A 3m coax transmission line used for transmission of a 3Ghz signal, has a characteristic impedance of 120 ohms. The dielectric in the line has a relative permittivity of 2.75. If the line is terminated in a load impedance of 75-j150 ohms, determine the impedance at the sending end. Show complete solution

A 3m coax transmission line used for transmission of a 3Ghz signal, has a characteristic impedance of 120 ohms. The dielectric in the line has a relative permittivity of 2.75. If the line is terminated in a load impedance of 75-j150 ohms, determine the impedance at the sending end. Show complete solution

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter13: Transmission Lines: Transient Operation

Section: Chapter Questions

Problem 13.8P

See similar textbooks

Similar questions

The VSWR on an 50-Ohm transmission line is 5. The distance between successive voltageminima is 80 cm while the distance from the load to the first minimum is 30 cm. What are thereflection coefficient and load impedance
The open circuit and short circuit impedance of a transmission line are 200 ohm and 50 ohm respectively. What will be the characteristic impedance of the transmission line?
Q) A source of 10 V and frequency 1000 KHz with internal resistance of 10 2 is connected to the sending end of a transmission line which can be represented by a resistance of 70 Q in series with capacitance of 0.001 uF connected across the line at the receiving end. An inductive load of inductance 0.002 H and resistance 100 is connected across the receiving end of the line. Determine the load current.
b) A 6052 characteristic impedance transmission line is fed by a DC source of 100V with an internal resistance of 4002. The line is 200m long and has a dielectric constant of 2.25. The load impedance is 12002. Calculate: i. The load reflection coefficient. ii. The source reflection coefficient. iii. What is the voltage at the source terminals just before AND just after 2us?
Which of the following parameter/s is represented as connected in shunt in the equivalent circuit for Transmission Lines? O A. RESISTANCE WITH THE INDUCTANCE O B. CONDUCTANCE ONLY OC. CONDUCTANCE AND CAPACITANCE O D. CAPACITANCE ONLY
A sinusoidal voltage wave is propagating on a low loss transmission line. The voltage as a function of position appears as shown below. From this plot, the phase constant B= Voltage 25 20 15 10 VAVA 5 -10 -15 -20 -25 10 20 30 40 50 60 70 80 90 100 Meters 0.489 0.625 0.314 0.562 Volts
please model a transmission line pair with an equivalent circuit model. establish the transmission equations using Kirchhoff's current law and voltage law. solve the equivalent circuit model equations to get wave equation.
A circuit consists of an AC voltage source, a 10-ohm resistor, and a capacitor, all connected in series. The magnitude of the impedance of the capacitor is also 10 ohms. Which of the following is true about the phase angle difference between the source voltage and the current through the circuit? a. Insufficient information is given. b. The phase angle difference will be zero degrees. c. The phase angle difference will be 45 degrees. d. The phase angle difference will be 90 degrees.
A lossless T-junction power divider has a source impedance of 50 2. Find the output characteristic impedances so that the output powers are in a 2:1 ratio. Compute the reflection coefficients seen looking into the output ports.
A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight meter. Determine 1)The capacitance in uF/km without effect of ground 2)The capacitance in uF/km with effect of ground
1) The AC bridge shown below in the figure has an Z₁ = 1009 + j2009, Z₂ = 600N - j300N, Z3 = 50092 and Z4= unknown. Determine the value of unknown in CD arm and specified its elements. B Z₁ Z₂ A Z3 D Z₁
At a frequency of 1.5 kHz, the open circuit impedance of the length of the transmission line is 8002-50° and the short-circuit impedance is 413-20°. Determine the characteristic impedance of the line at this frequency.