5. The value of an unknown load at the end of a transmission line can be determined by measuring the forward and reflected voltage waveforms. Assume a 50 № lossless line is terminated with a completely resistive load. The forward-going voltage wave of 100 V produces a reflected (or negatively-going) wave of -25 V (note the sign). Find a) the reflection coefficient, and b) R₁.

5. The value of an unknown load at the end of a transmission line can be determined by measuring the forward and reflected voltage waveforms. Assume a 50 № lossless line is terminated with a completely resistive load. The forward-going voltage wave of 100 V produces a reflected (or negatively-going) wave of -25 V (note the sign). Find a) the reflection coefficient, and b) R₁.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter13: Transmission Lines: Transient Operation

Section: Chapter Questions

Problem 13.14P

See similar textbooks

Similar questions

1. On a lossless 500 coaxial transmission line with a shorted load: a. a voltage minimum will occur at the load. b. a current maximum will occur at the load. c. a voltage maximum will occur A/4 back from the load. d. the voltage and current are in phase. e. the voltage and current are 90⁰ out of phase. f. the standing wave moves toward the source.
5. Two cascaded lossless transmission lines are terminated by Z₁-2502, as shown below.. a) Calculate the reflection coefficient and the standing wave ratio at the load, i.e., the CC' terminal. b) Determine the characteristic impedance of the quarter-wavelength transformer, Zol, to match the cascaded line to a 6492 generator. B A- A'. Zol 11= 2/4 B' Zo2=75 92 12=32/4 C C ZL=2592
A 105MHz, 90 v peak signal is incident on a 50-ohm transmission line. The line is 125m long and is terminated in 300-ohm load. What is the SWR for this situation? Find the reflection coefficient.
A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight 1-The capacitance in uF/km without effect of ground is 2-The capacitance in pF/km with effect of ground is
The capacitance per unit length and the characteristic impedance of a lossless transmission line are C and Zo respectively. The velocity of a travelling wave on the transmission line is (a) Z.C (c) Zo C - UN (b) Z.C (d) Z
4. (a) A transmission line with a characteristic impedance of 100 has a load of 1 k2 resistance in parallel with a 0.005 µF capacitor connected across the far end. A surge voltage of magnitude 10 kV and unit function form (i.e. step function) travels along the line. Derive an expression for the time variation of the voltage across the load, and calculate the value of this voltage 10us after the arrival of the wave front of the surge
A system has a forward power of 60 W, reflected power of 3 W, and transmission line loss of –3 dB. What will be the observed loss on the ground? A system has a forward power of 200 W and a reflected power of 15 W, what is the return loss?
A coaxial cable is 10 meters long, and is filled with lossless Teflon, having a relative permittivity of 2.1. There is a matched load at the end of the line (this means that there is no reflection at the end, so there is only a signal traveling in the + z direction). At the input of the line, a sawtooth waveform is applied, having a peak voltage of 1.0 [V] and a duration of 1.0 [ns] (the time from the beginning of the waveform until the end). Make a plot (versus time) of what an oscilloscope would read if it were connected to the line at various locations, corresponding to the following values of z: 0.0 [m], 1.0 [m], 5 [m], 10 [m]. Plot out to 50 [ns] 1
c) For a transmission line w/characteristic impedance Z0 = 50 W. At some point of the line, a forward wave has the voltage V+ = 10V and backward wave has the voltage V- = 4V. i) Currents of the forward wave and backward wave at that point. ii) Measured voltage and current at that point. d) A transmission line has the following properties: Length, L = 3 m. Characteristic impedance Z0 = 50 W. The load impedance ZL = 100 W. And phase constant b = p/3. Assume the forward voltage at z = 0 is VA =10ejp/4 At z = 3m, calculate: i) Forward voltage and forward current. ii) Backward voltage and backward current. iii) Measured (total) voltage and current across the load
g) Why the Capacitance effect is neglected in Short Transmission Line. h) Distinguish between Lumped or Distributed elements in a Transmission Line.
For a lossless trabsmisison line, the characteristic impedance is 80 ohm. If the capacitance per unit length is 1.5 mh/m then what will be the inductance per unit length.
4- The charactersitic and load impedances of a lossless transmission Line are to and Z₁ = // Z₁. 1 a- Determine the voltage reflection coefficient at the load. Determine the voltage at the load, determine the power Consumed by the load. b. what is the power reflection coefficient defined by the ration power reflected incident power