A bandpass filter has an upper cutoff frequency of 84.7 kHz and a bandwidth of 12.3 kHz. What is the lower cutoff frequency. Design the ideal waveform using the given frequencies.

Need help steps would be helpful please and thank you!

AC Circuits An RC high-pass filter is shown in the figure. Its purpose is to attenuate lower frequencies while allowing higher frequencies to pass through. A 1020-Hz sine-wave signal with rms amplitude of Vrms = 2.5 V is fed into the filter. The values of the components are R = 140 Ω and C = 0.76 μF.         Part (a) Find the output rms voltage, in volts.

What is the distinction in voltage attain of a lowpass filter if the enter frequency is doubled?    What is the distinction in voltage attain of a lowpass filter if the enter frequency is expanded ten times?    How do you assemble a band give up RC filter? Simulate a circuit and generate a desk to show your claim.

A low pass filter is designed to have dB/decade. The cut off frequency is 200 Hz, and the maximum gain of the filter is 23 dB. Determine the ff: a roll off factor of 40 a. Power in dB at the cut off frequency. b. Power in dB at 4000 Hz. c. Frequency that has a power of -20 db.

If vsig is a triangle waveform, determine the maximum amplitude that vsig can have? Showyour calculation.

How to calculate the Q-factor and bandwidth of the series and parallel R-L-C circuits?

3. a) b) Write a short note on Nyquist Rate. Calculate the Nyquist rate in rad/sec and in Hz for, m(t) = 2 sinАnt · cosВnt

Answer the following wuth illustration and solutions. 1.) A second-order band pass filter is to be constructed using RC components that will only allow a range of frequencies to pass above 500Hz and below 1.5kHz. Assuming that both the resistor have values of 1kohms, calculate the values of the two capacitors required. Find also the center frequency of the two frequencies. This is the example/guide that might help.