A 3 m diameter by 5 m height vertical tank is receiving water, density of 998 kg/m?, at the rate of 18 liters per second and is discharging through a 16 cm inside diameter line with a constant velocity of 1.5 m/s. At a given instant, the tank is half full. Find the level of water in the tank 15 minutes later.

A 3 m diameter by 5 m height vertical tank is receiving water, density of 998 kg/m?, at the rate of 18 liters per second and is discharging through a 16 cm inside diameter line with a constant velocity of 1.5 m/s. At a given instant, the tank is half full. Find the level of water in the tank 15 minutes later.

Name: A 3 m diameter by 5 m height vertical tank is receiving water, densit
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: A 3 m diameter by 5 m height vertical tank is receiving water, density of 998 kg/m?, at the rateof 18 liters per second and is discharging through a 16 cm inside diameter line with a constantvelocity of 1.5 m/s. At a given instant, the tank is half

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

PLEASE ANSWE QUICKLY
A horizontal pipe has a sudden expansion from diameter 8 cm to diameter 16 cm as shown in Figure Q2(b). The velocity and pressure of the water in the inlet of sudden expansion is 10 m/s and 410 kPa respectively. Based on Table 2 and setting given to you, determine the pressure at the outlet of the sudden expansion.
A 12-fl -oz glass, of 3-in diameter, partly full of water, isattached to the edge of an 8-ft-diameter merry-go-round,which is rotated at 12 r/min. How full can the glass bebefore water spills? Hint: Assume that the glass is muchsmaller than the radius of the merry-go-round.
The cylindrical tank in Fig. is being filled with water at20 ° C by a pump developing an exit pressure of 175 kPa. At theinstant shown, the air pressure is 110 kPa and H = 35 cm. Thepump stops when it can no longer raise the water pressure. Forisothermal air compression, estimate H at that time.
Man rests his coffee mug on a horizontal tray while he accelerates at 4 m/s2 as shown in the figure. The mug is 10 cm deep and contains coffee 7 cm deep at rest. Assuming rigid body acceleration of the coffee, determine AZ (cm) that is required to prevent the coffee from spilling out of the mug. Here the radius r=3.6 cm. Take the density of coffee as 1010 kg/m3.
I need the answer as soon as possible
PLEASE ANSWER QUICKLY
I need the answer as soon as possible
A wire ring of radius 6 cm is rested flat on the surface of a liquid and then slowly raised. The pull required is 0.06 N more before the film breaks than it is after. What is the surface tension of the liquid? Neglect the thickness of the ring.
A compressor draws in 0.25 m% of air whose density is 1.26 kg/m? and discharges it with a density of 4.87 kg/m°. At the suction, P, = 103.4 kPaa; at the discharge, P2 = 551.4 kPaa. The increase in the specific internal energy is 78.63 kJ/kg, and the heat from the air by cooling is 30.24 kJ/kg. Neglecting changes of potential and kinetic energy, determine the work on air in kW, BTU/min, and Hp.
Q4. Water is flowing in AF pipe (Figure 1) at a velocity of 2 m/s and a pressure of 102400 Pa, the pipe length is 100 m. If the water pressure needs to be at a pressure of 1.6 atm on a lower level. What should be the different in elevation between the upper and lower levels in order to achieve this pressure? Take the density of water 1000 kg/m and gravity is 9.81 m/s, consider the energy loss.
A 100-mm diameter jet of water is discharging from a nozzle into the air at a velocity of 36 m/s. the nozzle is inclined at an angle of 25 degrees with horizontal. neglecting air ressistance, determine: 1. the elevation of the highest point with respect to a datum at the tip of nozzle. 2. the area of the jet at the highest point of the stream.