A block of mass M = 4 kg is pulled by a force F = 100 N forming an angle of 60 degrees with themhorizontal plane with friction coefficient 0.3. Determine the work of force F, friction force and normal force. I would like to know if this solution is correct
Q: Advanced Physics Question
A: Given:
Q: B6
A: The pressure and specific volume are always inversely proportional to one another. Pressure increase...
Q: For harmonic oscillator,
A: For harmonic oscillator The general form of the wavefunction is ψn(x)=α2nn!πe-12α2x2-1nex2dndxne-x2 ...
Q: A driver in a car, approaching a vertical wall, notices that the frequency of his car horn has chang...
A: The car as the source, wall as an observer. f1=v-0v-vc×f0 .......(1)For reflected waves, the wall i...
Q: None
A: The Lande g-factor is given as, g=2.0023 The Bohr magneton value is given as, μB=9.274×10-24 J/T The...
Q: A galvanometer coil has 500 turns and each turn has an average area of 3 × 10–4 m2. If a torque of 1...
A: Given data- I=0.5 A N=500 turns A=3 x 10-4 m2 τ=1.5 Nm
Q: The repulsive force f between the north poles of two magnets is inversely proportional to the square...
A: Given data, Repulsive force when distance is 12 inches = 28 lb Another distance = 4 inches
Q: None
A: Given Violet color wavelength λ = 0.40 μm Red color wavelength λ = 0.76 μm
Q: Amount of solar energy received on the earth’s surface per unit area per unit time is defined a sola...
A: To find -Dimension of solar constant
Q: A point charge 100 pC is located at (4, 1, -3) while the x-axis carries charge 2 nC/m. If the plane ...
A: Consider point P (1, 1, 1) where electric field E is to be calculated. Consider charge Q of 100 pC i...
Q: A block of mass M = 4 kg is pulled by a force F = 100 N forming an angle of 60 degrees with themhori...
A: A block of mass M = 4 kg is pulled by a force F = 100 N forming an angle of 60 degrees with the hori...
Q: Complete the simple analysis of temperature (for which there are always observations of temperature ...
A: Meteorological departments of all the countries use contour maps to analyze how the parameters (temp...
Q: Two sources of light emit X-rays of wavelength 1 nm and visible light of wavelength 500 nm, respecti...
A: Given: Wavelength of source 1 emitting X-ray =1 nm Wavelength of source 2 emitting visible light =50...
Q: A spherical bubble inside water has radius R. Take the pressure inside the bubble and the water pres...
A: A spherical bubble inside water has radius R. Take the pressure inside the bubble and the water pres...
Q: An ideal fluid flows (laminar flow) through a pipe of non-uniform diameter. The maximum and minimum ...
A: We have been given that, Maximum diameter of pipe = 6.4 Minimum diameter of pipe = 4.8
Q: The following is a features of a central force motion. Explain what is meant by 1. The areal velocit...
A: We need to tell why the areal velocity remains constant.
Q: None
A: Given Water level = 81 feet Raising of water stream in nozzle = 3...
Q: 1. How much heat is needed to raise the temperature of 1000 g of metal from O'C to 10 C if the speci...
A:
Q: Two surfaces current at planes x = 1 and x = 5 carry current K = -12 ay A/m and K = 6 ay A/m, respec...
A: Current is nothing but the flow of charges in time. When the current flows, a magnetic field is prod...
Q: The thrust of an outboard motor on a boat may be represented as a force F acting at an angle p relat...
A: As we know in classical Physics if the motion at any point particle or group of particle is explaine...
Q: A 2kg billiard ball moving at 4 m/s to the right hits an 8kg bowling ball originally at rest. The bi...
A: Given that:Mass of billiard ball, m1=2 kgMass of bowling ball, m2=8 kgInitial velocity of billiard b...
Q: It's a complete question. Need help asap.
A:
Q: None
A: The given relation is E=-∇ϕ-∂A→∂t (1)From the maxwell's equation we get∇→×B→=μ0J+μ0ε0∂E∂tAgain it...
Q: Fusion Reactor. If two deuterium nuclei (charge +e, mass 3.34 * 10-27 kg) get close enough together,...
A: m=3.34×10-27Kg r=1×10-15m K=8.99×109 N.m2/C2 e=1.6×10-19
Q: Two moles of an ideal gas with Cp/Cv = 5/3 are mixed with 3 moles of another ideal gas with Cp/Cv = ...
A: For γ = Cp/Cv = 5/3 Using formula Cp = Rγ/γ-1 Cv = R/γ-1 Cp = 5R/2 Cv = 3R/2
Q: 1. A light bulb is placed at the bottom of a pond that has a depth of 3 m. size of the circle of lig...
A: Given, Let the incidence angle is i. Refraction angle, r=90∘ According to Snell's Law, nwaternair=s...
Q: R1=6 Ω, R2=11 Ω, R3=17 Ω, R4=23 Ω , C1=17 µF , C2=20 µF, and V=64 V. There is no charged capacitors ...
A: The values of C1 and C2 are given as follows. C1=17×10−6 FC2=20×10−6 F The capacitor C2 is connected...
Q: In a building, there are 15 bulbs of 45 W, 15 bulbs of 100 W, 15 small fans of and 2 heaters of 1kW....
A: We have: There are 15 bulbs of 45 W, 15 bulbs of 100 W, 15 small fans of 10 W 2 heaters of 1kW. The ...
Q: Using data from Table 7.1, calculate the mass converted to energy by the fission of 1.00 kg of urani...
A: In the fission process the mass of the components of the resultant is smaller than the mass of the r...
Q: A +25.0µC point charge is placed 6.0 cm from an identical +25.0µC_point charge. How much work would ...
A: Given Charge Q1 = +25 μC = +25×10-6Charge Q2 = +25 μC = +25×10-6Distance between Q1 and Q2 = 6 cmT...
Q: A transverse wave travels on a taut steel wire with a velocity of ? when tension in it is 2.06 × 104...
A: Given data- T1=2.06 x 104 N V1=2V V2=V T2=?
Q: Questions 4 and 5
A: Solution: 4. Given that the small sphere is surrounded by the thick conducting sphere and +2Q charge...
Q: A solid cylindrical conductor is supported by insulating disks on the axis of a conducting tube with...
A: The inner and outer radii of the conducting tube are given as follows. Ra=6.95 cm=0.0695 mRb=4.75 cm...
Q: •An imaginary cylnder 150 cm bng and 35cm in radus that has a with lineur cheme tensi ty X=75nclm, l...
A: The length of the imaginary Gaussian cylinder is given as 150 cm. Let L denote the length of this cy...
Q: a. Aradioactive sample with a half-life of five hours. Calculate the radioactive efficiency after th...
A: Concept used: Radioactive decay follows exponential decay law. Decay constant can be calculated usin...
Q: A) Calculate the net force that the magnetic field exerts on the coil. B) Calculate the torque that ...
A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and s...
Q: Hello, I need help with creating a graph with the collected data and equations provided. Please and ...
A: Refer to the plot between the weight of the hooked object and displacement of the spring is :
Q: None
A: Note : We’ll answer the first question since the exact one wasn’t specified. Please submit a new que...
Q: The figure shows the hysteria-free curve for a ferromagnetic material. For this material, which styl...
A: Given: A hysteresis loop between magnetic flux density and external magnetic field. This loop is for...
Q: A fluid is flowing through a horizontal pipe of varying cross-section, with speed v ms–1 at a point ...
A: Given data-We have to use Bernoulli's theorem.
Q: Two capacitors with capacitance values C1 = 2000 ± 10 pF and C2 = 3000 ± 15 pF are connected in seri...
A: Here,ET=12CeqV2Assuming Ceq=C1C=1C1+1C2=12000+13000=56000C=1200 pFdFE=dCC+2dVV1C=1C1+1C2 ...
Q: A vector and has a magnitude of 7 units, and has a magnitude of 5 units, and the cross product of a...
A: The physical quantity which has both magnitude and direction is considered as vector, otherwise scal...
Q: Determine system acceleration and wire voltages for the systems below. Data MA =4 kg, MB = 6mkg, MC ...
A: Given :MA=4kg, MB=6kg, MC=10kg, μ=0.2 Refer to the figure below :
Q: A short current element dl = (0.500 mm)j carries a current of 5.70 A in the same direction as dl. Po...
A: Concept used: Current carrying wire produces magnetic field. The direction of field depends on direc...
Q: A load resistor 9 S2 is fed by a parallel combination of two batteries. Battery A has an open circui...
A: In this problem the battery cells are arranged in parallel. The circuit figure is given below.
Q: A small bar magnet placed with its axis at 30° with an external field of 0.06 T experiences a torque...
A: Given data-T=0.018 Nmθ=300
Q: An electron in the beam of a cathod-ray tube is accelerated by a potential difference of 2.14 kV . T...
A: When a charged particle like Sielectron comes into influence of electric field, the particle experie...
Q: Visible light of wavelength 6000 × 10−8 cm falls normally on a single slit and produces a diffractio...
A: For single slit diffraction experiment: Angle of minima are given bysin θn = nλd (sin θn ≠ θn as θ i...
Q: 5.1 Briefly describe the inadequacies of classical physics and their remedies on the following 5.1.1...
A: Failure of classical mechanics to explain the atomic theory :- There are many aspects regarding ...
Q: A disk of radius R = 3 m, lies in a region of uniform electric field E = 100 N / C. The electric fie...
A: The area of the disc (A) can be computed from its radius R as follows.
A block of mass M = 4 kg is pulled by a force F = 100 N forming an angle of 60 degrees with themhorizontal plane with friction coefficient 0.3.
Determine the work of force F, friction force and normal force.
I would like to know if this solution is correct
Step by step
Solved in 2 steps with 1 images
