A cylindrical water tank has a height of 8 m and a radius of 2 m. Suppose the water tank is half full of water. Determine the work required to empty the tank by pumping the water to a level 2 m above the top of the tank. Leave the answer in terms of p, g, and pi if necessary

A cylindrical water tank has a height of 8 m and a radius of 2 m. Suppose the water tank is half full of water. Determine the work required to empty the tank by pumping the water to a level 2 m above the top of the tank. Leave the answer in terms of p, g, and pi if necessary

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.113P: Calculate the resultant force caused by the water acting on the parabolic arch dam. The water levels...

See similar textbooks

Related questions

Q: Using Bernoulli's principle between point 1 and 2, determine the maximum height that the water can…

Q: A car moves at a constant retardation of 6 m/s2. This means that the car

A: Given statement: The car moves at a constant retardation of 6 m/s2.

Q: Q4\closed system of 2kg undergoes adiabatic process. The work done on the system is 30000 J. if the…

Q: Consider a cubical water tank with a side length of 3 m. The tank is half filled with water, and is…

Q: A box with a mass of 600 kg is dragged up an incline 12 m long and 4 m high by using a cable that is…

A: Given data *The mass of the box, m = 600 kg *The height of the box, h = 4 m *The incline length of…

Q: 3. The homogeneous gate shown in Fig. P2.88 consists of one quarter of a circular cylinder and is…

A: Given:- Homogenous gate To Find:- Weight of the gate per meter of the length

Q: The difference between the heights of energy grade line (EGL) and hydraulic grade line (HGL) is…

A: The expression of the height of the energy grade line is given by, Here, H is the height of the…

Q: a 3m diameter vertical cylindrical tank rotates at a constant rate of 12rpm.if the pressure at the…

Q: Consider a cubical water tank with a side length of 3 m. The tank is half filled with water, and is…

A: Given Data: Consider the diagram shown below for the initial condition when there is zero…

Q: A closed cylindrical tank 1.5 m in diameter and 3.6 m high is ¾ full of water. The air pressure…

Q: The hydraulic life in a car repair shop has an output diameter of 30 cm and is to lift cars up to…

A: Pressure in a fluid system has magnitude but not a specific direction and thus, it is a scalar…

Q: Determine the required value for M in kg

A: h = 2.7 m d = 0.75 m width of the gate = 2 m. It is required to determine mass M of the cylinder.

Q: A 15 cm diameter, 50 cm high vertical cylindrical container is partially filled with 30 cm high…

A: Answer: The pressure difference in between the center and the edge of the container is 1125 Pa.…

Q: water Hava Patm Şu h h Civa

Q: m before the bend to 0.4 m after it. Water enters the bend at the rate of 0.5 m3/s with a pressure…

Q: An airplane weighing 20,896.36 lb, at ground is flying at an altitude of 31,529 44 ft at 524 miles…

Q: Find the work done in pushing a car a distance of 8 meters while exerting constant force of 900 N.

A: Given data : Force F=900 N Displacement d=8 m Required : Work done

Q: A certain fluid in a closed system initially at a pressure of 200 psia and having a volume of 3 ft…

Q: Choose correct answer: The _______ determines the change of state of the system A. process B.…

A: whenever a system changes its equilibrium state from one to another, then the system has to…

Q: A fluid, contained in a horizontal cylinder fitted with a frictionless leak proof piston, is…

A: Given data: The diameter of the cylinder is D = 0.40 m. The time of the stirring process is t = 10…

Q: In a closed system, the absolute pressure of a gas remains constant at 50 kPa while its volume…

A: Given Data Pressure 50Kpa V1=20cm3 V2=50cm3

Q: 2. The gage pressure of the air in the tank, as shown in the figure is measured to be 80 KPa.…

Q: PROBLEM: A hemispherical open tank used for concentration of sulfuric acid (Sp. Gravity=1.25) is…

Q: A piston-cylinder shown below is connected with a paddle wheel coupled in a 120 kg mass. The mass…

Q: Determine the specific volume v for R-410a at the following states: T = -15°C; P = 500 kPa T = 20°C;…

A: 1st two values of specific volume can be obtained from any standard table of thermodynamic property…

Q: The pressure of a gas in piston-cylinder varies with volume according to PV=C. The initial pressure…

Q: For the system shown in the Figure, Reservoir I has a water depth of 7 m and Reservoir 2 has a water…

A: INTRODUCTION : The head losses occur in pipes when the area of the crosssection occurs in the pipe…

Q: The paint level is h = 0.8 m with a density of 1200 kg / m3 in an open cylindrical tank with a…

A: Given that, Level of paint, h=0.8 m,Density of paint, ρ=1200 kg/m3Heigjht of the cylinder, H=0.9…

Q: A glass tube is attached to a water pipe, as shown in the figure. If the water pressure at the…

Q: 2. The gage pressure of the air in the tank, as shown in the figure is measured to be 80 KPa.…

A: Given data, Gauge pressure at the tank P= 80 KPa. Height of water =H1 = 30 cm Height of oil H2 =…

Q: Q2: The water in a tank is pressurized by air, and the pressure is measured by a multi fluid…

A: Given data as per the question The density of oil =850 kg/m3 Density of mercury =13600 kg/m3 h1 =…

Q: Q3: Calculate the applied force to move the process Envierment w-100 lb p=0.2 Process W 100 lb μ=0.2…

Q: A 1.5 m high by 1.8 m wide by 4.5 m long enclosed tank is filled with water and accelerated…

Q: the maximum height to which the water stream could rise.

A: Given: z1=20 m Pg=2.0265 bar To determine: the maximum height to which the water stream could rise

Q: A glass tube is attached to a water pipe. If the water pressure at the bottom of the tube is 110 kPa…

A: Given data the pressure at the bottom of the tube (P) = 110 kPa local atmospheric pressure (Patm) =…

Q: The Diameters of a small piston and a large piston of a hydraulic jack are 5 cm ad 10 cm…

A: The load lifted by the large piston: 1. When the piston are at the same level: 320 kN. 2. When…

Q: same elevation and is at rest. The system internal energy between its initial and final states…

Q: Calculate the maximum pressure (in MPa) in a container 4 m long and 3 m high that is filled with…

Q: 3 A tank is full of water. Find the work W required to pump the water out of the spout. (Use 9.8…

A: Work is done by a force on a body when the body is moved. The amount of work done is directly…

Q: The U-tube at both ends is open to the atmosphere. And the liquid between water and oil does not mix…

A: According to the information, we have a tube that is open with both ends and partially filled with…

Q: An open cylindrical tank with radius of 0.30 m and a height of 1.2 m is filled with water. Determine…

A: Please refer to the detailed solution given below, Answer - OPTION D = 0.058 cu.m. Given Data -

Q: 2. The gage pressure of the air in the tank, as shown in the figure is measured to be 80 KPa.…

Q: Problem 2.82 Pan-99 kPa A glass tube is attached to a water pipe, as shown in Fig. P2-84. If the…

Q: a 2.3 m high by 2.5 m wide by 4.5 m long enclosed tank is filled with water and accelerated…

Q: (1) The mercury manometer in the Figure below is connected to the inlet and outlet of a water pump…

A: Dear student, According to the guidelines I am allowed to answer only one…

Q: A man is pushing a cart that weighs 100 lbf with its contents up a ramp that is inclined at an angle…

A: Given data:

Question

A cylindrical water tank has a height of 8 m and a radius of 2 m.

Suppose the water tank is half full of water. Determine the work required to empty the tank by pumping the water to a level 2 m above the top of the tank.

Leave the answer in terms of p, g, and pi if necessary.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Calculate the resultant force caused by the water acting on the parabolic arch dam. The water levels are 16 ft on the upstream side and zero on the downstream side. For water, use =62.4lb/ft3.
One side of the container has a 03-m square door that is hinged at its top edge. If the container is filled with water, determine the smallest force F that must be applied to the bottom edge of the door to keep it closed.
A very large cyndrical shaped tank has a radius of 4 feet and a height of 15 feet. The tank is filled with chocolate milkshake to a depth of 11 feet. The weight density of the milkshake is 48 pounds per cubic foot. Find the work required to pump the milkshake to the top of the tank.
Find the work done in pumping gasoline that weighs 42 pounds per cubic foot. A cylindrical gasoline tank 3 feet in diameter and 8 feet long is carried on the back of a truck and is used to fuel tractors. The axis of the tank is horizontal. The opening on the tractor tank is 5 feet above the top of the tank in the truck. Find the work done (in ft-lb) in pumping the entire contents of the fuel tank into the tractor. (Round your answer to the nearest integer.) X ft-lb
A spherical tank of diameter 4 m is half-full of water (weight density = 9800 N/m3). Setup the integral for the work done in pumping the content to a point 3 m from the top of the tank. (Hint: Put the bottom of the tank along the x-axis.)
A conical tank of top radius 4-ft and height 4-ft is filled with oil with a specific weight of (20a+4) y. The work needed to pump the oil out of the top of the tank is equal to where a is a constant. What is the value of a? -nу ft-lbs, a
A cylindrical tank of radius 5 ft and height 9 ft is two-thirds filled with a liquid of weight density rho lbs./ft3. The work (in ft-lbs.) required to pump all the water over the upper rim is given by the integral
A hemispherical tank of radius 4 meters is full of water. find the work done in pumping all the content to the top of the tank. Show complete solution.
The vat shown in the accompanying figure contains water to a depth of xo = 1.4 m. Find the work required 4 m 6 m %3D to pump all the water to the top of the vat. 3 Use 9810 N/m as the weight density of water. 3 m NOTE: Enter the exact answer. Work J %3D
A fish tank that contains 60 cm high water is moved in the cabin of elevator. Determine the pressure in kPa at the bottom of the tank when the elevator is moving upward with an upward acceleration of 3 m/s^2. Include the free body diagram in your solution. a.5.89 b.4.09 c.7.69 d.6.46
Find the pressure at the bottom of a tank containing a 3 m thick layer of mercury, a 2 m thick layer of water, and a 4 m thick layer of oil (D = 700 kg/m3). The tank is open to the air.
While the pressure remains constant and 99.7 psia, the volume of air changes from 12 cubic feet to 20 cubic feet. Find the amount of work done on or by the closed system.