9) Solve the nodes and order the matrix of the following way: [AB] What is the value of A and B? Response format: a complex number in rectangular format

Q: Problem 1 A 3-phase, star-connected alternator generates 6,360 V per phase and supplies 500 kW at a…

A:

Q: electrolysis, there are 2 tanks connected in series where the current that flows is 5000 A. Each…

A:

Q: Consider the transmission line circuit shown in the accompanying figure. Compute the incident power,…

A: Transmission line is transfer the electricity from one place to another place. it is a long…

Q: Two 100-kW, single-phase transformers are connected in parallel both on the primary and secondary.…

A:

Q: 15 The unit of current is: (a) coulomb (c) volt (b) ampere (d) joule

A:

Q: Q2: Answer A or B A: Simplify the block diagram shown below and obtain the closed-loop transfer…

A:

Q: a) An MOS capacitor has a p-type silicon semiconductor substrate doped with an impurity…

A: It is given that:  A MOS capacitor has a p-type silicon semiconductor substrate doped with an…

Q: 5) What is IC,max(open), the current that flows through the capacitor whose magnitude is maximum…

A:

Q: An incandescent bulb is connected to 220-V (rms) AC source. To obtain the same brightness, the bulb…

A: We need to select correct option for given statement

Q: A wired baseband digital communications system uses a 100 metres long cable to connect the…

A: Distributed resistance = 1ohm/m Distributed capacitance =100pF/m Frequency response equivalent…

Q: (b) Find V across the load in the AC circuit given in Figure 4.1 (assume that both AC sources have…

A:

Q: Communication . Draw the Split-Phase Manchester code for the following binary data: (1001010110)

A:

Q: For the JFET amplifier circuit of Fig. '. determine the lower- and higher-cutoff frequencies and…

A:

Q: design a controlled  single phase rectifier

A: Controlled single phase rectifier.

Q: 1370 A resistor R and an inductor L are connected in series with a seat of constant e.m.f., E. 1101…

A: Given  An RL series circuit.we need to determine the RMS current and power.(avg rate of energy is…

Q: Sketch vo for the network and determine the dc voltage available. 100 V Si Ge 4.7 ΚΩ • 2.2 ΚΩ 2.2 ΚΩ…

A: Brief description: For the given question we need to calculate dc voltage and output voltage…

Q: A series-connected circuit has R = 4 22 and L = 25 mH. (a) Calculate the value of C that will…

A:

Q: Q4) Channel 1 of a two-channel system handles (0-3) kHz signals; the second channel handles (0-5)…

A:

Q: Q3 The approximate far zone normalized electric field radiated by a resonant linear dipole antenna…

A: Given: The approximate far zone normalized electric field radiated by a resonant linear dipole…

Q: A 3 phase, 50 Hz, 434-V, supply is connected to a, Y-connected induction motor and synchronous…

A: Assume synchronous motor is Y connected As I2=120∠cos-10.87I1=VphZVph=VL3=4343Vph=250…

Q: Let x(t) = 5 cos (50t+ sin 5t). Its instantaneous frequency (in rad/sec) at t=0 has the value? (a) 5…

A: Given signal equation, xt=5 cos50t+sin 5t

Q: Two transformers are required for a Scott connection operating from a 440-V, 3-phase supply for…

A: Given: The primary voltage is 440 V The secondary voltage is 200 V The output is 150 kVA

Q: Find the impedance at w = 1 Mrad/sec of: a) a 2 kΩ resistor in parallel with a 1 mH inductor; b) the…

A:

Q: A JFET data sheet specifies VGS(off) = –6 V and IDSS = 8 mA. The value of ID when VGS = –3 V is…

A: Brief description: In the above given question they want to know the saturation current for the…

Q: A four wire, three phase system has a balanced supply voltage of 208V. Three wattmeters are…

A:

Q: 1.5 V + R₁ Μ 56 Ω - R2 100 Ω R4 Μ 22 Ω Ω R3 100 Ω

A:

Q: Find DFT coefficients of x[n] = [1 2 3 4]. b) is in radian). Plot amplitude and phase spectrum of…

A: Given sequence is :        x[n]=[1 2 3 4]

Q: 15 The voltage 2,000,000 V can be expressed in powers of 10 as: (a) 2 mV (b) 2 kV (c) 2 MV (d) 2 GV

A:

Q: 1. From the given circuit, take V₁ = 240, ZL = currents. Determine also the total complex power from…

A: Given  A delta -Delta connected circuit.we need to determine the line and phase currents and the…

Q: Subject Digital Logic Design(DLD) Design the truth table for Full Subtractor Circuit. Write the…

A: We need to design the Full substractor .

Q: What is the current in the 12- 2 resistor when a potential difference of 100 V is applied to the…

A: We need to find out the voltage across 12 ohms resistor for given circuit

Q: Find the complex exponential Fourier series coefficients of the signal below x(t) = 1 + 2[*Cos(²kt)…

A:

Q: Q4) Find an orthogonal set from the following set of signals by utilizing Gran-Schmidt…

A: Given  A series of signals and we need to find the orthogonal set using  Gram- Schmitt…

Q: Mass of an electron?

A: The mass of an electron has been obtained in the following section.

Q: 2. The Illogic Company has developed a new logic family which has the following characteristics: VOH…

A: A group of logic circuits built with power supply and compatible logic levels known as a Logic…

Q: Determine Zin, Zo and the small-signal voltage gain. p type C₁ C₂ Vo D Vin Zin Rs 4k RD 2k VI -5V Zo…

A:

Q: Find the Thevenin's equivalent voltage and resistance across R₂ of a linear close circuit having 10…

A:

Q: Determine β (DC) for a transistor where Ib = 75 μA and Ic = 4 mA

A:

Q: 2. How many poles does a synchronous motor have if it operates at 200 rpm when connected to a…

A:

Q: reluctance of 10 cm diameter silicon steel

A: NOTE_ “Since you have asked multiple questions, we will solve the first question for you. If you…

Q: Two 1-phase furnaces a and b are supplied at 80V by means of a Scott-connected transformer…

A: Secondary voltage V2=80VPrimary main voltage V1=6600 VTransformation ratio K=V2V1=806600Let furnace…

Q: The total voltage and amperage of four 0.5-A, 1.5-V cells connected in series are 5 V, 0.5 A O 6V,…

A: series connection of cells is given as

Q: QUESTION ONE A 50 HP motor is required for a certain drive and there are two motors available •…

A: Based on the given data we try to find out the best motor.

Q: A modulating signal f(t) is bandlimited to 5 kHz is sampled at a rate of 15000 samples/ sec. The…

A:

Q: Q4/ The power radiated by a lossless antenna is 10 watts. The directional characteristics of the…

A: Since you have asked multiple questions with multiple sub-parts, we will solve the first question…

Q: Write the appropriate term for the following questions A clipper or limiter circuit consists of a…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Reduce the block diagram shown below to find the transfer function C(s) / R(s). R(s) C(s) G₁(s)…

A:

Q: If an FM wave is represented by the equation e=10sin (9×10³t+4sin 1500r), then what is the carrier…

A: Given FM signal equation, e=10 sin 9×108t+4 sin 1500t

Q: n parallel circuit, the voltage across each branch is the source voltage. equal to Olesser than O…

A:

Q: For the ideal op-amp shown, what should be the value of resistor Rf (in kilo Ohms) to obtain a gain…

A: