The current in a 30.0-mH inductor changes with time as i = 3.00t2 − 5.00t, where i is in amperes and t is in seconds.Please make sure in the correct measurement ;) (a) Find the magnitude of the induced emf at t = 1.00 s.%3Dmv(b) Find the magnitude of the induced emf at t = 4.00 s.mv(c) At what time is the emf zero?

Answered: Image /qna-images/answer/8ec95567-adf3-4174-8ec9-5a1ecb81a16e.jpg

Answered: (a) Find the magnitude of the induced…

(a) Find the magnitude of the induced emf at t = 1.00 s. (b) Find the magnitude of the induced emf at t = 4.00 s. mv (c) At what time is the emf zero?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 38P: When a camera uses a flash, a fully charged capacitor discharges through an inductor. In what time...

See similar textbooks

Related questions

Q: An iron wire has a diameter 0.85 mm and resistivity 9.71x 10-8 Qm. What will be the length of this w...

Q: Show all working explaining detailly each step Answer should be typewritten using a computer keyboa...

Q: As shown below, a bullet of mass m and speed v is fired at an at rest sphere. The bullet goes throug...

A: The total momentum of the system must be conserved according to the principle of momentum conservati...

Q: What is the speed of a 2,500 kg aircraft with 9.50E6 J of kinetic energy?

Q: For a grating of 4658 l/cm calculate the angular position of the 2nd order diffraction for the light...

Q: An 83-kg jogger is heading due east at a speed of 2.2 m/s. A 76-kg jogger is heading 18 ° north of e...

A: assume that, X-axis of coordinate system is along the East hence, X-component of momentum, Px=P1+P2x...

Q: A roller coaster car has a massive 320 kg. Starting from the rest the car requires 3.5×10^5 joules o...

Q: A thin conducting wire is bent into the shape shown in the figure. The circular portion of the wire ...

Q: A 167-lb pole vaulter carrying a uniform 15.6-ft, 11.9-lb pole approaches the jump with a velocity v...

Q: Please answer for D

A: y' = (0.752cm)sinπ/5cm-1xcos29.6πs-1t To find = Transverse speed of particle at x = 1.74 cm , t = 1....

Q: Show all working explaining detailly each step Answer should be typewritten using a computer keyboar...

A: Energy of ground level is Eg = -24.6 eV Energy level of some state is Es = - 21.4 eV

Q: A particle moves along the x axis. Its position is given by the equation x = 2 + 3t – 41², with xin ...

A: The position of a particle is givne as : x = 2 + 3t - 4t2The velocity is given by the formula : v = ...

Q: I want theory for Experiment about NEWTON’S LAW OF COOLING

A: SOlution: To explain theory for Experiment about NEWTON’S LAW OF COOLING.

Q: Show all working explaining detailly each step Answer should be typewritten using a computer keyboa...

A: Required :: The graph which represents the energy time graph of a SHM.

Q: 5. An emf is induced by rotating a 980–turn, 23.0 cm diameter coil in the Earth’s 5.30×10-5 T magnet...

Q: Two charged particles of charges 3 μC and -2 μC are placed on the x-axis on x = -2 cm and x = 2 cm r...

A: Two charged particles of charges 3 μC and -2 μC are placed on the x-axis on x = -2 cm and x = 2 cm r...

Q: do number 4

Q: A 6 kg mass attached to a horizontal spring oscillates at a frequency of 9 Hz. At t =0 s, the mass i...

Q: A block with mass m = 2 kg slides down from a friction less ramp (mu = 0). Angle theta is 25 degree...

Q: An object has 3 miliion more electrons than protons. What is the net charge of the object?

A: Given that an object has 3 miliion more electrons than protons. Then We have to determine the net ...

Q: A block of mass m = 3 kg is sliding along a frictionless inclined surface that makes an angleof φ = ...

Q: Starting from rest, a 62.0 kg woman jumps down to the floor from a height of 0.620 m, and immediatel...

Q: Show all working explaining detailly each step Answer b(i) & (ii) Answer should be typewritten u...

A: (a) (i) Renewable Resources The resources which cannot be exhausted even after continuous utilizatio...

Q: On an old-fashioned rotating piano stool, a woman sits holding a pair of dumbbells at a distance of ...

Q: Wire C and wire D are made from different materials and have length Lc = Lp = 1.4 m. The resistivity...

Q: 1a and b please

Q: 5.0 cm 0.20 T Crank 1.0 N

Q: Show all working explaining detailly each step Answer should be typewritten using a computer keyboa...

Q: Formation theories for the Moon have come and gone due to the discovery of new knowledge. The fissio...

A: The answer is given below

Q: 2- The components of a vector is (Ax = 5 m, Ay =8 m), calculate the magnitude and the direction of t...

A: Ax = 5 m Ay = 8 m To find = Magnitude and Direction of the vector

Q: A roller coaster car has a massive 320 kg. Starting from the rest the car requires 3.5×10^5 joules o...

Q: Calculate the force pushing down needed to fully submerge a block of wood, with density of 200 kg/m^...

A: Given that, the value of mass of the block and density and volume and density of water. Then We have...

Q: Part a

Q: Two blocks areconnected via a pulley,both blocks have a massof 10.kg. One block restson a horizontal...

Q: Chapter 05, Problem 082 In the overhead view of the figure, five forces pull on a box of mass m = 3....

A: In the overhead view of the figure, five forces pull on a box of mass m = 3.3 kg. The force magnitud...

Q: Show all working explaining detailly each step Answer should be typewritten using a computer keyboar...

Q: Consider the following figure. a) A conducting loop in the shape of a square of edge length ℓ = 0.30...

Q: A large wooden wheel (mass 2 kg, radius 0.5 m) is mounted on an axle so as to rotate freely about it...

A: A large wooden wheel (mass 2 kg, radius 0.5 m) is mounted on an axle so as to rotate freely about it...

Q: 27. Review. A 5.75-kg object passes through the origin at time t = 0 such that its x component of ve...

Q: Show all working explaining detailly each step Answer should be typewritten using a computer keyboa...

A: Required :: Which of the following can be used to identify an unknown element in a sample.

Q: Chapter 05, Problem 035 X Incorrect. The velocity of a 2 kg particle is given by v = (2t i+5t j) m/s...

A: Given data The mass of the particle is m = 2 kg The velocity of the particle is v→=2t i^+5t2 j^ m/s...

Q: A 1280 kg car pulls a 400 kg trailer. The car exerts a horizontal force of 3700 N against the ground...

A: M = 1280 kg m = 400 kg F = 3700 N μ = 0.14 FT = ?

Q: A monkey is 4 metres above ground in a tree when he falls. His mass is 3 kg A) find his potential en...

Q: A non-uniformly charged insulating sphere has a volume charge density p that is expressed as p= Br w...

A: Given:- ρ = Br Q = sphere charge R = radius

Q: A disk (mass M, radius R) is spinning clockwise at an angular speed 10 rad/s when a second, smaller ...

Q: If the period of a wave is 8.4 s, what is its frequency (in Hz)

A: Given : T = 8.4 s

Q: For the block that is pulled across a floor by force, F, the thermal energy of the block and floor i...

A: The rough floor will exert the frictional force on the block because the block is sliding on the flo...

Q: A positive charge +q1 is located to the left of a negative charge -q2. On a line passing though the ...

Q: When the switch is closed, the reading on the ammeter is = Amperes and Voltage =

A: The current before open, i=3 A The equivalent resistance of circuit, R=R1+R2 R=15+20=35Ω Then the ...

Q: Show all working explaining detailly each step Answer should be typewritten using a computer keyboar...

A: Vi = 2 m/s Angle between velocity after impact and the normal is Φ Coefficient of restitution is e...

Concept explainers

Electromagnets

The word "electromagnet" is composed of two words, ‘electro’ and ‘magnet’. It is a type of magnet in which an electric current helps in the generation of a magnetic field. Electromagnets usually consist of two major parts, wire and a coil around which the wire is wound. This is called a solenoid. When an electric current is allowed to pass through the coiled wire, the electric current produces a magnetic field. This magnetic field is present only when current is passing through the wire.

Question

The current in a 30.0-mH inductor changes with time as i = 3.00t² − 5.00t, where i is in amperes and t is in seconds.

Please make sure in the correct measurement ;)

(a) Find the magnitude of the induced emf at t = 1.00 s.
%3D
mv
(b) Find the magnitude of the induced emf at t = 4.00 s.
mv
(c) At what time is the emf zero?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The current flowing through a circuit is changing at a rate of 6.00 A/s. If the circuit contains a 190.0 H inductor, what is the emf across the inductor?
An alternating emf source with a variable frequency fd is connected in series with a 50.0 resistor and a 20.0 mF capacitor. The emf amplitude is 12.0 V. (a) Draw a phasor diagram for phasor VR (the potential across the resistor) and phasor VC (the potential across the capacitor). (b) At what driving frequency fd do the two phasors have the same length? At that driving frequency, what are (c) the phase angle in degrees, (d) the angular speed at which the phasors rotate, and (e) the current amplitude?
A 3.5 mH inductor and a 4.5 mH inductor are connected in series and a time varying current is established in them. When the total emf of the combination is 16 V, what is the emf of the larger inductor?
6.43 The current in an 80-mH inductor increases from 0to 60 mA. How much energy is stored in theinductor?..
A perfectly conducting filament containing a small 500 2 resistor is formed into a square, as illustrated in the figure below. Find the induced emf and I(t) if B = Bo cos wt 2. Given that Bo = 0.2 T and w = 103 rad/s. Let ds = îds. y B 0.5 m 500 N
An inductor is connected to the terminals of a battery that has anemf of 16.0 V and negligible internal resistance. The current is 4.86 mAat 0.940 ms after the connection is completed. After a long time, thecurrent is 6.45 mA. What are the resistance R of the inductor
Consider a 27.5 mH inductor that has a resistance of 4.25 Ω. a) What is the time constant, τ, of the inductor, in seconds? b) If the inductor is connected to a 12.0 V battery, what is the current, I, in amperes, after 12.5 ms?
The figure below shows a circuit with a battery of EME - 3.198 V, a resistor with R-3.3022, and an inductor with L-2208H. If the battery is connected at t-0, at what time will the rate of energy storage in the inductor be equal to the power dissipated in the resistor? R ண
What voltage is induced in a 1.00 m diameter loop 50.0 m from a 2.00 X 106 A lightning strike, if the current falls to zero in 25.0 μS
An RL circuit has an emf source of 28 v, a 62 resistor, a 38 H inductor, and a switch. At what rate, as a function of t, does the emf across the inductor change after the switch is closed?
A 6.0 V battery has been connected to an LR circuit for sufficient time so that a steady current flows through the resistor R=2.2kΩ and inductor L=18mH. At t=0, the battery is removed from the circuit and the current decays exponentially through R. Write the equation for the emf across the inductor as a function of time t. At what time is the emf greatest? What is this maximum value (V)?
For physics lab, two students constructed an RL circuit similar to the one shown in the figure, with = 6.00 V, L = 5.40 mH, and R = 8.00 Q. S R ele L (a) What is the inductive time constant of the circuit (in ms)? 0.065 X Apply the definition of the inductive time constant. ms ms (b) Calculate the current in the circuit (in A) 250 µs after the switch is closed. A (c) What is the value of the final steady-state current (in A)? A (d) After what time interval (in ms) does the current reach 80.0% of its maximum value?