9. A small bead of mass m slides without friction along a semi-circular wire of radius 10.0 cm that rotates about a vertical axis at a rate of 2.0 revolutions per second. (a) Determine the angle 0 for which the bead will remain stationary relative to the rotating wire? (b) Is it possible for e=90°. Explain.

9. A small bead of mass m slides without friction along a semi-circular wire of radius 10.0 cm that rotates about a vertical axis at a rate of 2.0 revolutions per second. (a) Determine the angle 0 for which the bead will remain stationary relative to the rotating wire? (b) Is it possible for e=90°. Explain.

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter2: One Dimensional Motion

Section: Chapter Questions

Problem 46PQ: In Example 2.6, we considered a simple model for a rocket launched from the surface of the Earth. A...

See similar textbooks

Similar questions

Keratinocytes are the most common cells in the skins outer layer. As these approximately circular cells migrate across a wound during the healing process, they roll in a way that reduces the frictional forces impeding their motion. (a) Given a cell body diameter of 1.00 105 m (10 m), what minimum angular speed would be required to produce the observed linear speed of 1.67 107 m/s (10 m/min)? (b) How many complete revolutions would be required for the cell to roll a distance of 5.00 103 m? (Because of slipping as the cells roll, averages of observed angular speeds and the number of complete revolutions are about three times these minimum values.)
Certain neutron stars (extremely dense stars) are believed to be rotating at about 3.5 rev/s. If such a star has a radius of 23527 km. For the material on this neutron star's surface to remain in place during the rapid rotation, its minimum mass should be ?answer in kg
A sled with a mass of 25.0 kg rests on a horizontal sheet of essentially frictionless ice. It is attached by a 5.00-m rope to a post set in the ice. Once given a push, the sled revolves uniformly in a circle around the post as shown in the figure. If the sled makes five complete revolutions every 60 s, find the force Fexerted on it by the rope. O 20.5 N O 30.5 N O 15.5 N O there is no answer O 34.3 N Activate Windows Go to Settings to activate Windows 04:42e O 4) G ENG
Two equal 16.5 kg masses are at the ends of a 4.6 kg 60.5 cm rod that is initially spinning about the rods center at 55.7 rev./sec. suddenly the rods length is increased to 92.3 cm. How fast is the rod (& masses) spinning now? Neglect any frictional interactions in the axle. Enter in your in rev./sec.
A pulley (in the form of a uniform disk) with mass Mp and radius Rp is attached to the ceiling in a uniform gravitational field g and rotates with no friction about its pivot. Mass M2 is larger than mass mı, and they are connected by a massless inextensible cord. T1, T2, and Ts are magnitudes of the tensions. What is the relationship between the ten- sion T and mi g? T3 R 1. T¡ m1 9 ANS = OPTION 4 NEED SOLUTION
Current Attempt in Progress Three dimensions. Three point particles are fixed in place in an xyz coordinate system. Particle A, at the origin, has mass ma. Particle B, at xyz coordinates (2.00d, 2.00d, 2.00d), has mass 4.00ma, and particle C, at coordinates (-3.00d, 2.00d, -3.00d), has mass 4.00mA. A fourth particle D, with mass 3.00ma, is to be placed near the other particles. If distance d = 4.20 m, at what (a) x, (b) y, and (c) z coordinate should D be placed so that the net gravitational force on A from B, C, and D is zero? %3D (a) Number i Units (b) Number Units (c) Number Units > >
A block is hung by a string from the inside roof of a van. When the van goes straight ahead at a speed of 18.4 m/s, the block hangs vertically down. But when the van maintains this same speed around an unbanked curve (radius = 97.0 m), the block swings toward the outside of the curve. Then the string makes an angle 8 with the vertical. Find 0. Number i Units To center of curve
A 200 g box is tied to the end of a cord and whirled in a horizontal circle of radius 1.20 m at a constant 11 rev/s. Assume that the chord is horizontal, meaning you can that you can neglect gravity. Determine the tension in the chord.
7. Consider the systems of masses M, and MB connected with a string through a pulley as the one illustrated. Mass MA slides up over the surface of an inclined plane. Find the acceleration of the blocks for mass MB= 10.0 kg and mass MA= 2.5 kg., 0= 30°, and u = 0.30.
3. The member OA rotates in vertical plane about a horizontal axis through O with a constant counter clockwise velocity w=3 rad/s. As it passes the position 0=0, a small mass m is placed upon it at a radial distance r=0.5 m. If the mass is observed to slip at 0=37°, find the coefficient of friction between the mass and the member. Answer: uk = 0.1875 Solution Ө
0.190 m) that 7. A penny is placed at the outer edge of a disk (radius rotates about an axis perpendicular to the plane of the disk at its center. The period of the rotation is 1.85 s. Find the minimum coefficient of friction necessary to allow the penny to rotate along with the disk. =
A rod 2m long rotates in a horizontal plane about a vertical axis through its center. At each of the rod is fastened a cord 1.200m long. Each cord supports a bob of weight W. Find the speed of rotation n (in rpm) to incline each cord at 32o with the vertical. the answer must be 3 decimal places