A electrical company provides power to a house at 220V  AC and can supply up to 600A, for a maximum power of 132kW. The wiring in the house is sized so that the total resistance of wiring is 0.02 Ohms. What is the worst case power loss in the house due to voltage drops in the wiring?

Q: Q3. A three-phase ,30 h.p, 380 V 50 Hz, 4-pole, Y-connected induction motor has a total stator…

A:

Q: The allowable voltage drop in the figure is 5%. The underground cable is a 3-core copper conductor…

A: Given: Allowable voltage drop is 5 % Main voltage is 220/380 V

Q: Graphically illustrate that an infinitely long pure sinusoidal signal has only one frequency…

A: To do: we have illustrate graphically that an infinitely long pure sinusoidal signal has only one…

Q: A series circuit consisting of a resistor, 0.05 H inductor and a 100-microfarad capacitor is…

A: Given data: Inductance 0.05H capacitor 100-microfarad voltage 100V frequency 60Hz phase angle 80…

Q: Use block diagram reduction rules to find the equivalent Transfer Function Y(s)/R(s) of the…

A:

Q: Determine the effective resistance of the network shown below when R1=1,880, R2=1,916, and R3=…

A:

Q: True or false  1- Management it control and application everything in work place only.?  2-…

A: we have to tell the given statement are true OR FALSE with explanation

Q: Calculate the short circuit current per unit value on the secondary side of a 750 KVA transformer…

A: Since you have posted the multiple questions so we are supposed to answer the 1st one.

Q: www 470 ΕΩ 16 V 3.6 k k 8=80 VD pss=8mA Vp =-4 V 2.4 kQ2

A:

Q: Mark all that apply for the circuit below if i = 5A. 25 Ω www 2002 1052 Ω The current ix = 75A ww…

A:

Q: Given the circuit from class and that v(t)- 155.56cos(377t+23.8°) solve for the voltages, currents,…

A: For the given circuit calculation of part 1,2,3 only as mention. Given: v(t)=155.56cos(377t+23.8°)V…

Q: 9. Sketch the outline of each surface. a) r= 3,0 ≤ ≤n/3, -2≤z≤2 b) 2≤r≤5, π/3³≤ ≤л, z=0 c) 2≤r≤5, p…

A: It is given that: a) r=3,0≤φ≤π3,-2≤z≤2b) 2≤r≤5,π3≤φ≤π,z=0c) 2≤r≤5,φ=π4,-2≤z≤2d) 0≤R≤5,θ=π3,0≤φ≤2π

Q: You have been asked to produce waveforms A and B shown to enable laboratory experiments to be…

A:

Q: Q3) Find I, in the network ww 1Ω 126 v 201 1Ω www 1Ω -ΠΩ; Va 4/6°ΑΙ

A: The kcl is shown below.

Q: such that the current is five times the current flowing through R1  where I=46 A and R1=2,772 Ohms?

A:

Q: Use the color code below to determine the colors of each band for a resistor that has a value of: ΚΩ…

A: The resistance value is 1Kohm+-5%                                     = 10*10^2+-5%

Q: Question 13 The channel of the JFET is between the O the gate and source O the gate and drain O…

A: Junction field effect based transistor : A JFET, is a junction based field effect transistor in…

Q: Find the effective current of the network below where I1=229 A and 12=1,391 I1 Your Answer: I2

A: The two current sources are in parallel and are in the same direction. Hence Ieff= I1+I2

Q: A microwaye receive receiver has a total input noise power of -108 dBm and an overall noise figure…

A: We need to find out minimum recived carrier power for given FM system .

Q: resistive load of value R = A single-phase, full-wave diode bridge is used to supply power to a 75 .…

A:

Q: 3. How many modes would a step-index fibre has with a core 100 μm in diameter and a numerical…

A: Basic problem on Fibre is solved as shown below.  The solution is given below.

Q: The magnitude of the phase voltage of a balanced three-phase wye system is 160 V rms. Express each…

A: The magnitude of the phase voltage of a balance three phase system is 160 V. Then the phase and line…

Q: 1. Form the bus impedance matrix for the network shown in Fig.1. 3 11.25 j0.2 j0.4 j0.125 O Ref…

A: Given

Q: If one amp equals 1 coulomb per second (Q=It) and one coulomb equals 6.24159·1019 electrons, find…

A:

Q: Q2) find the signal at each indicating point of figure 1. (a3-3-4) kHz, X X (3 BPF USB 10 Cos…

A:

Q: The plane 2x + y = 4 carries a charge 5nC/m2. Find E and D at P(4,2,- 1). (Hint: The source is an…

A:

Q: Question 11 One of the most important characteristics of the FET is its high medium low none of…

A: JFET :  A JFET, is a junction based field effect transistor  in other words  JFETT, is a FET in…

Q: A crystal diode having internal resistance rf, = 20ohm is used for half-wave rectification. lf the…

A: Introduction Half-wave rectification Half-wave rectification is a method used in electrical…

Q: +51 V₁ 15+ www M -O 5kQ 2mA | 10kΩ (d)

A:

Q: Complete this example-using flip-flop J-K (74LS73) Estado Futuro Output Estado Presente QA 0 0 0 0 0…

A:

Q: A single phase inductive load of 7500 kw has a lagging pf of 0.8. Draw the power triangle and…

A: Given data: Active power P= 7500kW Power factor = 0.8 lagging i.e angle Ø1 = cos-1(0.8) = 36.86° We…

Q: Question Assume the same LTI system presented in Question No. 1 with impulse response h[n] and the…

A:

Q: (a) Choose R2 such that the ideal voltage gain is Av = 40dB and draw the amplifier’s transfer…

A:

Q: 8 Ω Determine the value of V6 +V6n ? 6Ω 1 ΜΕ 20 2 9 V IyΩ ? ΤΩ 161₁ - 21₂= 4 -21₁ + +9/₂= -9

A:

Q: 1. For the Intel 8086 microprocessor interface diagram below chose the suitable ICs to be connected…

A: 8086 microcontroller:

Q: At cutoff, the JFET channel is at its widest point completely closed by the depletion region…

A: We need to select correct option for jfet in cut off region .

Q: For the circuit below, a. Label the voltage on each resistor and the loop current b. Write a KVL…

A:

Q: What is the value of V? 20-2 + V VIA th 162 LIA 1-2 Share Flore

A:

Q: You are given the circuit shown below. Note that the connected to the + terminal of the capacitor…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: QUESTION 5 With reference to the instruction below ,what is the value of the number stored at the…

A: Choose the correct answer:

Q: In a single-phase half-wave ac-dc converter, the average value of the lo current is 1.78 A. If the…

A: Since you have asked multiple questions in a single request, we will be answering only the frst…

Q: power if the fibre loss i

A:

Q: A JFET has a specified pinch-off voltage of 5V. When VGs=0, what is Vos at the point where drain…

A: In this question We need to choose the correct option We know Drain current ID = IDSS (1-VGS /Vp )2…

Q: If I the star is substituted with delta, what is the value of RB? 42 RB ул. дл RA m 82 Rc &82

A:

Q: Derive the of QPSK overall scheme. probability of symbol error

A: We need to derive the overall Probability of symbol error .

Q: The output of a measurement device (sensor/transducer) ranges between 0 Vdc minimum to +0.375 Vdc…

A: According to the question, the input to the 741 OP-AMP +0.375 Vdc. If the output of the amplifier is…

Q: A series RLC circuit has R = 20 kQ2, L = 0.2 mH, and C= 5 μF. What type of damping is exhibited by…

A:

Q: Question 11 Design a Duplex layer simplex lap winding DC machine armature winding by providing a…

A: Given the information, Design a Duplex layer simplex lap winding DC machine armature winding by…

Q: You have been hired as an engineering consultant to diagnose an overheating and low output voltage…

A: Given data:No load condition:Ioc=3∠−60∘AVoc=400∠0∘VLoad condition:Ild=8.45∠−37.35∘AVld=370∠−0.64∘V

Q: 3. a) Evaluate Energy Spectral Density (ESD) and Power Spectral Density (PSD) of a periodic signal.

A:

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.