Cable 1 40 N Cable 2 1 m A uniform 50 N beam that is 10 m long is suspended horizontally by two vertical wires at its ends and the system is in equilibrium. A small but dense 40 N weight is placed on the beam 6 m from Cable 1, as shown in the figure. What is the tension in Cable 1? (Each unit on the beam is equal to 1m) 49N 10N 9ON

The diagram shows a uniform 30 cm strut weighing 5 N supporting a 10 N weight 10 cm from the pivot. Find the tension in the cable attached to the wall. 10 cm 10 N 30°

A 350.0 N, uniform, 1.50 m bar is suspended horizontally by two vertical cables at each end. Cable A can support a maximum tension of 500.0 N without breaking, and cable B can support up to 350.0 N. You want to place a small weight on this bar. For related problem-solving tips and strategies, you may want to view a Video Tutor Solution of Locating your center of gravity while you work out. What is the heaviest weight you can put on without breaking either cable? Express your answer with the appropriate units. W = Submit 0 Part B I 550 μA Previous Answers Request Answer N X Incorrect; Try Again; 9 attempts remaining d= 0.614 Where should you put this weight? Express your answer with the appropriate units. μA m ? Submit Previous Answers Request Answer ? X Incorrect; Try Again; 9 attempts remaining from the cable A

5.00 m 4.00 m F End A of the bar AB rests on a frictionless horizontal surface, and end B is hinged. A The weight of the bar is 200 N. horizontal force F of magnitude 200 N is exerted on end What is the magnitude of the force exerted on the bar by the hinge at point B? 156 N 248 N 261 N 284 N B.

A 7-m long beam of negligible mass is hanged horizontally and is supported at each end by vertical cables. The tension in the left cable is 300 N, and that in the right cable is 400 N. How far is the person sitting from the left cable?

no ai please

One end of a uniform rod of weight w = 74.0 N and length L = 2.85 m is supported by a cable at an angle of 0 = 34.0° above the rod. The other end rests on a small frictionless support and presses into a wall as shown in the figure. -Support -L- Determine the magnitude n of the vertical normal force exerted by the support on the rod and find the magnitude T of the tension in the cable. n = T =

In the figure, a uniform beam of weight 440 N and length 2.3 m is suspended horizontally. On the left it is hinged to a wall; on the right it is supported by a cable bolted to the wall at distance D above the beam. The least tension that will snap the cable is 1100 N. What value of D corresponds to that tension? Cable Вeam Number i Units

A beam held by a hinge, take 2. The left end of a beam of mass 17.9 kg is fixed to a wall by a hinge. The beam is inclined at 19.8 degrees from the horizontal; it is supported at its right end by a rope forming an angle of 30.3 kg with the horizontal.create a model for the orientation of the hinge force, relative to the x+ axis.

A 40.0kg uniform platform is suspended by two cables, 2.00m apart, where the centre of the platform lies midway between the cables. A 5.00kg paint bucket is placed on the platform, 24.0cm to the right of the right cable. Determine the tension in each cable.