7. A 5.50 kg block is pressed against a vertical wall by a force (F), as shown in the figure below. The coefficient of static friction between the block and the wall is 0.42 and the directional angle @ for the force is 36.0°. Determine the magnitude of the force (F) when the block is about to slide down the wall. x 95.910 N Lano

7. A 5.50 kg block is pressed against a vertical wall by a force (F), as shown in the figure below. The coefficient of static friction between the block and the wall is 0.42 and the directional angle @ for the force is 36.0°. Determine the magnitude of the force (F) when the block is about to slide down the wall. x 95.910 N Lano

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

1. A crate is being push by a horizontal force P to cause movement upward along the 15° incline without tipping. The crate has a mass of 30 kg. Type only the numerical values. Please indicate positve sign (+) for values in upward or rightward direction and negative sign (+) for values in downward and leftward direction. L P В A D 15° Your answer a) Determine the largest allowable coefficient of static friction between the crate and the incline. Your answer b) the corresponding magnitude of force Pin Newtons. Your answer
GIVE ME RIGHT ANSWER
The 8-kg block A is attached to link AC and rests on the 12-kg block B. Knowing that the coefficient of static friction is 0.2 between all surfaces of contact and neglecting the mass of the link. с OA B Draw the FBD(s) for block A and block B. -50 N
While moving in, a new homeowner is pushing a box across the floor at a constant velocity. The coefficient of kinetic friction between the box and the floor is 0.393. The pushing force is directed downward at an angle below the horizontal. When is greater than a certain value, it is not possible to move the box, no matter how large the pushing force is. Find that value of 0. Number i Units
I need help on that
5. (a) The weight of the block in the diagram is 54 N. The coefficient of static friction between the block and the vertical wall is 0.570. What minimum magnitude of the force F is required to prevent the block from sliding down the wall? (Note that the static frictional force is directed upward, parallel to the wall) Block F40.0° Vertical wall (b) A 104 kg baseball player slides into second base. The coefficient of kinetic friction between the player and the ground is μ = 0.651. (i) What is the magnitude of the frictional force? (ii) If the player comes to rest after 1.13 s, what is his initial speed?
25 & 26
Answer only C-E C. What are the magnitude and direction of the frictional force on the upper box? D. What is the magnitude of the applied force? E. Determine the angle at which the top block will start to slide down the bottom block.
Question 6 Given that a body with weight W is being pulled by a force P up an incline at an angle a to the horizontal. Write two equations for this system and deduce an expression for the frictional coefficient of the body with impending motion up the incline. Draw diagram of the motion and Label all the variables used. A. В. Figure 8 below shows a rope wrapped around a pulley to support a 800 kg mass. T1 800 kg Figure 8 Given that the coefficient of friction between the rope and the pulley is 0.3 , calculate: the weight of the 800 kg mass. ii. the tension T when the rope is wrapped 180 degrees around the pulley. i11. the angle in degrees that the rope must be wrapped for the mass to be supported by a tension of 500 N. i.
A sled is on a horizontal surface and a rope with tension T is pulling on it at an angle 0 above the horizontal. The sled had mass M and does not move due to the frictional force. In this case the coefficient of friction is µ̟. In terms of the variables given and g, what is the magnitude of the frictional force in this case? Select one: a. H, Mgsino b. Tcose O c. Tsin0 O d. H, Mgcos0
11. A 6.0 kg block sits at rest on a 25° inclined plane. If this is the steepest the ramp can be before the block slides, determine the coefficient of static friction between the block and plane. 0.89 0.29 0.68 0.47
A mass m is being pushed by a horizontal force F of magnitude 209.0 N. The coefficient of kinetic friction between the two surfaces is 0.4. What is the magnitude of the acceleration of this mass as it gets to be pushed up the ramp?