A 2-ft-diameter unfinished-concrete drain pipe has been designed to transport 90 ft³/s of water at a depth of 1.5 ft. Determine the Express you So 11 Submit

Q: Calculate the water flow through a Parshall flume with a throat width of 5 feet and a water level of…

A: Reference : Fluid mechanics, Types of Open flow channel. Parshall flume is a device or fixed…

Q: Q4: Determine the size of the intake structure with 1 unit using the following data: Discharge: 3.5…

A: given Intake structure with 1 unit-Discharge Q=3.5 m3/minminimum depth of water H=4 mLow water level…

Q: 8. Estimate the value of wetted area of a circular section in case of maximum

A: To find : Wetted area.

Q: Determine the minimum diameter in mm of a suitable horizontal drain with a maximum possible slope of…

A: Take mannings constant (n) = 0.011,  PVC pipe

Q: Compare the open channel with the pipe system for providing the required drainage

A: Compare the open channel with the pipe system for providing the required drainage

Q: 3. A river intake structure has two sets of intake ports with each port having a width that is 3x…

A:

Q: 6. Calculate the wetted perimeter of the most economical circular section having radius 3m in case…

A:

Q: A cast iron pipe must carry water at 20°C between 2 reservoirs with a discharge of 30 cfs a distance…

A: L = Length of the cast iron pipe = 1000 ft  Q = Discharge in the pipe = 30 ft3/s   H = Elevation…

Q: What diameter of a standard, sharp-edge orifice will be required to produce a discharge of 1.25 cfs…

A:

Q: A concrete sewer pipe has a cross-sectional area of flow of 0.11045 m2 and a flow velocity of 3.45…

A: Area of flow (A) = 0.11045 m2Flow velocity (V) = 3.45 m/s Determine the flow rate (Q).

Q: a triangular channel with most efficient section discharges water at the rate of 1.45 m3/s. Assuming…

A:

Q: Discuss water hammer and its effect in pipes. What are the major functions of surge tanks?

A:

Q: What diameter (to the nearest inch) of new cast-iron pipe 1 mile long is required to discharge 4.4…

A:

Q: A double-inlet grating's capacity To drain a paved apron area, a double-inlet grating similar to the…

A:

Q: Civil Engineering There is a 5 story building each floor consisting of 4 spaces. 2 of these spaces…

A:

Q: A secondary clarifier is being designed and the required area based on HLR is 14,000 square feet.…

A: Given data:- Required area based on the HLR is 14000 sqare feet Required area based on the SLR is…

Q: Determine the total sanitary sewer loading for the three pipes in the subdivision shown below. Also…

A: solve below calculationExplanation:Step 1: Step 2:Step 3: Step 4:

Q: Compute the hydraulic radius for a circular drain pipe running half full if its inside diameter is…

A:

Q: A sewer pipe of diameter 915 mm is to be laid on a slope of 0.027%, and the minimum flow rate…

A: Given data  Diameter  Mannings roughness coefficient  Slope Discharge  Unit weight

Q: 3. Calculate the depth in a most economical circular section in case of maximum discharge. a) 0.65D…

A:

Q: 8. Estimate the value of wetted area of a circular section in case of maximum discharge if the…

A: Estimate the value of wetted area of a circular section in case of maximum discharge if the radius…

Q: Given all Find the 4 ft wide Information above Flow 7f+ rate depth of upstream of gate 0.8f+ depth…

A:

Q: Calculate the sewer (n=0.02) diameter in (ft) required to carry a maximum discharge of 20 cfs when…

A: Discharge of sewer , Q = 20 cfs Slope of sewer, S = 0.002 Manning's constant, n= 0.02  y/d = 0.8…

Q: Q1: Design a storm water system for the building shown in Figure below, with rainfall intensity of…

A: Velocity or rainfall intensity) = 150mm/hr = 0.15m/hr

Q: A standard Schedule 40 steel pipe is to be selected to carry 10 gal/min of water with a velocity of…

A:

Q: What size pipe should be used to supply 1300 gpm so that the velocity does not exceed 3.0 ft/sec…

A:

Q: A rough brick circular sewer 72 inches in diameter with n =0.020 ,is to have a slope of 0.0009.…

A: Diameter of the circular sewer (D): 72 inchesManning's roughness coefficient (n): 0.020Slope of the…

Q: 8. Estimate the value of wetted area of a circular section in case of maximum discharge if the…

A:

Q: What is the laminar entrance length in a 4-cm diameter pipe if 2 x 105 m³/s of water is flowing at…

A:

Q: Sewer is running half full. When Manning's coefficient is increased from 0.011 to 0.022, the slope…

A:

Q: What are the different design characteristics that must be considered when designing water…

A:

Q: Water is flowing full in an 18-inch diameter pipe at a velocity of 8.55 ft/s. Find the discharge, Q,…

A:

Q: 3. Compute the flow rate in a gutter section with a design spread of 3 m and cross-slope of…

A:

Q: 3. A 30in dia. concrete storm sewer pipe must a carry a flow rate of 9cfs at a minimum velocity of…

A:

Q: Determine the minimum size (mm) of horizontal drainage pipe sloped at 2% that can accommodate the…

A: This question is related to the Building design and Construction from Civil Engineering.

Q: Parti : Compute the maximum flow rate (Qma) the pipe can discharge? - Select the diameter (D)…

A: For the maximum flow rate the section should be most economical.

Q: Determine the flowrate for the symmetrical channel shown in the figure if the bottom is smooth…

A:

Q: A contractor needs to make a rectangular drain consisting of three sides from a pice of aluminum…

A: Let  be the length                                                 the width of the aluminium…

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?