7. Calculate the equivalent resistance of the circuit shown below- R, 50 2 50 2 R. R. 100 2 R, son 8. If the Power Source = 120 volts, what is the measured voltage across. (The symbol on the second resistor I ask about is very hard to read, it is the bottom of the parallel branch, the only 100 ohm resistor). R1 (502) = Rp (1002)=

7. Calculate the equivalent resistance of the circuit shown below- R, 50 2 50 2 R. R. 100 2 R, son 8. If the Power Source = 120 volts, what is the measured voltage across. (The symbol on the second resistor I ask about is very hard to read, it is the bottom of the parallel branch, the only 100 ohm resistor). R1 (502) = Rp (1002)=

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

1. Calculate the voltage across R1. 2. Calculate the current across R2. 3. Calculate the total resistance of the circuit.
A. Determine the equivalent resistance fir the circuit.keep vaules in ohms B. Determine hiw much current the battery produces. keep vaules in amps C. Determine the voltage across R12 and R3; call these values V12 and V3, keep the vaules in volts. then usr ohms law: V=i r, to fkmd the current across R12 and R3; call tjese 12 and 13, keep these vaules in amps. D. use ohms law to caculare the voltages across R1 and R2; call these vaules V1 and V2, keep results in volts. Requivatont,scris= Sihi=R1 tket . kequivaknt, papli=Zi Ri =RI K You circuit are given the following below. combination Z Rz R3 where V is a 12 V battery; R1 is 330ohms R2 is 180 ohms R3 is 270 ohms please write all work legaie thanks :)
A. What is the total resistance of the circuit in the figure?(Round off to two decimal places.) B. If E = 40 V, what is the voltage across R1?
a. Using the characteristics of the first figure, determine ID and VD for the circuit of the second figureb. Repeat part (a) with R = 0.57 kilo-ohms.c. Repeat part (a) with R = 0.78 kilo-ohm.d. Is the level of VD relatively close to 0.7 V in each case?
3. Find the readings of the ammeter and voltmeter in the circuits in Figure 3. The resistance of the voltmeter is Ry = 1 200 Q, the voltage at the battery is U = 80 V, the resistances R1= 300 Q and R2 = 480 N. Disregard the resistance of the battery and the ammeter. R1 Figure 3.
ANSWER ONLY NUMBER 4 3. A voltage of one volt applied across a resistance of one ohm produces a current of oneampere. What happens to the current if the voltage is doubled and the resistance ishalve? a. It doubles.b. It increases four times.c. It increases three times.d. It remains the same. 4. In Question 3, what is the current in amperes if the voltage is halved and the resistance is doubled?a. 1 ampereb. 0.33 amperec. 0.5 ampered. 0.25 ampere
23. Answer the following questions about total resistance in series and parallel circuits. a. What is the total resistance of a 30 2 resistor and a 10 2 resistor in series? b. What is the total resistance of a 30 resistor and a 102 resistor in parallel? R=(1/R+1/R+..^-1 MacBook Pr
1. Two resistors with Ri = 1500 Ohms and R2= 3500 Ohms are connected in parallel and connected in series with a 12.0 volts supply. a .Draw the circuit diagram for the given electrical components. b. Determine the equivalent resistance. c. What is the current through each of the resistors?
6. In the circuit shown to the right l = 2.0 A and I = 3.0 A. Find the values of the following: a. Vbd b. la c. RT ime b S.. 50 V
1. Calculate the equivalent resistance for the circuit which is connected to 24 V battery and also find the potential difference across 40 and 6 0 resistors in the circuit. R, ww ww 24 V
3. Ohm's Law states that the potential difference (voltage) across an ideal conductor is proportional to the current through it. The constant of proportionality is called the "resistance," R. The internal resistance of the circuit can be measured by the formula E = IR, where I is the current, in amperes (A); R = x + 6.1 ohms; x is the ohms of the resistor; and 6.1 is the internal resistance of the circuit. a) Find I if E = 1.6 volts. b) What is the domain of the function you found in part a)? c) What is the maximum value of I? d) Graph the function in part a). Is there a vertical asymptote? e) What happens to I when the resistance is very large?
I. VOCABULARY If the underlined word is used incorrectly, cross it out and replace it with the correct word. 1. The rate of flow of electric charge is called resistance and it is measured with the unit joule. 2. Current is the electric potential energy per charge. It comes from the wires. The unit is the ohm. 3. Resistors in a circuit increase the flow of charge. This obstruction is called voltage. 4. Resistors dissipate mechanical energy into heat. The rate at which this occurs is called load. 5. In a series circuit each resistor has the same voltage.