A gaseous fuel was reported to have the following volumetric analysis: CH 84.1 % C,H 6.7 % 0.8 % N2 8.4 % Estimate the Higher Heating Value of the fuel, in kg fuel O HHV = 46,511 ko fuel о ннV- 48,511 kg fuel O HHV = 50,511 kg fuet O HHV = 52,511 Ag fuel

Q: Gold has a density of 19.3 g/mL. Calculate the radius of an Au atom expected if gold crystallizes in...

A:

Q: US Department of Energy, a new process is used to convert coal into electricity with minimal greenho...

A: Given that, The chemical formula of coal is C2H8O2 The mass flow rate of coal = 50 kg/s = 50000 g/s ...

Q: A triple effect evap0rat0r c0ncentrates a 10% caustic s0da s0luti0n fr0m 10% to 50% NaOH,,,,. Assumi...

A:

Q: Fresh apple juice contains 75% water flowing at a mass flow rate of 200 kg/h. The fresh juice is con...

A:

Q: Using Clausius Clapeyron Equation, Calculate the volume change (cm3/kg) of ethanol if the melting po...

A:

Q: 1. A gas detector is used to determine concentration of a flammablé gas ll Normally the gas concentr...

A: Gas detector is used to determine concentration of flammable gas in the stream . Alarm limit is 4% a...

Q: There is 0.1mole of water at 25°C (constant V = 18cm3/mol), and the pressure is increased from 1atm ...

A:

Q: Question 1: (a) An ideal gas is expanded reversibly and ad- iabatically. Decide which of q, w, AU, a...

A:

Q: The gas phase reaction A +B > 2Dh is to be run in an isothermaland constant pressure CSTR The feed c...

A: Given that, The gas-phase reaction: Ag + Bg → 2Dg,l The feed consists of a stoichiometric gas mixtur...

Q: Calculations Based on Partial Analysis of the Flue Gas A furnace is fired with coal with the followi...

A: In solid fuel combustion to know the carbon percentage we use Calderwood equation. The orsat analysi...

Q: A mixture of 70 mole% propane and 30 mole% hydrogen is burned with 25% excess air. Fractional conver...

A: Given that, The mole fraction of propane in the fuel = 0.7 The mole fraction of hydrogen in the fuel...

Q: The element selenium would be expected to form covalent bond(s) in order to obey the octet rule. Use...

A: As the given compound is selenium, The Se belongs to the same group as Oxygen, O. The number of vala...

Q: Determine the radiated heat loss for 9.84 feet tube length. Having a surface emperature of 392°F pas...

A: Given that length ,l = 9.84 ft = 3m T = 392 F  

Q: Two chemicals A and B are combined to form a chemical C. The rate, or velocity, of the reaction is p...

A: Given, Ao=100g,Bo=50g For each gram of B, 2g of A is used. M=2, N=1 A=Ao-(MM+N)C=100-23C B=Bo-(NM+N)...

Q: The equations must be dimensionally consistent in order to be able to operate. Each term must have t...

A: Vander Waals equation studies the behavior of real gases. This Vander Waal equation gives relation b...

Q: Which two streams relate to equilibrium conditions for equilibrium staged operations? Stage A 2 Stag...

A: Distillation is a separation operation in which the high volatile component is separated from the le...

Q: The figure below shows the phase diagram for two partially miscible liquids, which can be taken to b...

A:

Q: An electronic PID temperature controller is at steady state with an output of 12 mA. The setpoint eq...

A: To derive an expression for the controller output p(t) with the given parameters

Q: What is chemically engineering

A: Chemical engineering is made up of two words chemical plus engineering.

Q: The following data are for Xenon adsorption on ZSM zeolite. Evaluate the constants of the (a) Langmu...

A: Adsorption isotherms explain the concentration interphases with adsorbents surface. Each isotherm mo...

Q: The glucose in cell culture media diffuses to the cell surface where it is rapidly consumed. The glu...

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part ...

Q: What is the optimum combination of ideal reactors for the reaction A →B if it is autocatalytic with ...

A: Autocatalytic reaction is the reaction which rates is depends upon the product concentration which p...

Q: In biological systems, enzymes are used to accelerate the rates of certain bio- logical reactions. G...

A: Conversion of units involve four major steps. First name out the units used or given and the units w...

Q: 5. The gas phase reaction A→ B+ C is to be carried out isothermally in a 20 dm constant pure A is in...

A: Let us see what data are given: Reaction: Gas Phase Well mixed A → B + C First part: First order rea...

Q: 3. The radius of a hydrogen atom is 0.529 A. (1010 A = 1 m) Convert the radius of a hydrogen atom: (...

A: Given that radius of a hydrogen atom = 0.529 A we have to convert it into different unit        Acco...

Q: 4. Plot CA(T) and T(t) for the reaction A → B, r = k(T)CA in an adiabatic PFTR for E = 30 kcal/mole,...

A: Given data: The given reaction is  A→B The rate equation is , r= k(T)CA E = 30 kcal/mole k0= 2.6 x ...

Q: 5. Variable Heat Generation and Equation of Energy Change. A plane wall is insulated so that conduct...

A: The plane wall is insulated and conduction occurs only in x direction The heat generation per unit v...

Q: How can I make this equation to be like this exactly    Cb0 + Ca0 = Ca + Cb    how can I achieve...

A: Concentration of any component is the amount of moles contained in per unit volume. Ca represents th...

Q: Hydrogen chloride gas is produced by burning chlorine in methane and air as shown: Cl2 +CH4 + O2 ...

A:

Q: Blu Convert 26.4 hr ft °F m K Answer: 45.69 True O False to

A: It is required to convert 26.4 Btuhr.ft.Fo to Wm.K

Q: Calculate AU in KJ for 0.5 Kg water when it vaporized at the constant temperature of 100°C and const...

A: Given that: Mass of water, m = 0.5 kg Constant temperature, T = 100⁰C Constant pressure, P = 101.33 ...

Q: To save energy, stack gas from a furnace is used to dry rice. The flow sheet and known data are show...

A:

Q: There is 1 mol of an ideal gas at 300K (constant T) 50atm, and the pressure is increase to 2atm duri...

A: Change in Gibbs free energy determines to happen the reaction and its direction. This is equal to wo...

Q: Carbon dioxide (CO2) is made in a chemical plant by burning natural gas (CH4). The carbon dioxide pr...

A: GivenData for CO2Pressure , P=145 atm or 145×101325  =1.469×107PaVolume, V=2 m3Temperature, T=70oC o...

Q: One mole of an ideal gas in a closed system, initially at 25 ‰and 10 bar, is first expanded adiabati...

A: In any thermodynamic system there can be four important process. The process can be adiabatic, isoba...

Q: The heat engine operates on a Carnot cycle with an efficiency of 75%. at COP woulda refrigerator ope...

A: Given that  efficiency of Carnot engine ,n =  0.75 COP of a refrigerator = ?  low temperature = 1 C ...

Q: A mixture solution of Na2S, NaOH and Na2CO3 was analyzed in a lab and the results shows that it cont...

A: Hello Subscriber! There are multiple subparts to this question. As per our policy, we have solved th...

Q: 2. One kg of air in a piston-cylinder apparatus can exchange heat only with a reservoir maintained a...

A:

Q: Express the Joule-Thomson coefficient in terms of measurable quantities Cp, Cv, P, V, and T and thei...

A: Expressing Joule-Thomson coefficient in terms of measurable quantities Cp, Cv, P, V, and T and their...

Q: Dur packed bed reactor runs the gas phase reaction A → R at 10 atm nd 336°C, and gives 90% conversio...

A: Given that Temperature = 336 C conversion =0.90pressure P = 10 atm  De = 2 x 10-6 m3m cat  s -r'''A ...

Q: pipe, g/cm', and the melt has a dynamic viscosity of 3.12 g

A: 1. diameter= 10cm = 10*10-2m 2. Density = 7.8 g/cm3= 7800 kg/m3 3. dynamic viscosity= 3.12g/ms= 3.12...

Q: The density of a fluid is given by the empirical equation p = 70.5 Exp(8.27 x 10- P) where p = densi...

A: Given that, The density of a solid  ρ = 70.5 exp8.27 × 10-7 PWhereρ is in lbmft3P is in lbfin2 It is...

Q: Fresh apple juice contains 75% water flowing at a mass flow rate of 200 kg/h. The fresh juice is con...

A: Given data: Composition of fresh feed is, Water = 75 % Solids = 25 % Flow rate of fresh feed = 200 k...

Q: Viscosity Measurement of a Liquid. One use of the Hagen-Poiseuille equation (2.10-2) is in determini...

A: Given data: Density of liquid = 912 kg/m3 Diameter of capillary = 2.222 mm Length of capillary = 0.1...

Q: Problem 2: A square silicon chip (k-150W/m.k) is of width W-5mm on a side and of thickness t-1mm. th...

A: Given, K=150 W/m.K, t=1 mm=10-3 m W=5mm=5×10-3m Q=4 W Area of square chip=W2=(5×10-3)2=25×10-6m2 als...

Q: 1. Please consider steam at 500 kPa and 300 C. Please determine a. a and g in k.J/kg. b. R in cc/gm.

A: Steam at 500 KPa comes in superheated region. Steam pressure, P=500 KPa Steam temperature, T=300°C  

Q: Solve for Prandtl (Pr) and Reynolds (Re) numbers depending on type of flow: A lead pipe has 2 cm ins...

A: Dear Subscriber ! With the given information, we can calculate  Prandtl number , but would need the ...

Q: 2) You wish to place a 600-gallon tank of liquid propane, C3H8, near your house to supply your furna...

A: Given data: 600 gallons of liquid propane   1 gallon = 3785.41 cm3 Volume of liquid propane= 2271246...

Q: Consider the reaction: 2 CO(g) + 1/2 O:(g) →2 CO:(g) Given are the data at 298 K. CO -110.53 O2 CO2 ...

A: Hi and thanks for the question. The given chemical reaction is not balanced, So I am providing the b...

Q: 2.You need to separate salt from the sugar particles using sieves given the table below. Size of Mes...

A: Solid -Solid separation is conducted based on their size difference. This process is known as screen...