A laboratory provides the following analysis obtained for a wastewater sam Total Solids = 200 mg/L %3! Total Suspended Solids 160 mg/L %3D Fixed Suspended Solids = 30 mg/L Volatile Suspended Solids = 120 mg/L What is the concentration of the Total Dissolved Solids of this sample?

Enter T next to the following true statements and F next to the false statements. Settling of suspended solids in secondary clarifiers is typical of Type II sedimentation. Thickening prior to digestion is common in many wastewater treatment plants because it reduces the size needed for the digester. Based on a temperature of 30°C, a design mean cell residenee time of about 20 days would be reasonable for a completely-mixed anaerobic digester without recycle. A volatile suspended solid is defined as an organic solid that can be oxidized to CO2 (g) at 250°C. The theoretical yield coefficient can be estimated from the observed yield coefficient if the specific growth rate constant is known. Air flotation would likely be more efficient for thickening waste activated sludge than primary sludge, while the opposite would be true for gravity thickening. The net mass of cells produced in the activated sludge process equals the total cell mass synthesized minus the cell mass wasted as waste…

The following data on the substrate removal rate and the substrate concentration is available for wastewater treatment (S) mol Rate, r (mol/min) 0.04 0.57 0.06 1.05 0.8 2.32 0.10 3.00 0.12 4.68 0.14 5.42 2.0 5.78 Estimate the value of substrate removal constant Km and the value of Vmax

From water sample, 25 mg/L HCO3" as CacO3, 10 mg/L C032 as Caco3 and 50 mg/L Ca* as CaCO3 were measured. pH was near neutral. What is alkalinity? () mg/L as Cac03 (*Answer in whole number only)