A 5152 relay has the following settings: Pickup 2 Amps Curve U1 TD 5 If 8 Amps enters the relay, what is the pickup time in seconds to 2 decimals? Enter the number only, no units. Answer is +/- 0.01

Q: The uniform scle of a moving coil(PMMC) instrument is due to O a. more number of turns O b. currnet…

A: In a permanent magnet moving coil (PMMC) instrument. Deflection torque is directly proportional to…

Q: In an induction motor, if the rotor is locked, then the rotor frequency of induction motor will be:…

A: Given: In an induction motor, the rotor is locked.

Q: If the speed of a DC motor is increased, what will happen to the back EMF and the current drawn by…

A:

Q: Q2. Suggest a suitable method to raise the speed of a de shunt motor 1 Add file

A:

Q: Write the expressions for the following descriptions. 16. A 10 volt peak sine wave at 20 Hz 17. A 5…

A:

Q: A 250V series motor draws a current of 40A. The armature resistance is 0.15 ohm and the field…

A:

Q: A stepper motor is configured in to a half step. If it rotate 32 steps. what data pulse is the last…

A: A stepper motor is a special purpose machine used for fractional rotation in low power applications.

Q: Choose the correct statement below motors are actuators but not transducers DC motors and servo…

A: The actuator generates motion in the system by changing the electrical energy into mechanical. The…

Q: Why when I have a small, desired speed of a Dc MOTOR the measured speed has small error while if I…

A: A motor that operates by the Direct current and converts energy from direct current into mechanical…

Q: The O smaller O larger the number of poles used in a stepper motor, the better the resolution

A: here we have to give relation between the number of poles and resolution.

Q: What is the angle of the servo motor if length of the high pulse is 1.725 ms?   Select one: a.120.3…

A: Through the control wire, a pulse with a changeable width, also known as pulse width modulation, is…

Q: For a power system having induction motor loads, an overexcited synchronous motor is also attached.…

A: Power system with induction motor load and overexcited synchronous motor

Q: what sustained oscillation?

A: Sustained oscillation: A system is said to be sustained oscillated system when it oscillate with…

Q: Thyristor switched reactor(TSR) for power factor improvement

A:

Q: In Single AC regulator with bidirectional control, if the input voltage is 200 V, 50HZ and the load…

A: following data is given  Vinrms=200 volt⇒VS=Vm2=20022 volt             f=50Hz             α=60°  we…

Q: 1. A single phase half wave converter is operated from a 220 volts, 50 Hz supply and the load R = 12…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: a.8.) A robot can use a back-pressure sensor to (a) measure the intensity of visible light. (b)…

A: a.8) Back pressure sensor : Robotics engineers use back-pressure sensors mostly  to limit the…

Q: MCQS A dc motor develops of torque of 100 Nm at 1000 rpm. If the motor now runs at 1200 rpm, the…

A:

Q: In an induction motor, if the rotor is locked, then the rotor frequency of induction motor will be:…

A: Given that  The rotor of the induction motor is locked. Then the rotor frequency of the induction…

Q: A starting torque of 80 Nm is developed in an induction motor by an auto-transformer starter with a…

A: Given data :  T1 = 80 Nm T2 =  ?  Tapping N1 = 30 %  Tapping N2  = 60 %

Q: A small electric vehicle is powered by a 96 .1 V battery and uses a series wound motor. It has a…

A: Given Supply voltage V =96.1 V Armature resistance Ra =0.1 ohm Motor speed N =750 rpm Armature…

Q: a. Complete the following timing diagram. Assume Q 1 and Q3 areinitialized to zero. Be careful when…

A:

Q: (U.E.I., 0.2) 9. A shunt generator on test is separately excited and driven at 1000 rev/min. The…

A:

Q: A 12-pole induction motor has a frequency of 60 Hz. Its synchronous speed would be: (a) 600 rpm (b)…

A: Given: Total number of pole, P = 12 Induction motor frequency, f = 50 Hz

Q: Distinguish between damped and undamped oscillations.

A: Damped oscillation is the kind of oscillation where the amplitude of oscillation reduces over time…

Q: The starting torque of a squirrel-cage induction motor is low Slightly less than full load torque…

A: For squirrel cage induction motor during starting adding of resistance is not possible. As end rings…

Q: A Flyback converter (for questions 1-3) shown below has the following parameters. Vin=100V, Vo=20V,…

A: Note: As per our policy, I have attempted the first three questions. Given data: Vin=100 VVo=20…

Q: Motor horsepower: Pole count: Maximum ambient temerpature: Synchronous speed: Base speed: Slip…

A: Nameplate details from the above nameplate are written as shown below

Q: Question # 2: Find the transfer function, G(s) = 01(s)/Ea(s) for the motor and load shown in the…

A: Given system represents the mechanical rotational system. The general equation for a mechanical…

Q: a) Explain the term PWM. b) Explain why PWM keeps the switching frequency constant. c) Explain the…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: The Frequency of rotor eut of an 8-pole induction motor in 2HZ. If the Supply frego is 50 Hz, then…

A: The given data is shown below:

Q: series motor runs at (800 r.p.m) when the voltage is (400 V A). The armature resistance is (0.4 Q)…

A:

Q: The are suitable when constant speed is important. Stepper Motors Shunt Motors Servo Motors Series…

A: In this question we need to choose a correct option.

Q: How a 12 pulse converter is solving the harmonics problems?. Explain the answer in detail

A: consider the given question;

Q: If the emf in the stator of an 6 pole induction motor has a frequency of 60 Hz and that in the rotor…

A: Rotor  frequency = slip× stator frequency.  Motor speed = (1-slip)×synchronous speed. Sycronous…

Q: A 3-phase 6-pulse converter is operated from a three-phase delta- connected 230 V, 50 Hz supply to…

A:

Q: Q) Do the following project TRIAC 400V-10A T1 M C1 R2 electrosche Ttiš. P12 220VAC T2 using MATLAB…

A: given data:

Q: Describe the purpose of the engine pickup coil and how it relates to Faraday’s law.

A: Engine pickup coil is generally used in the distributor which is used in vehicles. This device is…

Q: series motor runs at 800rpm when the voltage is 400v and the current is 25 ampere the armature…

A:

Q: The rotor of a 220 -V 60 Hz, 4-pole induction motor has a power input of 80kW is observed that the…

A: In this question,  We need to choose the correct options What is rotor copper losses?  If air gap…

Up-down counter

In digital logic and computing, a counter is a device that stores (and sometimes displays) the number of times a particular event or process has occurred, often in relationship to a clock. A sequential digital logic circuit is the most common type with an input line or clock and multiple output lines. In the binary or binary-coded decimal (BCD) number system, the values on the input line represents a number by several flip-flops connected in a cascaded manner. They are manufactured as separate integrated circuits and are widely used components in digital circuits. These are also a part of larger integrated circuits. These are a specific type of sequential circuit like registers or the value of the flip-flops serving as the output.