Answered: A 90ohmsresistor, 125mH inductor and a…

A 90ohmsresistor, 125mH inductor and a 2uF are in parallel with a supply of 115 Vac at 300 Hz. Find the Admittance, Impedance, Total Current, and the True, Reactive and Apparent Power.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: what kind of device would produce the following graph of energy stored versus time, an active…

A: In electrical engineering, devices are typically classified as either active or passive. Active…

Q: Solve correctly please

Q: The answer according to the book is 5.57 MW

A: Image below contain the answer.

Q: None

A: Step 1Identify the open-loop transfer function of the system. The given system consists of a gain K…

Q: Will you consider wheeling 3 MW best scenario when a 4 MW solar system is installed? and why

A: Wheeling is a process in which a producer or generator of power transfers electricity from their…

Q: Determine whether the diode is conducting or not. Assume thatthe diode is an ideal diode.

A: Concept , References and Examples: Examples-1Examples-2 Thank you

Q: A 10 kVA transformer has a primary voltage of 208 volts and a sec-ondary voltage of 120 volts.…

A: I hope this helped you and you learned a lot :) If you have any questions or clarification, do not…

Q: solve the circuit to determine the following parameters: active power P, reactive power Q, and…

A: Step 1:### Step 1: Calculate the Impedance in Each PhaseFor each phase, the impedance \( Z \) can be…

Q: By solving the circuit in the figure by Thévenin's theorem, the following values were obtained:…

A: Step 1:

Q: Apply Mesh analysis to the circuit and obtain the current

A: Step 1: Assign currents and loops as shown below:Step 2:Step 3:

Q: Given the following circuit, + iR ic + + VC L R VR ט C - Figure 1: RLC Natural Response Circuit…

A: Approach to solving the question:Detailed explanation: Examples: Key references:

Q: Q2B. Sketch the output of the analoque computer shown below and find its describing function…

A: We need to analyze the given analog computer circuit and find its describing function. The circuit…

Q: A blue dye has an absorption band in the visible light region of the spectrum at 700 nm. Calculate…

A: 1. Convert Wavelength (700 nm) to Frequency (Hz)The energy of a photon can be related to its…

Q: 784 Example 17.8 i(1) v (1) 102 2 F Figure 17.26 For Example 17.8. Chapter 17 The Fourier Series…

Q: Don't use ai to answer I will report your answer Solve it Asap with explanation and calculation

A: Step 1:

Q: None

A: Step 1: Utilization Factor (UF):UF = (Maximum Load) / (Rated Capacity)UF = 750 MW / 750 MWUF = 1 or…

Q: Consider an amplifier of this output-input characteristics: Vo = C₁ V₁ + C₂ V2 + ...... Assume these…

Q: pleasecircleasnswer

A: Given:a=RC1=(200Ω)(1×10−6F)1=5×103b=LC1=(50×10−3H)(1×10−6F)1=2×107 Roots of equation:Writing the…

Q: Solve all showing all the steps in detail

Q: Example/find the taylor series for f(x)== at x=2. Soltion// 1 f(x) = f(2) = x x = 7(x)-7(2) = 44 2 2…

A: To find the Taylor series for f(x)=x1 at x = 2 we need to calculate the derivatives of f(x)at x = 2…

Q: Verify that the autocorrection function at origin is equal to the average power of the periodic…

A: Steps of solution 1. Autocorrelation Function at the Origin R(0) :The autocorrelation function R(τ)…

Q: Work out a flow chart detailing the sequence of manufacture of the energy saving switch for a…

A: [Design Phase] -> [Procurement Phase] -> [Manufacturing Phase] -> [Assembly Phase] ->…

Q: Don't use ai to answer I will report your answer Solve it Asap with explanation and calculation.

A: Given:Current in the circuit:I = 3 A Resistance in circuit:R = 5 Ω Voltage:V = ? Finding voltage:We…

Q: 1. Use algebraic techniques to simply the following Booleanequations in terms of the variables P, Q,…

A: Question 1: Simplify the Boolean Equations Simplifying F Given: F=P⋅S+P⋅Q⋅S+P⋅Q⋅S Combine like…

Q: Write out the answer please

Q: Don't use ai to answer I will report your answer Solve it Asap with explanation

Q: I need answers

A: Step 1: Step 2: Step 3: Step 4:

Q: 7. Design logic circuit that converts Ex-3 code to BCD code using the truth table.

A: Step 1: To design a logic circuit that converts Ex-3 code to BCD code, we first need to create a…

Q: 1. Simulate the following circuit, use a DC source as V. Put a load of your choice at Vo terminals.…

A: I have given the exact answer and analysis of DC Sweep. Kindly check the answer and understand to…

Q: Don't use ai to answer I will report your answer Solve it Asap with explanation and calculation

A: Step 1:To solve the problem, we need to find the range of VD value required for the transistor to…

Q: None

A: Regular electronic filters use capacitors, inductors, and resistors to control the flow of signals…

Q: Topic : Digital Passband Transmission 12.)

A: To calculate the probability of a bit error (BER) for M-ary Phase Shift Keying (MPSK) modulation…

Q: Show that the current through the R_load resistor is independentof the resistance value. What does…

A: Current Source Principle: The op-amp is configured to control the voltage across Rsense such that…

Q: Principles of communication .I would like to understand the details of the method for doing this.…

A: Step 1: For any periodic signal x(t) with time period T, the corresponding exponential Fourier…

Q: Find rt(ohm) Is(A) I1(A) I2(A) v1(V) v2(v) pr1(w) pr2(w) pe(w)

Q: Find the thevenin equivalent voltage across the ports A and B Note I2 is a dependent current source…

A: Step 1:Step 2:Step 3:Simplified circuit:

Q: Topic : Digital Passband Transmission 12.2)

A: Explanation is provided in the Answer Section. There are 3 types of digital modulation technique and…

Q: FIGURE 5.32 Signal for EOCP 5.7. 1 *x(t) -1 1 2 3

Q: Evaluate the convolution Y（t）= X(t) * h(t), where x(t) and h(t) are shown In the Figure, by means…

Q: (b)- A LTI discrete-time system has the o/p y(n)= (0.5)+1 u[n]+ eu[n+2]. determine whether the…

A: I have provided the answer above for you. See the answer I provided above to understand the given…

Q: Question 4: Choose the correct answer. 1- (Have you decided/ Did you decide) about your holiday…

A: The correct answers are in bold underlined letters.1. (Have you decided/ Did you decide) about your…

Q: Don't use ai i will report you answer solve it as soon as possible with proper explanation

A: For the given circuit diagram shown the capacitor is acting as the open circuited at the steady…

Q: Show all the steps in detail and provide explanation after derieving

A: Step 1:Step 2:

Q: Please fill out table and show all work. I could not read the last explanation so please do not…

A: The values used here are my own experimental measurements, as you haven't provided specific…

Q: selected 1. Complete the timing diagram for the adjacent circuit. Note: When Clr = 1, the D…

Q: Identify two different practical examples of op-amp

Q: According to the book the answer is 29.8

A: 1. Determine the Cut-off Frequency:For the dominant mode (TE10), the cut-off frequency fc is…

Q: Don't use ai to answer I will report your answer Solve it Asap with explanation and calculation

A: To design an RLC circuit in MATLAB/Simscape where the input is E(t)E(t)E(t) and the output is the…

Q: Please answer in typing format

A: a) EarthingWhat is Earthing?Earthing, also known as grounding, is the process of connecting the…

Q: (d)- find an inverse Z-T of the function: Y(z) = 2 23 (2)(2)(2-1) (e)-given x(z) = (-1)) (4), plot…

Question

A 90ohmsresistor, 125mH inductor and a 2uF are in parallel with a supply of 115 Vac at 300 Hz. Find the Admittance, Impedance, Total Current, and the True, Reactive and Apparent Power.

AI-Generated Solution

AI-generated content may present inaccurate or offensive content that does not represent bartleby’s views.

Unlock instant AI solutions

Tap the button
to generate a solution

Click the button to generate
a solution

SEE SOLUTION

Similar questions

Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
A DC-DC Chopper Circuit with an RL Load has an output current waveform shown below with a duty cycle of 50% and 1ms period. If it has a resistance of lohm and an inductance of 10mH, find the source voltage. output 5A -current 2A ten toff
4. The current through a 10-mH inductor is 10e“²A. Find the voltage and the power at t = 3s. Ans.-11.16 mV and -24.89mW
Please disregard the question on the picture. Here's the right question, at what frequency will the value of the impedance be twice that at 25Hz (refer to the given in question #20).
A resistor & a capacitor are connected in series across 230V, ac supply. The current taken by the circuit is 4 A for 50 Hz frequency. The current is reduced to 2 A, when the frequency of supply is decreased to 40 Hz. Determine the value of resistor & the capacitor.
A resistor of 20ohms and a capacitance of unknown value when connected. In in parallel across a 100V, 50Hz supply take a current of 6A. The combination is now connected across a 100V supply of unknown frequency and the current falls to 5.5A . What is the frequency?
A resistor of 20 Ohms and a capacitance of unknown value when connected in in parallel across a 100V, 50Hz supply, take a current of 6A. The combination is now connected across a 100v supply of unknown frequency and the current falls to 5.5A. What is the frequency?
A capacitor C is connected in series with a 400 resistor across a supply of frequency 60 Hz. A current of 3 A flows and the circuit impedance is 500. Calculate: (a) the value of capacitance, C, (b) the supply voltage, (c) the phase angle between the supply voltage and current, (d) the p.d. across the resistor, and (e) the p.d. across the capacitor. Draw the Phasor diagram.
What impedance vector (0- j15) Ohms represents:A. A pure resistance. C. A pure capacitance.B. A pure inductance. D. An inductance combined with a capacitance.
A circuit consisting of a resistor in series with a capacitor takes 100 watts at a power factor of 0.5 form a 100 V, 60 Hz supply. Find the current, resistance, the impedance and the capacitance.