A cylindrical tank contains three liquids of specific gravities: 0.80, 1.00, and 1.50. Each liquid has a thickness of 0.60m and the tank is 1.20m in diameter. If a circular orifice 100mm in diameter is placed at the bottom of the tank to drain the fluid contents with the coefficient of discharge C = 0.650, then: Determine the time to remove the second liquid.

A cylindrical tank contains three liquids of specific gravities: 0.80, 1.00, and 1.50. Each liquid has a thickness of 0.60m and the tank is 1.20m in diameter. If a circular orifice 100mm in diameter is placed at the bottom of the tank to drain the fluid contents with the coefficient of discharge C = 0.650, then: Determine the time to remove the second liquid.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Provide solution for each answer
A fluid with a specific gravity of 0.75 flows through a horizontal pipe at a velocity of 20 ft per second. As the pipe continuously increases in area, this resulted in a decrease of 6.7 ft/s on the inlet velocity. What is the difference between pressures? (4 DECIMAL PLACES)
E10
Solve last three parts where density of fluid is 900kg/m3
An oil of density 850 kg/m3 is pumped in a pipe of diameter 20 cm. The discharge is measured as 0.015 m/s. The drop in pressure in a length of 800 m of pipeline, both ends of which are at the same elevation is measured as 98 kPa. Assuming Re < 2000, calculate the value of absolute viscosity of the oil.
A closed tank is filled with oil and water with the given situation as shown in the figure. An orifice with an unknown diameter is placed 1 m from the bottom of the tank discharging 10 L/s based on a calibration test. The jet from the orifice hits the ground 3.8 m horizontally away from the vena contracta. If the coefficient of discharge is 0.64, determine: a. The diameter of the orifice b. The coefficient of cotraction. Air p- 16 KPa 1 m S0.82 3.80 m Water 1m 2 m 1m
Pls do it correct and neatly
If the fluid is contained in a long, narrow vessel so it can expand in essentially one direction only, show that the effective coefficient linear expansion a is approximately equal to the coefficient of volume expansion b?
Water is pumped from a supply reservoir to a ductile- iron water-transmission line, as shown in Figure 2.26. The high point of the transmission line is at point A, 1 km downstream of the supply reservoir, and the low point of the transmission line is at point B, 1 km downstream of A. If the flow rate through the pipeline is 1 m3/s, the diameter of the pipe is 750 mm, and the pressure at A is to be 350 kPa, then: (a) estimate the head that must be added by the pump; (b) estimate the power supplied by the pump; and (c) calculate the water pressure at B. Supply reservoir Elev. 7 m Pump Elev. 10 m Transmission line Elev. 4 m- B Figure 2.26: Water pumped into a transmission line
In a hydraulic press, the ram has a diameter of 20 cm and the plunger 2 cm. The fluid is an oil of specific gravity 0.8. Calculate the mass that can be raised by placing a mass of 100 kg on the plunger: (i)When the plunger and the ram are on the same horizontal plane, and (ii)When the liquid level in the plunger is 0.5 m above that in the ram. What is the mechanical advantage of the press in cases (i) and (ii) above?
Question Certain fluid parameters are provided The inner cylinder, with a diameter of 20 cm, remains stationary, while the outer cylinder, with a diameter of 21 cm, holds the liquid up to a height of 30 cm. There is a 1.0 cm gap between the bottom of the two cylinders. By rotating the outer cylinder at a speed of 200 revolutions per minute (r.p.m.), the torsion meter attached to the inner cylinder registers a torque of 6.0 N-m. a. Determine the toque on the bottom in terms of b. Determine the toque on the surface in terms of ..... c. Determine method the viscosity of a liquid (N-sec/m^2)(Ans up to 2 decimal) μ (Ans up to 4 decimal) ..u.(Ans up to 4 decimal) using the rotating cylinder
Question 4 The Reynold's number for a fluid in a pipe of 25 cm diameter is 2000. Then the Reynold's number in a 15 cm diameter pipe forming an extension of the 25 cm flow pipe will be......... (round of to 2 decimal places) Take the flow as incompressible.