A 12m long post is bolted to the wall on its left end. It's right end is held horizontal by a wire that is attached to the wall, making a 35° angle with the post. If the post is 13kg what is the tension in the wire?

A 12m long post is bolted to the wall on its left end. It's right end is held horizontal by a wire that is attached to the wall, making a 35° angle with the post. If the post is 13kg what is the tension in the wire?

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter14: Static Equilibrium, Elasticity, And Fracture

Section: Chapter Questions

Problem 64PQ: A One end of a metal rod of weight Fg and length L presses against a corner between a wall and the...

See similar textbooks

Related questions

Q: Determine the tension at the cable TAB and TAC in the system below at equilibrium. 3 m C 4 m A 4.5…

Q: steel I-beam in the drawing has a weight of 8.00 kN and is being lifted at a constant What is the…

Q: A uniform plank of length 2.00 m and mass 30.0 kg is supported by three ropes as indicated by the…

Q: In the figure below, the horizontal boom is uniform and has the same weight as the hanging weight at…

Q: An 800-N billboard worker stands on a 4.0-m scaffold weighing 500 N and supported by vertical ropes…

Q: A board sits in equilibrium. On the left end, there is a wire that supports the board from the…

Q: The following setup of masses is hung (las) to a fixed ceiling as shown in the figure below. If M, =…

A: Here, a figure is given, showing a setup of masses hung from the ceiling. It is also given that M1…

Q: A sculptor has hung up a 45.0 kg horizontal rod of length 4.85 m . One end of the rod is supported…

A: Given,

Q: What is the weight (N) of a cube of stainless steel with 8 cm on each edge?

A: The weight of a cube is, W=ρVgW=ρa3g

Q: A2 m long horizontal uniform beam of mass 16 kg is supported by a wire as shown in the figure. The…

A: Given, Length of beam l = 2 m Mass of beam is mbeam = 16 Kg Angle θ=29∘ Distance where mass attach x…

Q: A uniform horizontal beam with a length of 8 m and a weight of 200 N is attached to a wall by a pin…

Q: A 12m long post is bolted to the wall on its left end. It's right end is held horizontal by a wire…

A: GivenLength of post L = 12 mMass of post m = 13 kgAngle Ѳ =35

Q: When the structure shown below is supported at point P, it is in equilibrium. Find the magnitude of…

A: Given, The system is in equilibrium about Point P.

Q: A homogeneous, 10 m-long beam has a total weight of 80N and is divided to 10 equal segments. Object…

A: Given:- A homogeneous, 10 m-long beam has a total weight of 80 N and is divided into 10 equal…

Q: If each cable can withstand a maximum tension of 1000 N, determine the largest mass o the cylinder…

A: Coordinates of point A (0,0,0) , B(-1,1.5,3), C(-1,-2,2) and D(3,-4,0) , from fig-1 Hence AB =…

Q: Look at the figure below. The horizontal beam weighs 200N, Find the tension in the cable if the…

Q: The boom in the figure is 2m long and weighs 100 N. If the 800N load is suspended 50cm from the end,…

Q: Consider the position of the human head and neck shown below, in static equilibrium: FM FJ FM: The…

A: Here position of all the forces are given We are going to calculate the components of all the…

Q: A 10-m long homogenous beam with a weight of 50N is divided into 10 equal parts (1 m each) as shown…

Q: Cable 1 40 N Cable 2 1 m A uniform 50 N beam that is 10 m long is suspended horizontally by two…

Q: 5.00 m 3.00 m 4.00 m 300 N 6. The horizontal beam in the figure weighs 150 N, and its center of…

A: Net torque on the beam about hinge is zero. Mg×4 + mg×2 = T( Sin37) × 4 Given Mg = 300 N mg = 150 N…

Q: A uniform horizontal beam with a length of 8 m and a weight of 200 N is attached to a wall by a pin…

Q: Look at the figure below. The horizontal beam weighs 200N, Find the tension in the cable if the…

Q: find the centre of gravity of T-section with top flange 100 mm x 20 mm and web 200 mm x 30 mm and…

Q: The system in the figure is in equilibrium. A concrete block of mass 325 kg hangs from the end of…

Q: 600 mm C. 3 kN 2 kN 350 mm 350 mm

Q: A D B A uniform thin shelf AB of length 2m and weight 100N is hinged to the wall at a and is…

Q: Cable 1 40 N Cable 2 1 m A uniform 50 N beam that is 10 m long is suspended horizontally by two…

Q: When the structure shown below is supported at point P, it is in equilibrium. Find the magnitude of…

A: Draw the free-body diagram of the system.

Q: The system in the figure is in equilibrium. A concrete block of mass 327 kg hangs from the end of…

Q: 300 kN 50 kN 180 kN 90 kN 60°

Q: The system in the figure is in equilibrium. A concrete block of mass 333 kg hangs from the end of…

Q: A uniform horizontal beam 10.0 m long and a mass of 82 kg is attached to support cables on either…

Q: 53° 5 m A uniform 80N beam that is 5 m long is attached to a wall by a cable as shown in the figure.…

Q: The Howe roof truss shown carries the given loads. The wind loads are perpendicular to the inclined…

Q: How do you do this? A hungry bear weighing 700 N walks out on a beam in an attempt to retrieve a…

Q: Two painters are carrying a uniform horizontal ladder that is 12 feet long and weighs 200 N. If one…

Q: A uniform meter stick is supported at the 50 cm mark . A 25 N weight is placed at the 10 cm mark.…

A: Given data: Meter stick supported at 50 cm mark Force (F1) = 25 N at 10 cm mark Force (F2) = 200 N…

Q: 1. The horizontal beam AB shown has a mass of 2.04 kg with center of gravity at its center. Find: A…

A: Consider the known data as below. Mass at the middle of the beam, m=2.04 kg Gravity, g=9.81 ms2…

Q: QUESTION 2 A uniform plank of length 2.00 m and mass 30.0 kg is supported by three ropes as…

Q: Find the smallest and largest value of P to maintain equilibrium when the weight of the rectangular…

Q: The truss structure in a Figure Q4a is supported at A and B and has three forces acting vertically…

Q: A uniform bridge span weighs 50.0x 10° N and is 40.0 m long. An automobile weighing 15.0 x10° N is…

Q: The horizontal beam weighs 150 and its center of gravity is its center. Find the tension in the…

A: Given: The weight of the horizontal beam is 150 N. The weight of the load is 300 N. The free-body…

Q: A uniform plank of length 2.00 m and mass 31.5 kg is supported by three ropes, as indicated by the…

A: Given that: Length of plank, L=2.00 mMass of plank, M=31.5 kgWeight of person, W=715 NDistance from…

Concept explainers

Rotational Equilibrium And Rotational Dynamics

In physics, the state of balance between the forces and the dynamics of motion is called the equilibrium state. The balance between various forces acting on a system in a rotational motion is called rotational equilibrium or rotational dynamics.

Equilibrium of Forces

The tension created on one body during push or pull is known as force.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A One end of a metal rod of weight Fg and length L presses against a corner between a wall and the floor (Fig. P14.64). A rope is attached to the other end of the rod. Find the magnitude of the tension in the rope if the angle between the rod and the rope is 90.
A 20.0-kg horizontal plank 4.00 in long rests on two supports, one at the left end and a second 1.00 m from the right end. What is the magnitude of the force exerted on the plank by the support near the right end? (a) 32.0 N (b) 45.2 N (c) 112 N (d) 131 N (e) 98.2 N
The board sandwiched between two other boards in Figure P4.91 weighs 95.5 N. If the coefficient of friction between the boards is 0.663, what must be the magnitude of the compression forces (assumed to be horizontal) acting on both sides of the center board to keep it from slipping? Figure P4.91
A 12m long post is bolted to the wall on its left end. It's right end is held horizontal by a wire that is attached to the wall, making a 35 degree angle with the post. If the post is 13 kg, what is the tension in the wire?
A 5 kg beam 2 meters long is used to support a 10 kg sign by means of a cable attached to a building. The signs hangs from the end of the 2 m long beam, and the cable makes a 40 degree angle with the beam. What is the tension in the cable?
A 10 m uniform rope of 100 N is supported at two ends. A person (400 N) sits 2 m from the left side. What is the tension on the right side?
A 12-kg, 1.0-m-long uniform beam is attached to a wall by a cable. The beam is free to pivot at the point where it attaches to the wall. However, it remains motionless. What is the magnitude of the tension force in the cable?
You are pressing a 3.0 kg cubic wooden block into a corner between a wall and the floor. Your arms make a 20°20° angle with the floor. The block is in static equilibrium. If the floor exerts a 60 N force on the block, what force does the wall exert on the block?
A 200 N sign hangs from the middle of a cable between two buildings. The ends of each cable are attached to each building at the same height. The cable cannot exceed 1500 N without breaking. Find the minimum angle that the cable can make from the horizontal.
A 24 kg rectangular 4.00 m x 3.00 m rectangular sign is suspended from a horizontal 6.00 m long rod with a 5 kg mass as indicated in the figure. The left end of the rod is supported by a hinge, and the right end is supported by a thin cable making a 30.0° angle with the vertical. Draw a free body diagram and calculate the tension T in the cable. The thin cable breaks if it is pulled by more than 200 N. Show than in the present situation the cable can not support the sign without breaking. Show the cable is able to support the load if it is attached higher up such that it makes an angle of 20.0° angle S0.0 CE CREAM SHOP with the vertical.
an object weighing 2.4 kilograms is suspended by two cables attached to its upper corners. the two cables make the same angle with the vertical. the tension in each cable is equal to 65% of the weight of the object. ignore the weight of the cables.
A 20 kg traffic light hangs midway on a cable between two poles 40 meters apart. If the sag in the cable is 0.40 meters, what is the tension in each side of the cable?