A man is pushing a cart that weighs 100 lbf with its contents up a ramp that is inclined at an angle of 10◦ from the horizontal. Determine the work needed to move along this ramp a distance of 100 ft considering the cart and its contents as the syste

A man is pushing a cart that weighs 100 lbf with its contents up a ramp that is inclined at an angle of 10◦ from the horizontal. Determine the work needed to move along this ramp a distance of 100 ft considering the cart and its contents as the syste

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.122P: The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate...

See similar textbooks

Related questions

Q: A pump can discharge about 419.2 liters of water in one day. This work done by the pump is equal to…

A: Given: The pump discharge about 419.2 liters of water in one day. The head is H=2 m, The density of…

Q: 2–62. Determine the resultant force that the water and oil together exert on the wall ABC.The wall…

Q: A 3-kg plastic tank that has a volume of 0.2 m3 is filled with liquid water Assuming the density of…

A: Given Data : Mass of tank(m)= 3kg Volume(V)=0.2 m3 Density of waterρ=1000kgm3

Q: A box with a mass of 600 kg is dragged up an incline 12 m long and 4 m high by using a cable that is…

A: Given data *The mass of the box, m = 600 kg *The height of the box, h = 4 m *The incline length of…

Q: Emperor Wang So weighs 790 N and is pushing a golden cart that weighs 440 N with its contents up a…

Q: r at 50 °F and at

Q: a 3m diameter vertical cylindrical tank rotates at a constant rate of 12rpm.if the pressure at the…

Q: A gas is contained in a vertical, frictionless piston cylinder device. The piston has a mass of 2 kg…

Q: A gas is contained in a vertical, frictionless piston-cylinder device. The piston has a mass of 4kg…

Q: onsider two altitudes A and B, the pressure at altitude A is 213.57 psf and the specific weight at…

A: Given: Pressure at altitude A = 213.57 psf =213.57*47.88 = 10225.7316 N/m2 The specific weight of…

Q: m before the bend to 0.4 m after it. Water enters the bend at the rate of 0.5 m3/s with a pressure…

Q: A piston-cylinder device contains 5 kg water. The piston has a mass of 25 kg and a cross-sectional…

Q: An airplane weighing 20,896.36 lb, at ground is flying at an altitude of 31,529 44 ft at 524 miles…

Q: man weighing 180 Ibf is pushing a cart that weighs 100 lbf with its contents up ramp that is…

Q: Find the work done in pushing a car a distance of 8 meters while exerting constant force of 900 N.

A: Given data : Force F=900 N Displacement d=8 m Required : Work done

Q: A certain fluid in a closed system initially at a pressure of 200 psia and having a volume of 3 ft…

Q: Determine the volume of rigid tank if contains 50 kg of saturated liquid water at 90°C. * O 0.0718…

A: The steam exits in three phases:- Saturated Liquid Saturated Steam Supersaturated steam

Q: Q2. A Pelton wheel has diameter of 4m and the average force of water against the blades is 13.13KN.…

Q: Q2: A gas is contained in a vertical, frictionless piston-cylinder device. The piston has a mass of…

A: Sol:-According to the given dataweight of the piston, W=3.2X9.81=31.392NForce exerted by sprintg,…

Q: Determine the pressure in a vessel of mercury at a point 300 mm below the liquid surface when it…

A: Given data a= 1.5 m/s2 upward h= 300 mm= 0.3 m Let density of mercury d= 13600 kg/m3 Let g= 9.81…

Q: The hull of a boat has a volume of 180 m^3, and the total mass of the boat when empty is 8560 kg.…

Q: Can I ask if the man is 200lb should I convert it to lbf to get the force or is it direct? Or as is…

A: no ,both have same magnitude lb represent the mass in pound and lbf represent pound force

Q: If a cup of cream having a density of 1005 kg/m^3 is turned into 3 cups of whipped cream, determine…

Q: Determine the total force(in kN) acting at the rear wall of the container.

A: Determine the total force acting at the rear wall of the container.

Q: The hull of a boat has a volume of 180 m3, and the total mass of the boat when empty is 8560 kg.…

A: Given data: Volume, V = 180 m3 Mass of empty boat, m = 8560 kg The weight of the unloaded boat is;…

Q: A man weighing 180 lbf is pushing a cart that weighs 100 lbf with its contents up a ramp that is…

A: Given data: Wm=180 lbfWC=100 lbfθ=10°L=100 ft Need to determine required work for the man and the…

Q: A 175-lb man climbs a flight of stairs 12 ft high. Determine The work done on the man by gravity.

A: Workdone = mass x gravity x height mass = 175 lb = 175 x 0.453…

Q: A 6-kg plastic tank that has a volume of 0.18 m is filled with liquid water. Assuming the density of…

A: Given : Weight of the tank Wtank = 6 kg Volume of the tank Vtank = 0.18 m3 Density of water…

Q: A container with water which has a mass of 36 kilograms rests on the floor of an elevator. Determine…

Q: A car moves at a constant speed of 6 m/s. This means that the car

A: Given data: The car is moving at a constant speed of 6 m/s.

Q: The barometer of a mountain hiker reads 980 mbars at the beginning of a hiking trip and 790 mbars at…

A: Given data as per the question Pressure measured at the beginning =980 mbar Pressure measured at the…

Q: 2. What is the difference between intensive and extensive properties? Prove that pressure (P), is an…

Q: WL 5 m y = 2 30 5 m b

A: given data from basics determine the force acting on one side of a surface kept vertical in…

Q: Determine the force to accelerate 10 kg at a rate of 10 ft/s2 in Newton.

A: Given data Mass=10 kg acceleration=10 ft/s2=10×0.3048 m/s2=3.048 m/s2

Q: The depth of water in the swimming pool is 4 m as shown in Figure Q2, at the temperature of 6 °C.…

A: Given data: The density of water at 6 degrees Celsius is nearly 1000 kg/m3.

Q: B- Determine the mass and the weight of the air contained in a room whose dimensions are 600 cm x…

A: Given:Dimension of room=600cm,600cm,800cmHence,Volume of…

Q: A swimming pool has a width of 12ft and a side profile shown in figure. gamma w= 62.4 lb/ft^3.…

Q: A 3-kg plastic tank that has a volume of 0.2 m3 is filled with liquid water. Determine the weight of…

A: Given Mass of tank, m = 3 kg Volume, V = 0.2 m3 Find Weight, w

Q: A 6-kg plastic tank that has a volume of 0.18 m3 is filled with liquid water. Assuming the density…

A: Given: The mass of the plastic tank is m=6 kg. The volume of the liquid water is V=0.18 m3. The…

Q: A piston-cylinder device which contains air has an initial state of 150 kPa and 0.25 cubic meter. In…

A: Given data:

Q: A hydraulic lift is used to raise a 900 – kg car. If the diameters of the small and large pistons…

A: As per given Mass=900kg D1=8cm D2=0.8m We have to determine the force that is exerted on the small…

Q: A 100-kg mass drops 3 m, resulting in an increased volume in the cylinder of 0.002 m (Fig. below).…

Q: 3. A pipe of diameter 0.5 m interferes with the bottom surface of a reservoir as shown below.…

A: Write the formula for the horizontal force on the submerged pipe. FH=ρgAph¯ Here, g is the…

Q: In a stationary fluid, the pressure of the liquid changes with O Both horizontal and vertical…

A: both horizontal and vertical there is no pressure change because it is a stationary flow

Q: 2. A vessel 3 m in diameter containing 2.4 m of water is being raised. (a) find the pressure at the…

Q: relation to the figure shown, the liquid is water (p = 1000 kg / m3). The gate is rectangular and…

Q: A boat having a mass of 80 Mg rests on the bottom of the lake and displaces 11.75 m^3 of water.…

A: To find: The smallest radius r of each spherical balloon and the mass of air in each balloon. Given:…

Q: Two pistons of a hydraulic lift have diameters of 60 cm and 5 cm. Determine the force exerted by the…

Q: A tank of cross-sectional area A is filled with a liquid of specific weight γ1 as shown in Image…

A: Given, Volume of cylinder = V Cross Section of Area = A Specific Gravity of Liquid = γ1 Specific…

Q: A tank is filled with oil whose density is ρ = 850 kg/m3. If the volume of the tank is V = 2 m3,…

Question

s) A man is pushing a cart that weighs 100 lbf with its contents up a ramp that is
inclined at an angle of 10◦
from the horizontal. Determine the work needed to move along this ramp a
distance of 100 ft considering the cart and its contents as the syste

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Calculate the resultant force caused by the water acting on the parabolic arch dam. The water levels are 16 ft on the upstream side and zero on the downstream side. For water, use =62.4lb/ft3.
The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate and the smooth surface at B due to water pressure acting on the gate. Use =62.4lb/ft3 for water.
One side of the container has a 03-m square door that is hinged at its top edge. If the container is filled with water, determine the smallest force F that must be applied to the bottom edge of the door to keep it closed.
Find the elevation h (km) where the weight of an object is one-tenth its weight on the surface of the earth.
A man is standing on a board on a frozen lake where there is no friction between the board and the ice surface. Tha man's mass is 2 m and the boaf's mass is 4 m. The board has length L. He walks from 1/5 Lfrom the left end of the board to 1/5 L from the right end of the board. How far and in which direction does the board move during this process?
Consider a 6-m-long, 6-m-wide, and 2.3-m-high above-ground swimming pool that is filled with water to the rim. Determine the distance (m), Yp, of the line of action of the resultant force from the top of the pool.
Find the work done in pumping gasoline that weighs 42 pounds per cubic foot. A cylindrical gasoline tank 3 feet in diameter and 8 feet long is carried on the back of a truck and is used to fuel tractors. The axis of the tank is horizontal. The opening on the tractor tank is 5 feet above the top of the tank in the truck. Find the work done (in ft-lb) in pumping the entire contents of the fuel tank into the tractor. (Round your answer to the nearest integer.) X ft-lb
A rectangular plane surface is 1.7 m wide and 2.7 m deep. It lies in vertical plane in water. Determine the total resultant force (in kN) on the plane surface when its upper edge is horizontal and 2.1 m below the free water surface.
Q4; A liquid when poured into a cylinder is found too weigh 12 N when occupying a volume of I liter. Determine its specific weight, density, and specific gravity of this liquid.
A cylindrical tank of radius 5 ft and height 9 ft is two-thirds filled with a liquid of weight density rho lbs./ft3. The work (in ft-lbs.) required to pump all the water over the upper rim is given by the integral
A conical tank of top radius 4-ft and height 4-ft is filled with oil with a specific weight of (20a+4) y. The work needed to pump the oil out of the top of the tank is equal to where a is a constant. What is the value of a? -nу ft-lbs, a
4. Determine the manometer reading (the length of R) in meters if the gage reads 200 kPa. Show your work