A and B are two footings of size 1.5 x 1.5 m each placed in position as shown in the following figure. Each of the footings carries a column load of 400 kN. Determine the excess load that footing B carries due to the effect of the load on A. Assume the loads at the centers of footings act as point loads. - 2.5 m B [0.5 m Q = 400 kN %3D E 1.5 m 2.5 m

A and B are two footings of size 1.5 x 1.5 m each placed in position as shown in the following figure. Each of the footings carries a column load of 400 kN. Determine the excess load that footing B carries due to the effect of the load on A. Assume the loads at the centers of footings act as point loads. - 2.5 m B [0.5 m Q = 400 kN %3D E 1.5 m 2.5 m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Design of Rectangular and Combined Footing Question: (See photo) Note: Avoid rounding off values in the course of solution proper as much as possible. ROUND OFF ONLY AT THE FINAL ANSWER.
A 4.0 m square footing is proposed to be used to support a 766 mm x 766 mm RC column loaded with 550 kN dead load and 590 kN live load. The bottom of the footing is 2 m below the ground. Assume soil weighs 19 kN/m³ and the allowable soil bearing pressure is 307 kPa. The thickness of the footing is 563 mm. f'. = 21 MPa and fy = 420 MPa. It is to be reinforced with 20 mm diameter. Use 24 kN/m3 as the unit weight of concrete. Use an effective depth measured from the top of the footing until the center of the bottom-most bar (d1) Calculate the number of bars required in one direction. You Answered Correct Answer 13
Use the following planning theories to explain the ways in which you will ensure safe and efficient use of the road to avoid hawkers ,passengers that board vehicles at inappropriate venues and as well as indiscriminate use of the roads by both drivers and commuters... 1.femist planning theory 2. bargaining models 3. transactive planning 4. mixed planning model 5. rational planning theory 6. procedural planning theory
Calculate the number of steel bars #6 in a square footing necessary to resist a factored moment of Mu = 60 T-m. The footing has the following characteristics. B = 2.6 m, Fy = 4200 kg/cm2, f'c = 250 kg/cm2, d = 42.5 cm. Assume that the footing is ductile and you can use the reduction factor of 0.9 O 12 O 14 O 21 O 17
The material used in the unreinforced expandedfoundation has poor tensile and flexural properties.To ensure that the foundation has sufficientrigidity, the most effective of the followingmeasures is ( )◼A. Adjust the average pressure on the bottom of thefoundation◼B. Control the allowable value of the height-to-widthratio of the foundation steps◼C. Improve the bearing capacity of the subgrade soil◼D. Increase the compressive strength of the material
A 6ft x 6ft foundation is subjected to an axial load Q = 225k and a moment M = 100k ft. The depth of footing is 5ft. The soil unit wt is 125pcf, phi = 32deg and c=1000psf Find: 9min qmax e L' qult using the general BC equation
Answer the following problem and show your solution 1. A 400 mm concrete wall supports a DL= 200 kN and LL =146 kN. The allowable bearing pressure is 216 kPa at the level bottom of the footing which is H=1.2m below the grade. Weight of concrete is 24 kN/m^3 and that of soil is 16kN/m^3. Thickness of footing is 300mm with an effective depth of 225mm. use load combination of U=1.4DL+1.7LL f'c-28 MPa, fy=248MPa. Use 28 mm diameter reinforcing bars. Normal weight concrete λ=1.0 a. Determine the effective soil pressure b. Find the width of the wall footing c. Compute the spacing of 28mm diameter steel reinforcement
I need this answer in handwritten
A rectangular footing 2.0 m x 2.5 m carries three columns at distances from the footing center as shown below. The column loads are: P₁ = 400 kN and P₂ = P3= 200 kN. For the soil profile and properties given, check the safety factor against bearing capacity failure. (Use yw = 10 kN/m³) 0.4 m 0.2 m 2 N Depth be w surface in meters 4 C. 3 (a TENT 7 8 Note: pictures are not drawn to sale 00 0.8 m B 0.8 m 3 Water table ROCK Soil surface WIT Sand c = 0 kPa, = 30° = 16 kN/m³ Y Ysat = 20 kN/m³ Es = 12 MPa, v = 0.3 Clay c = 60 kPa, = 0° Y = 14 kN/m³ Ysat = 19 kN/m³ Cc = 0.3, Cs = 0.1 eo = 1.0 P= 245 kPa