What size septic tank will you recommend for a 2-bedroom house? If the AR for the house is determined to be 0.4 gal/ft2 /day, what size drainfield should be designed? Show the layout for the drainfield if the trench width is 5 feet and the maximum length is 100 ft. Space the laterals 6 feet from each other on the center. How does your layout change if the drainfield area is determined from the figure based on a perc rate of 30 minutes/inch?

What size septic tank will you recommend for a 2-bedroom house? If the AR for the house is determined to be 0.4 gal/ft2 /day, what size drainfield should be designed? Show the layout for the drainfield if the trench width is 5 feet and the maximum length is 100 ft. Space the laterals 6 feet from each other on the center. How does your layout change if the drainfield area is determined from the figure based on a perc rate of 30 minutes/inch?

Solid Waste Engineering

3rd Edition

ISBN:9781305635203

Author:Worrell, William A.

Publisher:Worrell, William A.

Chapter8: Landfills

Section: Chapter Questions

Problem 8.9P

See similar textbooks

Similar questions

How to conduct an analysis of a water discharge?
Using the Manning nomograph determine the following: a. An 800 mm diameter sanitary sewer is built on a slope of 0.2 percent. What is the full-flow discharge capacity of the sewer and what is the flow velocity? b. What diameter pipe is needed to carry a peak flow of 200 liters/s on a grade of 0.007 ? c. The discharge for a 200 mm inside diameter common clay drainage tile running half full if it is laid on a slope that drops 1 m over a run of 1000 m . Assume n=0.01 .
An averaged vitrified sewer pipe (n = 0.015) is laid on a slope of 0.0002 and is to carry 2.36 m3/s when the pipe flows 0.9 full. What size pipe should be used? only HANDWRITTEN answer needed ( NOT TYPED)
What is Unit Hydrograph? Discuss Unit Hydrograph method of estimating maximum Probable Discharge.
QUESTION 1: Answer the following questions. Draw sketches where needed. a) Explain the functions of manholes in sewage systems. b) What types of sewage systems are used? Explain. c) Explain the runoff coefficient. d) Explain the inlet time, flow time and concentration time in storm water systems. e) Determine the hydrographs when the flow time is 5 minutes and rainfall durations are 3, 5, and 7 minutes respectively. Discuss. QUESTION 2: The layout of the storm water collection system is given below with areas that served by each channel, run-off coefficients, inlet times for starting manholes and flow times for channels. Determine the discharges of all channels for the design rainfall of n=2 and T=15min. (Rainfall yield r= lab I/s.ha is for the rainfall of n=1 and T=15 min.) t; =15min (4) A=4,a ha. A=2,b ha. A=3,a ha. A=1,b ha. C=0.45 t; =5min t=10min C=0.60 C=0.75 C=0.60 (1) t;=6min (2) t=4min (3) tę =3min (5) A=2,b ha C=0.50 te =3min
Discuss Unit Hydrograph method of estimating maximum Probable Discharge.
2. Draw HGL (Hydraulic Grade Line) and EL (Energy Line) for the given situation. It can be NTS (Not to Scale); you do not need to calculate the magnitude of losses.
If a 250 mm sewer is placed on a slope of 0.010, what is the flowing full capacity when n = 0.013 in cu.m/sec?
NEED ASAP There is a 1350 mm diameter sanitary sewer pipe with roughness coefficient of n = 0.022 and slope of 0.67%. Answer the following questions if the depth of the flow in this pipe is 659 mm: 17. How much is the capacity flow (Qc) of the proposed sanitary pipe? TIP: You may use Table No. 1 to help for calculation of the Qc. 18. How much is the velocity of the capacity flow (Vc) in the proposed sanitary pipe? 19. How much is the actual sanitary flow (Qa) of the project area? 20. How much is the velocity of the actual flow (Va) in the proposed sanitary pipe?
Using the Manning nomograph and assuming n=0.013, determine the following: (a) An 800 mm diameter sanitary sewer is built on a slope of 0.2 percent. What is the fullflow discharge capacity of the sewer and what is the flow velocity? (b) What diameter pipe is needed to carry a peak flow of 200 liters/s on a grade of 0.007 ? (c) A 300 mm diameter sewer is built at a grade of 2 percent. What is the depth of sewage flowing in the pipe when it carries a flow of 50 liters/s? What is the velocity? USE MANNING MONOGRAPH, NOT HAZEN WILLIAMS
Using the Manning nomograph and assuming n=0.013, determine the following: (a) An 800 mm diameter sanitary sewer is built on a slope of 0.2 percent. What is the fullflow discharge capacity of the sewer and what is the flow velocity? (b) What diameter pipe is needed to carry a peak flow of 200 liters/s on a grade of 0.007 ? (c) A 300 mm diameter sewer is built at a grade of 2 percent. What is the depth of sewage flowing in the pipe when it carries a flow of 50 liters/s? What is the velocity?
Determine the following:What is Rainfall-Run off Relation?Definition of HydrographWhat is a Hydrograph Separation?What is a Unit Hydrograph?Estimation of Discharge using HydrographWhat is Rational Formula and SCS Curve?Please type it in here instead of writing it on a piece of paper