Answered: A hydro station of 3 MW generate 358…

A hydro station of 3 MW generate 358 Mwh for one week. If the water discharge at one week is 542000 cubic meter. The overal effieciency of the station is 0.7. The head of the water in the dan is *

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.50P: Consider the balanced three-phase system shown in Figure 2.34. Deter mine v1(t) and i2(t). Assume...

See similar textbooks

Related questions

Q: Complete the sentence The power factor must be close to will be reduced To insure that losses in the…

A: Power factor is the ratio of Real power(kW) to apparent power(kVA). It can also be defined as the…

Q: The maximum demand of a power station is 110 MW. It generates 105 x 10 units during the day. The…

Q: A transmission line has an actual impedance of 18 ohms, compute for the per unit impedance of this…

Q: Example 4.5. A generating station has an installed capacity of 50,000 kW and delivers 220 × 10 units…

Q: A hydro-electric station has to operate with a mean head of 250 m and is supplied from a reservoir…

A: Given that H= 250 m A= 120 Km2 available rain off =50 % Annual rain fall = 100 cm =1 m capacity…

Q: q3-Assume the following status for worldwide total and wind electric generation as of the year 2000…

Q: A Hydroelectric Plant has a Turbine and Generator with an efficiency of 63%. If the dam has a Head…

A: To find the power generated in the hydroelectric power plant First convert all data in SI Unit

Q: Q1. High load factor indicates Ocost of generation per unit power is increased O total plant…

A: Here question is high load factor indicates what

Q: A high-voltage transmission line with a resistance of .39ohms/km carries a current of 1030A. The…

A: The performance of a power system depends mainly on the performance of transmission lines in the…

Q: 4. On the basis of annual operation, the use factor and capacity factor of a central plant are 0.7…

A: Given:-Use Factor=0.7Capacity factor=0.3

Q: The total installed electric generating capacity of Pakistan is about 38719 MW. Find the installed…

A: The total installed capacity of the public sector power plants in the country was 19621 MW while the…

Q: A typical SME food factory 37 kW capacity and for continuous use and 27 kW for food processing…

A: We need to calculate plant factor , by given data we will find out plant factor.

Q: If the values of real power and reactive power is specified for a bus, then it is called as PV bus.…

A: If values of real power P and reactive power Q is specified for a bus then it is called PQ bus (load…

Q: A generating station has a connected load of 43,000 kW and a maximum demand of 20,000 kW, the units…

Q: A hydro-electric generating station is supplied from a reservoir of capacity 6000000 m at head of…

Q: 17. What is the share of renewable energies on the total electrical energy generated for 2019/2020?…

A: Introduction:. Electricity is produced using all sources of renewable energy. Geothermal steam is…

Q: Determine the complex power absorbed by the voltage source

A: In this question, Determine the complex power absorbed by the voltage source? Complex power S= VI*…

Q: A hydro-electric station has an average available head of 100 metres and reservoir capacity of 50…

A: Given values are =

Q: Example 10. A run-of-river hydro-electric plant with pondage has the following data : Installed…

Q: generation station of 1MW supplied

Q: Renewable and non-renewable for poor area which is best please explain step by step

A: Types of renewable energy resources Solar energy Wind energy Tidal energy Geothermal energy…

Q: Calculate (i) the number of units supplied annually (ii) the diversity factor and (iii) the demand…

A: Given, A generating station has the following loads : 15000 KW ,12000 KW, 8500 KW, 6000 KW and 450…

Q: The

Q: on of the Tariff characteristics is to be fair by charging the big consumer a high rate than the…

A: The first question is subjective and hence out of scope. The solution for rest two questions is as…

Q: load of the persons and infiltration in the room are 5100 W and 3400 W respectively; the air is 1250…

Q: A generating station has a maximum demand of 10 MW. Calculate the cost per unit generated from the…

Q: A power station has a daily load cycle as under; 260MW for 6 hours; 200MW for 8 hours; 160MW for 4…

A: The load factor (LF) of a power station is the ratio of average load (AL) on power station to…

Q: Which component represents Y axis of load duration curve ? a Time of a day b. Peak Demand C Power…

A: Choose the correct option Which component represents Y axis of load duration curve?

Q: Calculate the average power transferred by the source in the circuit given below

A: According to question: The circuit is redrawn as The values of impedance Z1, Z2, Z3, and Z4 at…

Q: Calculate the cost of generation per KWh for a power station having the following data Installed…

A: It is given that: Installed capacity of the plant=200 MWCapital cost=Rs. 400 croresRate of interest…

Q: 6. An industrial load can be supplied from the following alternative tariffs : (i) High voltage…

Q: What is the Total Actual Energy Generated by Davao Power Plant if there are (4) substation with 1.12…

Q: (1) daily load factor (2) plant capacity factor (3) utilization factor and

A: Given: The maximum demand of a power station is 110 MW. It generates 105 x 10 units during the day.…

Q: . A power plant has the following given data: load factor of 0.48; installed capacity 35 MW; reserve…

A: In this question we need to find the plant use factor.

Q: g period. Peak demand is typically measured at 400 kW during the day and 200 kW at night. However,…

A: Service charge for 3 phase is P518. Energy Charge , Total Energy consumed = 126000kWh total energy…

Q: A.) A coal-powered station has a maximum demand of 30 MW, a load factor of 60%, plant capacity…

A: Given data: Load factor = 60%=0.6 Maximum load= 30 MW

Q: A generating station has a maximum demand of 10 MW. Calculate the cost per unit generated from the…

A: The cost per unit can be calculated as follows.

Q: Complete the table giving your answers to two decimal places. Reactive Specific Power Power…

A: Milk shed: Given details are P1=6200W.pf=0.75 lagging. The reactive power is calculated as…

Q: A single-phase consumer who lives in San Francisco has an annual average monthly consumption of 430…

A: Given data: Power consumption per month: 43. kWh Full sunlight available per day: 3.96 hours Solar…

Q: A hydro-electric plant has a catchment are of 120 square km. The available run off is 50% with…

Q: The percent values of the voltage, current, impedance, and volt-amperes for a given power system are…

Q: A run-of-river hydro-electric plant with pondage has the following data : Installed capacity = 10 MW…

Q: Q3: Calculate the average power in kW that can be generated in a hydro- electric project from the…

A: In this question ,we have to find average power in KW that can be generated in a hydro electric…

Q: what is the power loss in the line in megawatt (MW)?

Q: By Nodal Analysis, determine the voltage V₂ of the circuit 252 jsn v m 8410A (1 Lin 452 jiori 2014…

Q: Can we connect a 10A load to domestic socket outlet? Justify your answer

A: According to question we have to justify the given condition.

Q: A generating station has a maximum demand of 10 MW. Calculate the cost per unit generated from the…

A: The solution can be achieved as follows.

Q: 1. To demonstrate the theoretical method of transforming delta networks to wye network, or…

A: As per our guidelines, we are supposed to answer only one question. Kindly repost other questions as…

Q: dwelling units, the lighting load demand factor for the computed load above 120,000 VA is

A: The solution is given below .

Concept explainers

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.

Question

A hydro station of 3 MW generate 358 Mwh for one week. If the water discharge at one week is 542000 cubic meter. The overal effieciency of the station is 0.7. The head of the water in the dan is *

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For the first question, is the statement true or false: "The load is not absorbing nor generating reactive power"For the second question, is the statement true or false: "The load is absorbing 8.93kVA"
b) Wind farm consist of ten wind turbines with nominal capacity of 2MWper turbine, has a total of 20 MW for farm as a whole, in year 2020, the farm produced a total energy 43416MWH, find a capacity factor.
TM Thermal Visayas Incorporated Power Plant generates actual load of energy for 1.352 MW supplying (2) two town substation both has a capacity factor of each substation 85.75 & 87.91 Twin pipe B 80.5 and 79.21% C) 72.30 and 75.51% D) 75.5 and and 72.41%
Electric power is to be generated in a hydroelectric power plant that receives water at a rate of 70 m3/s from an elevation of 65 m using a turbine–generator, the electric power output of this plant is? a. 38.2 MW b. 53.5 MW c. 44.6 MW d. 3.9 MW
A generating station has a daily output of 280 MWh and uses 500 tonnes of coal in process. The coal releases 7 Mj/kg when burn. Calculate the overall efficiency of the station
7. A power station has to meet the following load demand: Load A 50 kW between 10 A.M. and6 P.M. Load B 30 kW between 6 P.M. and 10 P.M. Load C 20 kW between 4 P.M. and 10 A.M. Plot the daily load curve and determine (i) diversity factor (ii) units generated per day (iii) load factor. () 1-43 (ii) 880 kWh (iii) 52-38%]
Complete the sentence The power factor must be close to will be reduced To insure that losses in the transmission lines
Q2/ Find Yous for the power system all reactance on a common base. Bus 3 j0.25 j0.10 j0.25 Bus 2 j0.125 Bus 1 j0.40 j0.20 j0.10 Bus 4
A rice mill will be served by two units of 50 KVA transformers, 7.620 KV/240V. The transformers will be installed as open delta bank to serve the three phase load of the rice mill. What is the maximum KVA load that this bank can carry without overloading? A. 75.5 B. 86.6 C. 50 D. 100 Please send me solution in handwritten form. Thank you very much.
A SUBSTATION RATED 1250 KVA IS OPERATING AT FULL LOAD AT 0.8 PF LAGGING AND TO CARRY AN ADDITIONAL LOAD OF 170 KW AT 0.85 PF LAGGING. WITH THE MENTIONED POWER FACTOR, THE SUBSTATION IS EXPERIENCING AN INEFFICIENT ELECTRICAL SYSTEM: HIGH POWER LOSSES, HIGH VOLTAGE DROPS IN THE ELECTRICAL EQUIPMENT, AND HIGH ELECTRICITY BILLS. TO REDUCE POWER LOSSES AND TO REDUCE THE ELECTRICITY BILL, POWER FACTOR CORRECTION IS TO BE OF HIGH IMPORTANCE AND CONSIDERATION. Make a total power triangle (phasor diagram) for Alternate A additional substation capacity in KVA and Alternate B shunt capacitor in KVA
A SUBSTATION RATED 1250 KVA IS OPERATING AT FULL LOAD AT 0.8 PF LAGGING AND TO CARRY AN ADDITIONAL LOAD OF 170 KW AT 0.85 PF LAGGING. WITH THE MENTIONED POWER FACTOR, THE SUBSTATION IS EXPERIENCING AN INEFFICIENT ELECTRICAL SYSTEM: HIGH POWER LOSSES, HIGH VOLTAGE DROPS IN THE ELECTRICAL EQUIPMENT, AND HIGH ELECTRICITY BILLS. TO REDUCE POWER LOSSES AND TO REDUCE THE ELECTRICITY BILL, POWER FACTOR CORRECTION IS TO BE OF HIGH IMPORTANCE AND CONSIDERATION. ANSWER: CITE A STEP BY STEP SUMMARY OF HOW TO DETERMINE THE POWER FACTOR CORRECTION REQUIRED IN THE GIVEN PROBLEM TO ARRIVE AT THE ALTERNATIVE THAT SHALL BE SYSTEMATICALLY CARRIED OUT TO GUARANTEE A SUCCESSFUL DECISION IMPLEMENTATION,
Short term and long term effects of wind energy on power system