a)What are the typical permeability values for clay and sand, respectively? Discuss howthe pore pressure in these soils would respond to loading, make use of schematicdrawings when needed.b)A sample of silty clay is compacted into a mould 150 mm in diameter and 120 mm high.The mass of soil is 3.527 kg which reduces to 2.594 kg after drying in an oven. Calculatethe bulk unit weight of the soil sample. Assuming the specific gravity of the soil grains,Gs = 2.72, calculate the degree of saturation and voids ratio of the soll.c)A site investigation is carried out in Northampton Square for a proposed five storeybuilding. The ground is found to comprise 2 m of coarse gravel overlying London Clay.The gravel has a Gs = 2.65 and a specific volume of 1.573. The clay has a bulk unit weight= 17.9 kN/m³ and a coefficient of earth pressure, Ko= 1.1. The water table is at a depthof 2 m below the ground surface (i.e. level with the top of the London Clay strata).Calculate the vertical effective stress and horizontal total stress at 4 m depth.d)Subsequently the proposed building is constructed including a 2 m deep basement.Assuming that the total vertical stress exerted by the structure on the ground is50 kN/m², calculate the vertical effective and horizontal total stress at 4 m depth afterconstruction is finished.

The permeability or coefficient of permeability can be defined as the rate of flow of water through…

Answered: a) What are the typical permeability…

a) What are the typical permeability values for clay and sand, respectively? Discuss how the pore pressure in these soils would respond to loading, make use of schematic drawings when needed.

Principles of Foundation Engineering (MindTap Course List)

9th Edition

ISBN:9781337705028

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter2: Geotechnical Properties Of Soil

Section: Chapter Questions

Problem 2.13P

See similar textbooks

Similar questions

The total density of sand in an embankment was found to be 1900kg/m^3 and the field water content was 12% . In the laboratory, the density of the solid was found to be 2660 kg.m^3, and the maximum and minimum voids ratio were 0.63 and 0.44, respectively What is the void ratio of the sand? Calculate the relative density of the sand in the field:
PLS. ANSWER ASAP WITH COMPLETE SOLUTION4 DECIMAL PLACES A saturated sample of clay with a shrinkage limit of 22 has a natural water content of 35%.a. What would its dry volume be as a percentage of its original volume if the specific gravity of soil solids is 2.70?b. What would be the void ratio of the soil in its natural water content?c. What is the dry density of the soil sample?
Geotechnical Engineering Please help me answer this question, and please show your solutions write it properly. Problem 3 A soil sample with a grain specific gravity of 2.67 was filled in a 1000mL container in the loosest possible state and the dry unit weight of the sample was found to be 14.75 N. It was then filled at the densest obtainable state and the weight was found to be 17.70 N. The void ratio of the soil in the natural state was 0.63. Determine the relative density in the natural state.
Sand at a borrow pit is determined to have an in-place dry unit weight of 115 pcf. Laboratory tests performed to determine the maximum and minimum unit weights give values of 122 pcf and 102 pcf, respectively. From these data, what is the relative density of the natural soil?
A sample of soil compacted according to the standard Proct or test has a density of 2.06 g/cm³ at 100% compaction and at an optimum water content of 14%. What is the dry unit weight? What is the dry unit weight at zero air-voids? If the voids become filled with water what would be the saturated unit weight? Assume Gs = 2.67 Air Water Solids Ma + - + M st
A liquid limit test on a clay was performed with the following results. The natural water content of the clay is 38% and plastic limit is 21%. Number of Blows 6 12 20 28 32 Water content (%) 52.5 47.1 42.3 38.6 37.5 What is the liquidity index of this clay? (Use Interpolation) Group of answer choices 0.895 0.96 1.08 0.90 Please answer this asap. For upvote. Thanks
SIZE (mm) PERCENT FINER 2.0 90.1 0.073 53.96 0.053 41.9 0.0045 25.16 0.0017 10.1 A sample of residual soil developed on shaly sandstone has the following grain-size characteristics. USING USDA, DETERMINE THE FOLLOWING AND SHOW COMPLETE SOLUTION. PLOT THE GRAPH. (ALL FINAL ANSWER IS IN 3 DECIMAL PLACES) 1. Determine the modified percentage of sand. 2. Determine the modified percentage of silt. 3. Determine the modified percentage of clay. 4. Determine the classification of soil.
Give its consistency index. EXERCICE 3 Classify the following soil using the Unified Soil Classification (ASTM standard). Percentage passing N° 4 seive = 98 Percentage passing N° 10 seive = 86 Percentage passing N° 40 seive = 80 Percentage passing N° 200 seive = 71 The liquid limit = 102% The Plasticity index = 68% The water content is = 72%Give its consistency index. Indicate the activity of this soil and numerous some potential problems linked to its use in different geotechnical works. EXERCICE 4 Some tests were performed on the sandy silt according to Standard Proctor test. The volume of the mold is 944 cm. The specific gravity was measured as 2.67 1) Plot the Proctor compaction curve (see the page 2) 2) Find: 2-1 The maximum dry unit weight of sandy-silt fill, 2-2 Its OMC, 2-3 The moisture ranges for 85% of Standard Proctor Optimum, 2-4 The degree of saturation at the optimum Proctor state. 3) Plot the zero air voids curve (see the page 2) 4) Determine the values of degree of…
A sample of fully saturated clay weighs 2.98 pounds in its natural state and 2.15 poundsafter drying. Determine the following:a. Natural water contentb. Void ratioc. Porosityd. Moist densitye. Dry density (Hand written please)
a. Write down the four Factors that effects the Behavior of Soil. b. A soil specimen with volume of 0.60x10-4 m3 , weighs 0.105 kg. Its dry weight is 0.0802 kg, and Gs is 2.65. Compute • Water content m, % • Void ratio e and porosity n • Degree of saturation Sr, % Kindly answer this question as soon as possible.
A saturated clay 120cu.cm clay sample has a natural water content of 35%. The shrinkage limit was determined when the water content reaches 20%. Given the specific gravity of soil is 2.6. Calculate the shrinkage ratio.
1. A sample of saturated clay was placed in a container and weighed. The weight was 6 N. The clay withcontainer was oven dried for 24 hours at 105C and weighed again as 5N. if the weight of the containeris 1 N, and specific gravity of soil solids is 2.70, determine the a) water content b) void ratio c) bulk unitweight d) dry unit weight, e) saturated unit weight f) submerged unit weight. This is the question of Soil Mechanics.