A 50-ohm and 100-ohm resistors are connected in series. The series connection is energized by an AC source given by the equation v (t) = 8cos (120лt) volts. Using Ohm's Law, determine the total current in the circuit and use it to solve for the individual voltage drops across the 50- and 100-ohm resistors. Displaying two periods of the waveforms, superimpose the following graphs in a single plot using line width 2 and different colors: • the waveform of the AC source; • the voltage drop across the 50-ohm resistor; • the voltage drop across the 100-ohm resistor; Do not forget to put legends, titles, and labels on the axes with the appropriate units of measurement.

A 50-ohm and 100-ohm resistors are connected in series. The series connection is energized by an AC source given by the equation v (t) = 8cos (120лt) volts. Using Ohm's Law, determine the total current in the circuit and use it to solve for the individual voltage drops across the 50- and 100-ohm resistors. Displaying two periods of the waveforms, superimpose the following graphs in a single plot using line width 2 and different colors: • the waveform of the AC source; • the voltage drop across the 50-ohm resistor; • the voltage drop across the 100-ohm resistor; Do not forget to put legends, titles, and labels on the axes with the appropriate units of measurement.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter7: Parallel Circuits

Section: Chapter Questions

Problem 4PP: Using the rules for parallel circuits and Ohmslaw, solve for the missing values....

See similar textbooks

Similar questions

8 The figure is a graph of . Current Voltage the current across a voltage as a function of the potential difference through it the resistance as a function of the current across a component the current through a component as a function of the voltage across it O All three of the above (a), (b), and (c) are true O None of the above (a), (b), or (c) is true
The current through a 15kohm resistor is given below, using Ohm’s Law to find the voltage, convert to polar form, complete the math, then convert back to the waveform at i1 = 3.5sin(2500t) mA and i2 = 2.3sin(200t – 60°) mA
For the network shown in figure (3), if the switch is closed for 2usec and then opened for Susec, find mathematical expressions for vi and in of both periods of time and then plot the waveforms of vL and i as a function of time.
In a series circuit with the following devices to a 230volts 60Hz supply with a resistor in the range of 300 ohms and 990 ohms. What are the steps in calculating the impedance ...
A sinusoidal voltage has a value of 100 volts at 2.5 milliseconds and completes one cycle.It takes 20 milliseconds. Then find the maximum cost and the time to reach it for the first time
A capacitor in series with a 200 ohms resistor draws a current of 0.3 ampere from 120 volts, 60 hz source. What is the value of the capacitor in microfarad? a. 8.7 b. 9.7 c. 6.7 d. 7.7
Q9-a) Graphically show the differences between alternating current voltage (A.C) and direct current voltage (D.C). What are the advantages of A.C compared to D.C?
A sinusoidal voltage has a value of 100 volts at 2.5 milliseconds and takes 20 milliseconds to complete one cycle. Then find the maximum cost and the time to reach it for the first time.
Using the rules for parallel circuits and Ohmslaw, solve for the missing values. ETE1E2E3E4ITl1I2l3l4RTR182kR275kR356kR462kPT3.436WP1P2P3P4
Problem Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V dc voltage source.
A five-Ohm resistor is in series with a 0.001-Henry inductor and is supplied from a 10-V DC source. Solve for the current 2 milliseconds after the switch was turned on. a. 2.0000 Amperes b.1.9999 Amperes c.1.0001 Amperes d. 2.0001 Amperes
Explain the basic concepts of direct current and alternating current. Give an example with formulas and results for each of them.