8.* A single phase bridge rectifier supplies a 1kW washing machine induction motor drive. The smoothing capacitance is 6.8 mF and the smoothing inductance is 5 mH. At full load, the equivalent resistance of the induction motor is 24 2. The ac supply is 220 V (60Hz). (a) (b) (c) Estimate the ripple What is the capacitor 'de link' voltage under full load? What is the % voltage regulation no load to full load?

8.* A single phase bridge rectifier supplies a 1kW washing machine induction motor drive. The smoothing capacitance is 6.8 mF and the smoothing inductance is 5 mH. At full load, the equivalent resistance of the induction motor is 24 2. The ac supply is 220 V (60Hz). (a) (b) (c) Estimate the ripple What is the capacitor 'de link' voltage under full load? What is the % voltage regulation no load to full load?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Q5. For the following center tapped transformer, show the waveform across each half of the secondary winding and across Ri, when a 100 V peak sine wave is applied to the primarywinding. What is the PIV rating must the diode have? (Use constant voltage drop model for the Silicon diode) IN4001 Ry OV 10k) D IN4001
A load consists of XL=70 and XC=150 are connected in parallel across 120 Volt supply.The reactive power of the circuit is.......
a. A 80 V rms is stepped down to 18V rms by a transformer. The output from the transformer is rectified using a half wave rectifier circuit and connected to a 47.5 2 load resistor. Draw a circuit diagram of this arrangement and the waveform at each stage.
A three phase full wave rectifier is shown below along with the peak input phase voltage Vm=169.7V. The load is purely resistive. The rectifier delivers Ipc = 100 A and the source frequency is 60 Hz. The DC output voltage is Vpc=280.7V and. The RMS transformer secondary current is equal to 81.72A, the output RMS voltage is equal to VRMS=280.93V and the output resistance is equal to 2.8070. The TUF would be equal to: Secondary a平a字a辛 R 太D。太D。太D. Select one: 0.875 Ob. 0.955 O C. 0.551 O d. 0.432 Compared with power transistors, thyristors have the following characteristic
1. Single phase half-wave converter has a purely resistive load of R and delay angle is a= n/2 determine: (a) Rectification efficiency (b) Form factor (c) Ripple factor.
A three phase half-wave controller rectifier is connected to a highly inductive load. Show the operational sequence for each thyristor, at a firing delay angle of 135° and plot the load voltage waveform. (Note: the waveform should be plotted on 3-phase waveform template)
Derive the average and rms values of output voltages and currents for three phase semi converter. Power Electronics
iii. For fully controlled single phase bridge rectifier with inductive load (load current is continuous) ,supply voltage 220 V(RMS) and a=30° .The mean value of output voltage is : (a) 150.32V (b) 171.52V (c) 120.98V
Which of the following statements about bridge tip rectifiers is false? A) If the 1-phase type has source inductance, the average value of the output voltage is lower than in the absence of the inductance. B) The average output voltage value of the 1-phase type is 0.9 times the peak voltage of the network. C) none D) There are only odd harmonics in the current drawn by the 1-phase type from the mains. E) The average value of the output voltage of the 3-phase type is larger as the 3-phase and 1-phase types are compared
4- Single phase centre-tape rectifier with 100V peak secondary voltage per coil, energizing 10 Ohms and 2mH inductance with 50Hz source. The output rectified voltage drops to ...of the Vdc. *
In a rectifier circuit , DC output voltage and RMS output voltage is 0.3 V & 0.6 V respectively. The form factor of this circuit is ___________________.
(b) A three-phase uncontrolled bridge rectifier is connected to an AC supply of 415V through a delta-star transformer as shown in the Figure. The load consists of large inductance to render a level load current of 60A at 300V. Assuming voltage drop across the power device to be 0.7V, compute the following: i) Rms value of secondary phase voltage and current; ii) Rms value of primary phase voltage and current3; iii) Transformer power rating in kVA and transformation ratio; iv) Device ratings. 本の。本の本の Load 本の。本。本の。 Figure