A jet of water is ejected out of the tip of a nozzle (50mm in diameter) and exposed to the atmosphere with negligible pressure. If it is released at an angle of 60 degrees from the horizontal at an initial velocity of 10 m/s, then: Compute for the area of flow of the jet of water at its summit. cannot be determined None of the choices 0.00393 sq.m. 0.07071 sq.m. 3.93 sq.m. O

A jet of water is ejected out of the tip of a nozzle (50mm in diameter) and exposed to the atmosphere with negligible pressure. If it is released at an angle of 60 degrees from the horizontal at an initial velocity of 10 m/s, then: Compute for the area of flow of the jet of water at its summit. cannot be determined None of the choices 0.00393 sq.m. 0.07071 sq.m. 3.93 sq.m. O

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

1. A reservoir has a sidewall, inclined backwards 30° from the vertical in which is an orifice having a velocity coefficient of 0.97 with a head of 3m on the orifice, compute the velocity of the jet as it strikes the ground a distance 2m below the orifice. 3m h \30° 2m \B -X-
A sharp edge orifice 105-mm diameter, in the side of a tank having a horizontal cross section 2m square, discharges water under a constant head. The rate of inflovw over which the head was kept constant is suddenly changed from 25 lit/set to 35 lit/sec. How long will it take, after this change aECUrs, for the head to become 2 meters? The coefficient of discharge may be considered constant and equal to 0.6 O 25.0 min O 18.7 min O 14.3 min O 105 min
A nozzle discharges 155lit/sec with a velocity of 35m/s. The entire jet strikes a vane moving in the same direction as the jet with a velocity of 20m/s. Compute the Force exerted on the vane.
7.12 The globe valve in the pipeline shown is opened instantaneously. If the loss coefficient for the wide-open valve is 3.0, how many seconds are required for the velocity to reach 99% of its final value? Neglect the entrance loss. El. 1000' El. 980' - 2000'12" f = 0.018 XIO El. 970' Valve
hm 25mm diameter 2m 75mm diameter 1 water 200mm 600mm Mercury (SG = 13.6) The head lost from point 1 to point 2 is 4m. If the specific gravity of mercury is 13.6, determine the following: a) The velocity at point 1 is Blank 1 m/s. b) The maximum height the water can reach "hm" if neglecting air friction is Blank 2 m
Vertical Q6) The flow-metering device shown consists of a stagnation probe at station 2 and a static pressure tap at station 1. The velocity at station 2 is 2 times that at station 1. Air with a density of 1.2 kg/m flows through the duct. A water manometer is connected between the stagnation probe and the pressure tap, and a deflection of Ah = 5 cm is measured. What is the velocity at station 2? Water
Vertical Q6) The flow-metering device shown consists of a stagnation probe at station 2 and a static pressure tap at station 1. The velocity at station 2 is 2 times that at station 1. Air with a density of 1.2 kg/m3 flows through the duct. A water manometer is connected between the stagnation probe and the pressure tap, and a deflection of Ah = 5 cm is measured. What is the velocity at station 2? Water
hm 25mm diameter 75mm 2m diameter water 200mm 600mm Mercury (SG 13.6) The head lost from point 1 to point 2 is 4m. If the specific gravity of mercury is 13.6, determine the following: a) The velocity at point 1 is 2.30 m/s. b) The maximum height the water can reach "hm" if neglecting air friction is 21.87 m
A closed cylindrical tank 1.89m high and 0.99m in diameter contains water of height 1.35m. When the angular velocity is constant at 2Orad/sec, 0.07 V What is the area (m^2) uncovered at the bottom? [ Select ] If it is rotated at 15rad/sec and the air has a pressure of 200kPa what is the minimum pressure at the bottom of the tank in KPa?
2. A nozzle inclined at an angle of 60 degrees with the horizontal issues a 50mm diameter water jet at the rate of 10 m/s neglecting air resistance what is the area of the jet at the highest point of the projectile |Highest point v,0 v = v. e=60° Vo = 10 m/s
A sharp edge orifice 105-mm diameter, in the side of a tank having a horizontal cross-section 2m square, discharges water under a constant head. The rate of inflow over which the head was kept constant is suddenly changed from 25 lit/sec to 35 lit/sec. How long will it take, after this change occurs, for the head to become 2 meters? The coefficient of discharge may be considered constant and equal to 0.6 25.0 min O 18.7 min 14.3 min 10.5 min
The height of water above the 5 mm diameter orifice stands 180 mm. What is the theoretical velocity in the orifice? Select one: O a. 2.40 m/s O b. 0.65 m/s O c. 3.53 m/s O d. 1.88 m/s