A high altitude chamber chamber , the volume of which is 30m3 , is put into operation by reducing the pressure from 1.013 bar to 0.35 bar and temperature from 27 0C to 5 0C . How many kg of air must be removed from the chamber during the process ? Express this mass as a volume measured at 1.013 bar and 27 0C Take R=287 J/kg K for air

A high altitude chamber chamber , the volume of which is 30m3 , is put into operation by reducing the pressure from 1.013 bar to 0.35 bar and temperature from 27 0C to 5 0C . How many kg of air must be removed from the chamber during the process ? Express this mass as a volume measured at 1.013 bar and 27 0C Take R=287 J/kg K for air

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter1: Heat, Temperature, And Pressure

Section: Chapter Questions

Problem 6RQ: One British thermal unit will raise the temperature of _____ 1b of water _____F.

See similar textbooks

Similar questions

One kilogram of air is compressed from a volume of 1.0 m and a pressure of 100 kPa to a volume of 0.147 m and a pressure of 1000 kPa. Assuming that the compression follows the law pu" the work done during the compression process. = constant, find
40 m3 of air (R=0.287), at a gage pressure of 20kPa, and a temperature of 27 °C. then the specific volume of the air is: Select one: O a. 0.72 m3/kg Ob.0.72 cm3/kg Oc. 0.73 m3/kg Od. 0.73 cm3/kg
One kg. of gas is confined to a constant volume tank. Initial pressure and volume are 4 0.21m3 respectively. When a heat energy of 82 kJ is supplied to the system, the final temperature of the gas becomes 127 degrees C. Find (a) Work done. (b) Change in internal energy. (c) Specific heat at constant volume. Assume, R=300 Nm/kgK.
the specific heat capacity of the system during a certain process is given by Cn(0.4+0.004T) kJ/kg deg. celcius. if the mass of the gas is 6kg and its temperature changes from 25 def. celcius to 125 def. celcius find the mean specific heat of the gas
H.W: - 0.8m of gas at 8bar and 27°C is compressed isothermally until its volume is ¼ time the original volume, then its heated at constant pressure to original volume, finally its cooled at constant volume to original condition. Find: - a- the heat transferred. b- Work done c- Change in internal energy. (draw the processes on p-v diagram) Take cp=1.01kj/kg.k, R=0.28kj/kg.k
As shown in the diagram, the state of helium gas is changed in such a way that its PV graph is a straight line segment with volume Vo increases to yVo and pressure Po increases to xPo where x and y are arbitrary constants. During this process the total heat transferred to the gas is equal to the heat necessary to double the absolute temperature of the gas at constant volume. What is the maximum ratio for the volume increase? xP, P. Vo
An air bubble rises from the bottom of a well where the temperature is 25oC, to the surfacewhere the temperature is 27oC. If the depth of the well is 5m and the atmospheric pressure is101.325kPa, determine the following:a. Initial pressure inside the air bubble (P1). b. Volume of air bubble at state 1. c. Volume of air bubble at state 2. d. Percent increase in volume of the bubble.
The frictionless piston and cylinder contain 1 kg of water. The initial pressure and volume are each pressure of 100kPa 0.25 m^3 (state 1). The system was gradually heated and when the volume of water in the cylinder became four times the initial volume (state 2), the piston was fixed and heating was continued until the water pressure reached 300 kPa (state 3). (1) Find the final temperature in the cylinder (2) Find work during this process (3) Find the amount of heat transfer during this process. Try to approximate this process on a P-v diagram.
What is the specific internal energy of water at 50°C with a specific enthalpy of 1500 kJ/kg? Report your answer to one decimal place using rounding.
For the cylinder below, the final volume inside cylinder (V3) in (Liter) ;is A frictionless piston-cylinder device initially contains 0.2 kg of steam at 400 kPa, 300 °C. Now the steam loses heat to the surroundings and the piston moves down, hitting a set of stops at which point the cylinder contains saturated liquid water. The cooling continues until the cylinder contains water at 135 °C. |frictionless Piston /// / Steam ,m=8-2 kg Pi= 400 kPa Ti= 300°C (sat. lig.)2 T3 = 135 C stops Below 0.1 O Between 0.1 and 0.2 O Between 0.2 and 0.3 Above 0.3 O
During processing in a steel mill, a 375kg steel casting at 800 degrees is quenched by plunging it into a 500-gal oil bath, which is initially 75 degrees . After the casting cools and the oil bath warms , what is the final tempertature of the two? The weight per unit volume of the oil is 7.5 lb/gal.
Oxygen (molar mass 32 kg/kmol ) expands reversibly in a cylinder behind a piston at a constant pressure of 3.102 bar. The volume initially is 0.0119 m and finally is 0.0327 m; the initial temperature is 18.24 °C. Calculate the heat supplied during the expansion in the correct unit to two decimal places. Assume oxygen to be a perfect gas and take the specific heat at constant pressure as = 0.917 kJ/kg Kand molar gas constant as = 8,314 J/ kmol K