A mass is oscillating horizontally on a spring. At the locations A, B, C, D, and E, photogates are used to measure the speed of the mass as it moves by. The speed is used to calculate the kinetic energy (KE) and the location of the photogates is used to calculate the elastic potential energy (PEelastic). Interpret the chart to determine the missing KE and PEglastic Values. Assume all values are exact. A PE = 80 J BKE = 40 J С EpE DE BPE = ? A CKE = 80 J C DPE = 20 J DKE = ? EPE = 80 J What is the elastic potential energy PEelastic at position B? PEclastic J What is the kinetic energy KE at position D? KE = J E.

A mass is oscillating horizontally on a spring. At the locations A, B, C, D, and E, photogates are used to measure the speed of the mass as it moves by. The speed is used to calculate the kinetic energy (KE) and the location of the photogates is used to calculate the elastic potential energy (PEelastic). Interpret the chart to determine the missing KE and PEglastic Values. Assume all values are exact. A PE = 80 J BKE = 40 J С EpE DE BPE = ? A CKE = 80 J C DPE = 20 J DKE = ? EPE = 80 J What is the elastic potential energy PEelastic at position B? PEclastic J What is the kinetic energy KE at position D? KE = J E.

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter5: Energy

Section: Chapter Questions

Problem 11CQ: A weight is connected to a spring that is suspended vertically from the ceiling. If the weight is...

See similar textbooks

Similar questions

Consider the data for a block of mass m = 0.250 kg given in Table P16.59. Friction is negligible. a. What is the mechanical energy of the blockspring system? b. Write expressions for the kinetic and potential energies as functions of time. c. Plot the kinetic energy, potential energy, and mechanical energy as functions of time on the same set of axes. Problems 5965 are grouped. 59. G Table P16.59 gives the position of a block connected to a horizontal spring at several times. Sketch a motion diagram for the block. Table P16.59
A block of mass 300 g is attached to a spring of spring constant 100 N/m. The other end of the spring is attached to a support while the block rests on a smooth horizontal table and can slide freely without any friction. The block is pushed horizontally till the spring compresses by 12 cm, and then the block is released from rest. (a) How much potential energy was stored in the block-spring support system when the block was just released? (b) Determine the speed of the block when it crosses the point when the spring is neither compressed nor stretched. (c) Determine the speed of the block when it has traveled a distance of 20 cm from where it was released.
A certain uniform spring has spring constant k. Now the spring is cut in half. What is the relationship between k and the spring constant k' of each resulting smaller sprig? Explain your reasoning.
In the short story The Pit and the Pendulum by 19th-century American horror writer Edgar Allen Poe, a man is tied to a table directly below a swinging pendulum that is slowly lowered toward him. The bob of the pendulum is a 1-ft steel scythe connected to a 30-ft brass rod. When the man first sees the pendulum, the pivot is roughly 1 ft above the scythe so that a 29-ft length of the brass rod oscillates above the pivot (Fig. P16.39A). The man escapes when the pivot is near the end of the brass rod (Fig. P16.39B). a. Model the pendulum as a particle of mass ms 5 2 kg attached to a rod of mass mr 5 160 kg. Find the pendulums center of mass and rotational inertia around an axis through its center of mass. (Check your answers by finding the center of mass and rotational inertia of just the brass rod.) b. What is the initial period of the pendulum? c. The man saves himself by smearing food on his ropes so that rats chew through them. He does so when he has no more than 12 cycles before the pendulum will make contact with him. How much time does it take the rats to chew through the ropes? FIGURE P16.39
A block of mass m = 0.250 kg is pressed against a spring resting on the bottom of a plane inclined an angle = 45.0 to the horizontal. The spring, which has a force constant of 955 N/m, is compressed a distance of 8.00 cm, and the block is released from rest. Consider the total energy of the springblockEarth system. a. What is the total distance the block moves from its initial position if the incline is frictionless? b. What is the total distance the block moves from its initial position if the coefficient of kinetic friction between the incline and the block is 0.330?
Consider a particle moving in the region x > 0 under the influence of the potential where U0 = 1 J and α = 2 m. Plot the potential, find the equilibrium points, and determine whether they are maxima or minima.
A bungee cord is essentially a very long rubber band that can stretch up to four times its unstretched length. However, its spring constant vanes over its stretch [see Menz, P.G. “The Physics of Bungee Jumping.” The Physics Teacher (November 1993) 31: 483-487]. Take the length of the cord to be along the direction and define the stretch as the length of the cord minus its un-stretched length that is, (see below). Suppose a particular bungee cord has a spring constant, for of and for. (Recall that the of (Recall that the spring constant is the slope of the force versus its stretch (a) What is the tension in the cord when the stretch is 16.7 m (the maximum desired for a given jump)? (b) How much work must be done against the elastic force of the bungee cord to stretch It 16.7 m? Figure 7.16 (credit modification of work by Graeme Churchard)
A spring of spring constant k lies along an incline as shown in Figure P8.27. A block of mass m is attached to the spring. The spring compresses, and the block comes to rest as shown. Find an expression for the change in the Earthblockspring systems potential energy in terms of the parameters given in the figure.
A mass is oscillating horizontally on a spring. At the locations A, B, C, D, and E, photogates are used to measure the speed of the mass as it moves by. The speed is used to calculate the kinetic energy (KE) and the location of the photogates is used to calculate the elastic potential energy (PEelastic). Interpret the chart to determine the missing KE and PEelastic Values. Assume all values are exact. APE = 40 J ВКЕ 3 20 J EpE B KE BPE = ? D CKE = 40 J A B C E DPE = 10J DKE = ? %3D EPE = 40 J What is the elastic potential energy PEclastic at position B? PEelastic = J What is the kinetic energy KE at position D? KE = J
A block of mass mm is attached to the end of a spring (spring stiffness constant k), (Figure 1). The mass is given an initial displacement x0 from equilibrium, and an initial speed v0. A) Ignoring friction and the mass of the spring, use energy methods to find its maximum speed in terms of the given quantities. B) Find its maximum stretch from equilibrium in terms of the given quantities.
A pen contains a spring with a spring constant of 261 N/m. When the tip of the pen is in its retracted position, the spring is compressed 4.6 mm from its unstrained length. In order to push the tip out and lock it into its writing position, the spring must be compressed an additional 6.7 mm. How much work is done by the spring force to ready the pen for writing? Be sure to include the proper algebraic sign with your answer.
In the figure below, the 2 kg block is released when espring has its equilibrium length. The spring constant is k = 100. If the inclined surface is frictionless, determine he m maximum elongation of the spring. 30° mH