A 2.20 g sample of pure glucose is burned in a bomb calorimeter that has a heat capacity of 8.910 kJ/°C. The temperature of the water jacket rises from 25.00 °C to 29.15 °C. i. What is AE for the combustion of 1 mole of glucose, CeH12Os? 1. How many dietary Calories per gram (Cal/g) does glucose provide when metabolized (1 kJ 4.184 Cal)

Q: . A furnace wall is of three layers, first layer of insulation brick of 12 cm thickness of conduct...

A: Given data: Furnace wall having three layers. Thickness of first layer of insulation=12 cm Conductiv...

Q: FIRST LAW OF THERMODYNAMICS Consider the following reaction in the vessel with a movable piston.X (g...

A: according to first law of thermodynamics ∆U=Q+Where ∆U is channge in total internal energy of the sy...

Q: Design a process to produce a NiO-60% MgO refractory with a structure that is 40% glassy phase at ro...

A: The phase diagram of the NiO-MgO is as follows:

Q: Q .2 (a) Consider an ideal binary distillation column shown in [Figure.3]. The system possesses six ...

A: Degree of freedom for a processing system is the number of independent variables which should be def...

Q: Response of a Ist order system to an impulse input is also a/an a. Impulse function b. Sinusoidal fu...

A: The correct option for the response of a 1st order system to an impulse input is to be chosen.

Q: Calculate the natural convection heat transfer coefficient for a vertical stainless pipe, 100 mm out...

A: Given, Diameter of pipe, D = 100 mm×1 m1000 mm    = 0.10 m temperature on outside surface of pipe, T...

Q: 1. The Fe2+ content of iron tablets was determined by titration with a freshly standardised solution...

A: Given mass of five iron tables is 0.325 g. Fe2+ solution is prepared from iron tablets to titrate wi...

Q: An undersaturated oil reservoir with a bulk volume of 1 x 10 bbl has an average porosity of 0.15 and...

A: (1) Volume of reservoir pore is defined as the product of bulk volume and porosity. Write the expres...

Q: Valculatethe molae concentration of Agteaq) don in a g.12 M Aplulion of Age g with ne excen cuberud ...

A: Given that, concentration of AgCl2- =0.212 M It will give 1 mol Ag+ and 2mol Cl- ions for each mole ...

Q: 1-advantages and disadvantages about filtration proccss?! 2 _Recommendations about filtration proces...

A: (1) Filtration is defined as a process of removing solids from a fluid containing contaminants by pa...

Q: Example of material balance of absorption?

A: An example of material balance of absorption is to be mentioned.

Q: The discipline dealing with material distribution between coexisting phases is called Select one: O ...

A:

Q: What will be the products when the following compounds are oxidized with K,Cr,O;/H*? 1. Propan-1-ol ...

A: In this oxidation primary alcohol oxidized into aldehyde while sec.alcohol oxidized into ketone by P...

Q: A heat pump is to be used to heat a house in winter and then reversed to cool the house in summer. T...

A: Given data: Interior temperature = 20 0C Heat transfer through walls and roof = 0.525 kJ/s per degre...

Q: Q1. Solute A is to be absorbed from a binary mixture containing 7.5% of A with solvent B in a packed...

A: Given data: Concentration of A in the feed = 7.5 % Total gas flow rate = 60 kmol/h Concentration of ...

Q: Q1. Solute A is to be absorbed from a binary mixture containing 7.5% of A with solvent B in a packed...

A:

Q: 1. The vapor pressure of pure water at 60 °C is 149 tor. The vapor pressure of water over a solution...

A: Raoult's law is applicable for ideal solution Raoult's is  PA=xAPAv             1here PA is partial ...

Q: The walls of the refrigerated storage room are 10 m long and 3 m high and constructed with 100 mm co...

A:

Q: The walls of the refrigerated storage room are 10 m long and 3 m high and constructed with 100 mm co...

A:

Q: Please solution

A:

Q: Three moles of N2(g) originally at 1 atm pressure, are mixed isothermally with 5 moles of H2(g), als...

A: If A gas having number of moles nA is mixed with B gas having number of moles nB. Assuming the gases...

Q: In the experimental demonstration of Bernoulli’s theorem using venturi, it took 175 seconds to colle...

A: Venturimeter is a device which is used to measure the rate of discharge (flow rate) in a pipeline. T...

Q: The gas, which contains 10% methane and 90% air by volume, enters a heater at a speed of 2000 L / mi...

A: Given data: The composition of methane = 10 % Composition of air in the gas mixture = 90 % The volum...

Q: The transfer function for a PID controller is (where, ti is the integral (reset) time and tD is the ...

A:  Controllers are used in a Feedback system. The four types of controller used in the Chemical indust...

Q: Que:- Give some examples of smart material actuators.

A: Smart material actuators examples are to be mentioned.

Q: A nigid vessel charged with lo kg Coz at 25°C and l4,7 bar a) Calculate the volume of the vessel as ...

A: Given data: We have a rigid vessel charged with 10kg at 25oC and 14.7bar pressure. We  are asked to ...

Q: Estimate the clean filter headloss for a proposed new sand filter using the sand. Use the following ...

A: Given data: Loading rate =216 m3/m2∙d Shape factor = 0.82 Porosity of bed= 0.45 Depth of sand = 0.5 ...

Q: 4. The output response of a temperature measuring system of a kiln in a Cement Plant is represent...

A: The response function of the process for an impulse input is to be determined. 

Q: If the composition of one phase is known, the composition of a second phase in equilibrium with the ...

A: In phase equilibrium, we can draw a tie line at constant temperature or constant pressure. Now apply...

Q: Is the heat treatment process (annealing, normalizing and hardening) an effect of changing the prope...

A: Yes,  heat treatment process (annealing, normalising and hardening) effects in changing the properti...

Q: Physical Chemistry: Show complete solution. Calculate the change in molar entropy of aluminum which ...

A:

Q: A pipe carrying steam at 230°C has an internal diameter of 12 cm and the pipe thickness is 7.5 mm....

A: Given data: Internal diameter of pipe=12cm Pipe thickness=7.5mm The conductivity of the pipe materia...

Q: Make a brief discussion on waste planning and waste managment in terms of waste hierarchy.

A: Waste planning is the pre incident planning to prepare the group to manage the waste effectively. In...