Answered: 50 g of NaCl has been dissolved in…

Principles of Modern Chemistry

8th Edition

ISBN:9781305079113

Author:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Chapter11: Solutions

Section: Chapter Questions

Problem 10P

See similar textbooks

Similar questions

Addition of water to concentrated sulfuric acid is dangerous because it generates enough heat to boil the water, causing it to spatter out of the container. For this reason, chemists remember to add acid to water. In a dilution experiment, we calculate the amount of the more concentrated solution that must be measured out. If we place this concentrated solution (Figure 4.7) in the volumetric flask first, then dilute with water, we violate the caution Add acid to water. Describe a safer variation on the method shown in Figure 4.7 that allows the quantitative dilution of concentrated sulfuric acid. Figure 4.7 Preparing a dilute solution from a concentrated solution. (a) Draw the concentrated solution into a pipet to a level just above the calibration mark. (b) Allow the liquid to settle down to the calibration line. Touch the tip of the pipet to the side of the container to remove any extra liquid. (c) Transfer this solution to a volumetric flask. Again touch the pipet to the wall of the flask to ensure complete transfer, but do not blow out the pipet because it is calibrated for a small amount of liquid to remain in the tip. (d) Dilute to the mark with solvent. Frequently, especially with concentrated acids, it is best to have some solvent present in the volumetric flask before you add the concentrated sample.
An experiment calls for 100. mL of 1.25 M HC1. All that is available in the lab is a bottle of concentrated HC1, whose label indicates that it is 12.1 M. How much of the concentrated HC1 would be needed to prepare the desired solution?
Calcium carbonate, CaCO3, can be obtained in a very pure state. Standard solutions of calcium ion are usually prepared by dissolving calcium carbonate in acid. What mass of CaCO3 should be taken to prepare 500. mL of 0.0200 M calcium ion solution?

Recommended textbooks for you

Principles of Modern Chemistry

Chemistry

ISBN:

9781305079113

Author:

David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:

Cengage Learning

Introductory Chemistry: A Foundation

Chemistry

ISBN:

9781337399425

Author:

Steven S. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

Chemistry

ISBN:

9781305957404

Author:

Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

Principles of Modern Chemistry

Chemistry

ISBN:

9781305079113

Author:

David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:

Cengage Learning

Introductory Chemistry: A Foundation

Chemistry

ISBN:

9781337399425

Author:

Steven S. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

Chemistry

ISBN:

9781305957404

Author:

Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

Chemistry: Matter and Change

Chemistry

ISBN:

9780078746376

Author:

Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Publisher:

Glencoe/McGraw-Hill School Pub Co

Introductory Chemistry For Today

Chemistry

ISBN:

9781285644561

Author:

Seager

Publisher:

Cengage

Introductory Chemistry: A Foundation

Chemistry

ISBN:

9781285199030

Author:

Steven S. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

50 g of NaCl has been dissolved in water to come up with a 120 mL of solution. The saline solution has a density of 1.3 g/mL. What is the concentration of the solution in terms of M? Responses A 6.27 M B 9. 17 M C 7.17 M D 0.66 M