101.325 kPa) . The concentration is 4.089 *10-5 mole/m³…

Q: 3. A sphere of radius 3 in is initially at a uniform temperature of 70 F. How long after being…

A: It is given that a sphere is immersed in ,the radius of the sphere, ,initial uniform…

Q: F = L+V FZ₁ = Lxi + Vyi Combine to eliminate L V; = - -V/F\x₂ 1 + Z;

A:

Q: Calculate the bubble point temperature and the equilibrium vapour composition for a liquid…

A: Given data :The Antonian Equation is :The values of constant are :

Q: The wet feed solid material to a continuous dryer contains 40 wt% water on a wet basis (see hint),…

A: Amount of water in the feed = 40 wt% Mass flow rate of dried solid product = 800 Kg/h temperature of…

Q: For a cylindrical pressure vessel, its diameter is ? and its height is ?. Suppose it is required to…

A: A cylindrical pressure vessel is a closed-end container having a cylindrical shell. It is used to…

Q: Ammonia is oxidized in a continuous reactor 4NH3 g + 5O2 g --> 4NO g + 6H2O g delta AHr= -904.7KJ…

A: It is given that, ammonia is oxidized in a continuous reactor.The reaction is given as:Enthalpy of…

Q: 3. (a.) Explain how Mg in 6061 aluminum can increase the strength of Aluminum in terms of defect…

A: It is asked that :a) How aluminium's strength is increased by Mg 6061.b) Observable effects on…

Q: 'A 1 mº rigid tank with air at 1 MPa and 400 K is connected to an airline as shown in Fig. The valve…

A:

Q: P23-1A Rogen Corporation manufactures a single product. The standard cost per unit of product is…

A: It is given that a company is manufacturing a single product and the following data has been…

Q: Ex) Air at 0 C and 1 atm flows at a velocity of 6 m/s across a rectangular plate at a uniform…

A:

Q: could you touch further on the last slide, where does the mixing point come from and also tie lines…

A: Since there are three different components, So simple distillation cannot be done to separate themA…

Q: 3-19. Draw the block diagram representing the following transfer functions. In each case, do not do…

A: Block diagrams are made up of a single block or a group of blocks. These are used to graphically…

Q: a) What is the optical depth of the cloud? b) If the cloud would be twice thinner, what intensity…

A:

Q: Propane (C3H8) reacts with 400% theoretical air in a burner in which the reactants and products…

A: It is given that propane reacts with  theoretical air in a burner.TemperaturePressureSince you have…

Q: How about the other parts? Can you summarize the final answers by listing them down at beginning?

A: From the reaction stoichiometry One mole of CaCO3 reacts with one mole of sulfuric acid.Total moles…

Q: At steady state, a new power cycle is claimed by its inventor to develop net power at a rate of (a)…

A: Temperature of hot reservoir = 2000oRTemperature of cold reservoir = 500oRHeat addition rate = 300…

Q: A 10 kg of water in a piston/cylinder arrangement exists as saturated liquid/vapor at 100 kPa, with…

A:

Q: Classify the types of admixtures and write a short note on them .

A: The objective of this question is to classify the types of admixtures used in concrete and provide a…

Q: Acetaldehyde is produced from the input components CH4 and CO according to the following CH4(g)…

A:

Q: Q2// Calculate change in standard enthalpy of formation AH (Fe203) and Standard Enthalpy of…

A: The given reaction is:The reverse reaction is :When the reaction is reversed, the sign of enthalpy…

Q: EXAMPLE 10-2 An Actual Steam Power Cycle A steam power plant operates on the cycle shown in Fig.…

A: Now we see at point 1:Now at the point 3:

Q: Q4: The two-tank mixing process shown in Fig. (4) contains a recirculation loop that transfers…

A:

Q: 17. Some nuclear power plants, which are facing space limitation in their spent fuel pool, place…

A: The following is given,Total loss coefficient associated with the flow through the HSMFlow areaTotal…