6 6 32 4 A - 10 V _ R 50 V

Q: An unbonded strain gauge shown in figure 1 is used to measure pressure. As the pressure is applied…

A:

Q: In the figure the current in resistance 6 is i6 = 1.50 A and the resistances are R1 = R2 = R3 = 1.53…

A:

Q: Briefly describe the effect of putting an infinite number of resistors in parallel

A:

Q: string of two 1,000 ohm resistances is in series with a parallel bank of two 1,000 ohm resistances.…

A:

Q: When resistors R1 and R2 are connected in parallel each resistor dissipate 100 w and 75 w,…

A:

Q: A,

A: Usually wire connected between bulb and battery to flow the current and make bulb on. the wire must…

Q: 5. Three 15-2 resistors are connected in parallel and placed across a 30-V ba a. What is the…

A: Given data, The value all the three resistances are R1= R2 = R3 =15 Ω. All the three resistance are…

Q: Four resistances 800, 500, 25 0 and Rare connected in parallel. The current through 250 resistance…

A: The solution is given below

Q: For each set of measured voltages at the points (1, 2, and 3) indicated in Figure, determine if they…

A: The given circuit is a bridge rectifier with a filter and regulator. The circuit can be easily…

Q: 42

A: When two resistors are in series, then the equivalent is calculated as Rs=R1+R2 When two resistors…

Q: 4 resistors of 500N each with accuracy of ±2% are connected in series, and 2 resistors of 120 with…

A:

Q: Now, double the value of R1 and R2. Disconnect the load and make sure that VNL (No Load) is the same…

A: Take the following actions to find out if the loaded voltage divider with doubled R1 and R2 values…

Q: R1 R2 R3 R4 220 Q 220 Q 220 Q 220 Q w w +1 PSB 5 V

A: Voltage division rule Voltage division rule is applied to simplify the mathematical calculations. In…

Q: A galvanometer with an internal resistance of 7 ohms is connected in parallel to an unknown resistor…

A:

Q: 1, between points (a and b) en's equivalent voltage and seguivalent resistance are

A:

Q: In cross circuits, how do i know the resistances are in parallel or in series connection?

A: The solution is given below

Q: The positive sequence current is Times the current in neutral wire

A: A balanced three-phase system with the same phase sequence as the original sequence is called as the…

Q: Use the circuit below for questions 1-5. Exact answers will vary based on rounding during…

A:

Q: In the circuit shown in below figure, a voltmeter reads 60V when it is connected across 650 Q…

A:

Q: A 120-A current flows into two parallel resistors having resistances of 15-ohm and 28-ohm. Find the…

A:

Q: Find the decimal equivalent of the binary number (1011.011)2

A: Binary numbers are those numbers which have 2 in their base and decimal numbers are those numbers…

Q: State Kirchoff's current Law. O None of these sum of all powers in a circuit O sum of all emfs in a…

A: Kirchhoff's Laws: Kirchhoff's current law, Kirchhoff's voltage law Kirchhoff's current law:…

Q: n resistors each of resistance R when connected in series offer an equivalent resistance of 50 ohm…

A: Given, n resistors each of resistance R when connected in series offer an equivalent resistance of…

Q: 4) For circuit shown in Figure (4): Determine the voltage drop across 90. a) 17V 20 90 b) 15V c) 19V…

A: Given circuit is:

Q: .A cube is made of copper wire with all the corners connected together. Four 12- O resistors are…

A: OHMS LAW:-if the physical conditions remain the same then the current flowing across any conductor…

Q: A 12-V DC automobile head lamp is to be used on a fishing boat with a 24-V power system. The head…

A: Given     Rating of lamp ,P = 50W Voltage rating of lamp ,VL= 12V Available Voltage, V= 24 V

Q: 9 The total resistance of two resistors in series is the sum of their resistances. Determine the…

A: We need to find out worst possible error for given series combination .

Q: Two resistors have resistances of 1.76 2 and 0.540 2. Determine the equivalent resistance if they…

A: Given: The two resistors are R1=1.76 ΩR2=0.540 Ω

Q: In the network shown in the figure, each of the resistance is equal to 20. The resistance between…

A: The given figure each resistance is equal to 2 ohm, the resistance between A and B has been asked.…

Q: Can I see an example of how to measure a load voltage and current using breadboard with multimeter

A:

Q: 1. A 5-ohm resistance is connected in parallel with a 10-ohm resistance. Another set, a 6-ohm and an…

A: Concept: When two resistances are connected in series then equivalent resistance Req= R1+R2When two…

Q: Five resistors are connected as shown in the figure. What is the equivalent resistance of this…

A:

Q: Two resistance in series are ka/2 ohm and a/k ohm find the minimum resistance of the circuit?

A: Given: R1=ka2 ΩR2=a2 Ω

Q: Three resistances are connected in parallel and their equivalent is in series with the same value of…

A: As given, the three resistances are connected in parallel and their equivalent is connected in…

Q: 2. From the figure, when the voltage V2 is 10 and 10 volts, the total voltage VD4 and VD6 is 0.7…

A:

Q: Voltage Peak value RMS value Average value Peak-to- peak value O V Time VT = Vmsinwt

A: Given, The wave form is sinusoidal. Please find the below attachment for the clear explanation.

Q: What is the advantage of using the voltage divider technique in determining the voltage across a…

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.