A liquid of specific gravity of 1.75 flows in a 6 cm horizontal pipe. The total energy at certain point in the flow is 80 J/N (joules/newton). The elevation of the pipe above the fixed datum is 2.6 m. If the pressure is 75 kPa. Determine the power available at the specified point in kW.   A. 148.91 B. 144.22 C. 142.25 D. 146.96  With F.B.D

Q: The throat diameter of a perfect venturi meter is 1.79 inches and is placed horizontally in a pipe…

A:

Q: An orifice meter with orifice  area 969 mm2 is inserted in a pipe of area 1938 mm2  The pressure…

A: Given data: The orifice area is ao=969 mm2=9.69×10-4 m2 The pipe area is ap=1938 mm2=19.38×10-4 m2…

Q: The water level in a tank is 34 ft above the ground. A hose is connected to the bottom of the tank…

A: Govind

Q: Determine the pressure difference between pipe A and B for arrangement shown in Fig. P. 1.13.20.

A: It is needed to determine the pressure difference between the two pipes.

Q: Q1. Two water jets of equal size strike each other as shown in the figure below. What is the speed,…

A:

Q: Find the pressure of a liquid in pipe of specific gravity 0.8 as shown in Fig. P.1.13.12. (Specific…

A: As shown in the question, we must calculate the pressure of a liquid in a pipe with a specific…

Q: A venturi meter has air flowing through it. The diameter at the entrance is 2.1 in and at the throat…

A:

Q: Using the volume graph detemine the aproximate Vt 1. 250 ml 2. 500 ml 3. 750 ml 4. 1000 ml cm H₂O ml…

A: Given:The graphs are given below;

Q: A trough is 6 feet long and 11 foot high. The vertical cross-section of the trough parallel to an…

A: Given trough is 6 feet long and 11 foot high.Assume vertical section of through is represented by…

Q: A tank is filled with water at a rate of 9 gal/min as shown in the figure below. Given that D = 3 ft…

A: Given A tank is filled with water at a rate of 9 gal/min as shown in the figure below. Given that D…

Q: The pressure at the suction of the pump reads 6 psi vacuum, while at the discharge is 35 psi. The…

A:

Q: A liquid of specific gravity of 1.75 flows in a 6 cm horizontal pipe. The total energy at a certain…

A:

Q: Carbon dioxide flows steadily at 1 kg/s through a device where the pressure, specific volume, and…

A: Given   Mass flow rate, m = 1 kg/s            Pressure, P1 = 200 kPa            Volume, V1 = 0.5…

Q: A fluid with specific weight 32 -flows through the pipe below as it narrows from a diameter of 4.8…

A:

Q: QI: In a venturemeter used for measuring the flow of oil (S = 0.85) through a horizontal pipeline,…

A: Given data:-specific gravity of flowing fluid, sl=0.85specific garvity of manometric fluid,…

Q: In a hydraulic system The volume of oil displaced by a cylindrical effort piston with 20 cm diameter…

A: We have to find the stroke length of this piston cylinder .

Q: A droplet with an inner pressure that is 0.075 psi higher than the air has a diameter of 0.03…

A:

Q: 3. Two water tanks are connected to each other through a mercury manometer with inclined tubes, as…

A: The given information in the problem is represented in the following attached image:

Q: A liquid of specific gravity of 1.75 flows in a 6 cm horizontal pipe. The total energy at certain…

A: E=80m Z=2.6m P=75kPa D=6cm

Q: A 22 L kerosene tank is filled with 2 cm diameter hose equipped with a 1.5 cm nozzle meter If it…

A:

Q: The pressure at the suction of the pump reads 6 psi vacuum, while at the discharge is 35 psi. The…

A:

Q: střéss is proporti of shear stress is p r stress is proport

A: A Newtonian fluid is one in which the viscous stresses generated by its flow are linearly…

Q: A square box with a length of 1.30 m contains water at room temperature. The box has two pipe…

A:

Q: A venturi meter has air flowing through it. The diameter at the entrance is 2.9 in and at the throat…

A:

Q: 30°. 3. A container filled with water accelerates at 20 ft/s? up a plane inclined by a = pressure at…

A:

Q: Q1: The flow of water from a reservoir is controlled by an L-shaped gate hinged at point A, as shown…

A:

Q: A mercury manometer is used to measure the pressure difference between pipes A and B. Oil (specific…

A:

Q: The throat diameter of a perfect venturi meter is 1.59 inches and is placed horizontally in a pipe…

A:

Q: Water flows downward in a pipe at 45° as shown in Fig. (3). The mercury manometer reads a 6-in…

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.