A dc ammeter has an internal resistances of 0.1 ohm. A shunt of 1.010 milliohm is connected to the ammeter. What is the multiplier of the set-up?

Q: (a) Calculate the average power absorbed by an impedance Z = 30 -170 2 when a voltage V = 120 200 is…

A: Given data, Voltage V=120∠00 V. Impedance Z=30-j70 Ω.

Q: Answer the following (a) An amplifier with Ri = 330 kΩ, Aoc = 500 V/V, and Ro = 1.5 Ω isdriven by a…

A: We need to find out gain for given amplifier for different value of load resistance .

Q: Obtain a simplified Product of Sums (POS) form for the following K-map: AB CD 00 01 11 10 1 00 1 01…

A: Product of sum(POS) Created by Boolean expressions known as sum expressions are constructed from…

Q: Given the period T = 861 microsecond, find the frequency in rad/sec. Provide your answer in rad/sec…

A:

Q: signal flow graph

A:

Q: Four resistances are connected in series, 5  ohms, 10 ohms , 15 ohms and 20 ohms respectively to a…

A:

Q: A filter in the form of a series L–R–C circuit is designed to operate at a resonant frequency of 5…

A: Resonant frequency = 5 kHz Inductance L = 20 mH Resisyance R = 10 Ω

Q: In the given circuit, obtain V₁, V2, and v3. Assume A = 130 V, B = 120 V, C = 70 V, and D = 120 V. +…

A: Given A = 130 V , B = 120 V , C = 70 V , and D = 120 V.

Q: A receiver connected to an antenna whose resistance is 75 ohms has an equivalent resistance of…

A: Given, the equivalent resistance of the antenna is,Req=50 Ω resistance of the receiver will be, R=75…

Q: In a dielectric material, Ex = 5 V/m and P Calculate: (a) Xe (b) E (c) D − (3ª¸ − a, + 4a) nC/m².…

A: Given data, Ex=5 V/m P=110π3ax-ay+4az nC/m2

Q: Power-supply efficiency. A certain power supply operates from an AC line and delivers 48 VDC…

A:

Q: The Channel Coding Theorem

A: SOLUTION  .               Channel Coding Theorem The primary purpose…

Q: Question No.82 The steady state error for a ramp input for a unity feedback system with open loop…

A: Given a unity feedback system, Open loop transfer function, Gs=kss+1. Unity feedback, Hs=1.…

Q: F(A,B,C,D) = (B'+D')(A+C'D)+BCD' 1. Find Minterms and Maxter, in short notation 2. Draw logic…

A:

Q: I have the magnitude and phase Bode plot for the following equation. I need to draw by hand or with…

A: According to the question, we need to draw the magnitude and phase plot for the Bode plot for the…

Q: Q20) If the total current supplied by the battery is 2 µA, calculate the voltage across R₂ in the…

A: Given circuit: Total current supplied by the battery, I=2 μA.

Q: If the frequency of a rectifier is doubled (for the same load and capacitive values), the ripples…

A: This is a problem of application of diode. The detailed solution is given in the next step

Q: For the circuit in the given figure, use KCL to find the branch currents to 14. Assume A = 5 A, B =…

A:

Q: Convert the following diagrams to circuit diagram.

A:

Q: From your life experiences, list 3-5 examples of products that you have used that contain…

A:

Q: Puease Find sola

A: It is given that:

Q: There are three node voltages, x, y, and z, labeled in the network. Each source contributes…

A:

Q: A coil has a resistance of 30Ω and an inductance of 0.5H . If the current flowing through the coil…

A: Given: Resistance, R=30Ω Inductance, L=0.5 H Current, Irms=4A Frequency, f=60Hz

Q: Use mesh analysis to determine the power absorbed by each resistor and power delivered by each…

A: Given- Voltage source= 42 V, 10 V Resistance values = 6 ohm, 3 ohm, 4 ohm To find- By using mesh…

Q: A 100 KVA transformer with 4% impedance is connected in parallel with a 75 KVA with 3% impedance.…

A:

Q: • The plates of a capacitor are separated by a mica sheet 0.0001 m thick. The effective area of the…

A:

Q: 1.) Please consider the system described by the open-loop transfer function: S-2 G(s) = (s + 1)(s² +…

A: In this question,  We need to determine the range of K for the stability of the closed loop system.…

Q: A 2300/ 230 V, 20 KVA Transformer has the following Short Circuit Test Data. Calculate the %…

A: Given that: 20kVA, 2300/230 V, the transformer has short circuit data. PSC= 250 Watts VSC= 50 Volts…

Q: Calculate the total inductance:

A:

Q: Let x[n] = u[n+2] − u[n −3]. Draw the signal g[n] (on paper if it is easier) and explain how the…

A:

Q: 7V ΤΩ 2 Ω 3Ω +7 A 20 2 Ω Σ1Ω

A: The mesh analysis is done as following.

Q: Question - A in a load of (40+j30) 2. Find VSWR. transmission line having 50 2 impedance is…

A:

Q: 1-10. The wire shown in Figure P1-7 is moving in the presence of a magnetic field. With the…

A:

Q: Question - A in a load of (40+j30) 2. Find VSWR. transmission line having 50 2 impedance is…

A: Given - impedance of transmission line = 50 Ω, Load = (40 + j30) Ω,   To find- VSWR.

Q: 8. The sole purpose of a commutator in a d.c. Generator is to (a) increase output voltage (b) reduce…

A:

Q: Convert the wiring diagram to circuit diagram

A:

Q: A three-phase, fully-controlled thyristor bridge converter is used as line commutated inverter to…

A: Given- Three phase thyristor bridge converter, 50 kW power 420 V dc, 415 V(line), 50 Hz ac mains, To…

Q: Current amplifier CATHR Source R₂ Load 1. Apply the current divider formula twice to derive an…

A:

Q: According to the supply given w=4 rad /sec 64° X₁₂ хс 8 In phasour domain, = WL : $85 j4 1 WC by…

A:

Q: Q20) If the total current supplied by the battery is 2 µA, calculate the voltage across R₂ in the…

A: This is a basic problem of circuit. The detailed solution is given in the next step

Q: in I ww ID T5V Vo - Given that Vin is 7V: a. b. c. What is ID if the diode is on? What is Vo if the…

A: Given that: The circuit is shown below.   Vin= 7V Find; Calculate ID when the diode is ON.…

Q: Problem 2. Referring to the circuit given in Figure 2, a. If ix = 5A, find v₁ and iy; b. If v₁ = 3V,…

A:

Q: If y = 4 sin (wt+25%) and i = 6 sin (wt-10%) v leads i by 35° v lags i by 35° y leads i by 15° v…

A: Given, Voltage, v=4 sinωt+25° V. Current, i=6 sin ωt-10° A.

Q: Determine the mesh current i2 5 V + O-1.132 A O 1.132 A O-0.105 A 0.105 A 40 ww www + 50 www 202 2 V…

A: In this question,  We need to determine the current i2 . we are solving this problem using the mesh…

Q: Consider a control system descried by Y(s) (s+4) U(s) (s+2)(s+3) = a. Obtain state-space…

A: Given: Y(s)U(s)=S+4S+2S+3 Find: Obtain state-space representation in time domain  Obtain…

Q: For the nodal voltage for the following circuit. To make things easier, the circuit is already…

A: In this question,  We need to matrix of the equations of the nodal analysis.  We are solving this…

Q: 3. Find I, using Norton's Theorem. 4 lov (+ २७ a I. SV +- दु b --- ssa

A: Given:   Required: Find I0 using Norton's current.

Q: A transformer has a turns ratio of 8:1. If the primary voltage is 120Vac, then what is the secondary…

A: The transformer is given below. This is basic problem of turns ratio on transformer.

Q: Select one ad.0.5KHz 10KHz 24.For the AM modulated wave shown below, the carrier frequency is UN

A: It is given that:- fc =?

Q: Solve for the solution of the ODE: 5Dx+3x=10. At t=0, x=0.50.

A:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.