5. Find the power absorbed by by each of the subcircuits A and B given that the voltage and current are 10V and 2A as shown. 2A А 10V В

Q: 4. Take a picture of a system inside your home that utilizes the concept of control system and ident...

A:

Q: #7.7 An amplifier has a voltage transfer function 10° s T(s) = (s+10)(s+1000) Convert this to the fo...

A:

Q: VCC 10V RC $3.6kN 10% R1 10kn 10% C2 B = 150. 01 2N3904 C1 RS 1kn 10% 1pF RL vs 1.5kN 10% CE 470uF R...

A: We will do DC analysis to find current and we will do ac analysis to find input, output impedance an...

Q: KHZ 2. 4) How to determene Cutoff froy. ond whih Crlut has Hhis characterestics ond why Vout Vaut

A:

Q: Two electric field lines can cross each other Select one: True False

A: Electric field lines depend on the charge. They are imaginary lines drawn on the electric field.

Q: al 10 D.

A:

Q: A current transformer has 15 turn on the primary and 75 turn on the secondary. The relay burden is (...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: What is the circuit time constant? 1 kQ i(1) I mH all

A: Circuit is given as,

Q: Q1/(a) At the network below, „Find Av 18 V 3.6KN C2 110 ΜΩ Ipss = 6 mA Vp=-3 V Yos = 10 µs Z. 150 2 ...

A: GIVEN: a circuit diagram with             IDSS=6mAVP=-3Vy0S=10μs FIND: AV               

Q: D2 С1 R1 5kQ V1 1n4001 1000µF T1 220 Vrms 60 Hz 0° +, TS POWER_10_TO_1

A:

Q: -10 931+1=2"{-1+31 10 (-1+i) = -8(1+l} %3D

A:

Q: quoted as having Ipss 12 mA and Vp -4 V. The circuit capacitances may be Calculate the output voltag...

A: The solution is given below

Q: Example-3: Determine the transfer function C/R for the block diagram Ha R G2 G3 H a G4

A:

Q: 32. (a) A series connection is formed between a 1 2 resistor, a 1 F capacitor, and a 1 H inductor, i...

A:

Q: #8)- FIND VO of Vo

A: For the given circuit we have to find the value of voltage vo

Q: what are the electrical, electronic, and robotic components of the robotic circuit?

A: Robotic circuit are basically the robotic system that comprises of various electrical and electronic...

Q: 2. A parallel circuit has 3 resistors each on different paths connected to a 120 V potential differe...

A:

Q: in this chapter we proved that aliasing occurs when an analog signal is discretized. Can aliasing oc...

A: Aliasing is a way of processing a signals which are different from others and make them indistinguis...

Q: An 8-pole, 3-phase, 50 Hz induction motor is operating at a speed of 720 rpm. The frequency of the r...

A: Poles P = 8  Frequency  f= 50 Hz Speed  Nr = 720 rpm Frequency of the rotor current  fr  = ?  

Q: An AM DSBFC signal of 100 watts that is modulated simultaneously by three equal modulating signals h...

A: Given,Power of AM DSBFC = 100 WandPercentage of power saving = 15%

Q: An AM transmitter has an output power of 500 W when the modulation used is 60 %. If another signal w...

A:

Q: 20kr 6okn V, V3 2okn V. 20kn (ookn 60k V2 20m www 20kn 20kn VW

A:

Q: For the P-only control , briefly explain changes in controller gain and offset (steady-state error) ...

A: In this question we will write effect of change in Proportional band on  proportional controller gai...

Q: Explain State Space Representation of Nth order Linear Differential Equation.

A: Most physical systems can be modelled in terms of differential equations. So we need to devise a met...

Q: 45. The average power absorbed by an inductor is zero. Neither True False Either

A:

Q: 502 ww 10.4: For the circuit shown: 1. Find the Z-Parameters? 2. Find the Y-Parameters? 202 V2 202 n...

A:

Q: Consider two charge Q =9 x 10- (C) and Q2 = 5 x 10-0 [C] separated by a distance r = 0. 05 (m]. a. W...

A: When two charges Q1 and Q2 are kept at distance d then charges experience a force on each other. If ...

Q: 7. A purely resistive lamp is rated at 200V (rms), 120 W (i.e., it dissipates 120 W power when conne...

A: Given, A purely resistive lamp, Vrms=200 VPrms=120 W

Q: Whas is the circuit diagram of linear voltage regulator for fixed output voltage using IC78xx and IC...

A: Voltage regulator- Voltage regulator is a device which provide a fixed voltage as an output for fluc...

Q: 1. Vp, VR and Ip

A:

Q: 3. When small ac input signals are required a. channel 1 on the oscilloscope should be used b. the a...

A:

Q: Transient C1 10µF V1 D1 10Vpk 1kHz 0° R1 25.6kQ -15 -20 -25 Om 2m 4m 6m 8m 10m Time (s) V(1) VPRI) S...

A: We need to find out output voltage for given clamper circuit.

Q: 10. Two resistances are connected in parallel. R1= 24Q, R2=24 Q, and IT=6 A. Find the current in eac...

A: This question belongs to circuit theory . It is based on the concept of the current division in para...

Q: МСВ Instruction Check Connection ON A Voltmeter 1 Ammeter Wattmeter Reset V Add to Table Autotransfo...

A: The setup shows two voltmeter, ammeter, wattmeter, auto transformer, Transformer and MCB.  

Q: Which of the following has no units? A. Permeability B. Moment of a magnet C. Magnetic susceptibilit...

A:

Q: In the circuit shown in figure (3) VI =12V,find Vs : 4 kf ww w- 2 kl 1 kl Vs 3 kl Fig. 3 6 kl? 4 k

A: Given V1=12v

Q: 4.37 Consider the process control system with the plant transfer function G(s) = G+0,4)(s+1.2)* 0.9 ...

A: A transfer function (usually in the s-domain) denotes the relationship between an input signal and t...

Q: Which of the following has no units? A. Permeability B. Moment of a magnet C. Magnetic susceptibilit...

A: Permeability has the unit of Henerymeter or Hm Magnetic moment has unit of Amper-meter2 or Am2 Permi...

Q: A 1.5k ohms resistor has a voltage drop of 22.5V across it. Can a 1/4W resistor be used for this app...

A:

Q: An FM signal expressed as S(t)-1000cos[2*z*10°t+0.5cos(2* x*10*t)] is measured in an 50 N antenna. D...

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part y...

Q: 1. Derive the transfer function of the (R-L-R) circuit, and then find the state space representation...

A: As per our guidelines we are supposed to be answer only first question. Kindly repost the other ques...

Q: The instantaneous values of two alternating currents are given by i, = 20 sin wt and i, = 10 sin (wt...

A: The solution is given below 

Q: 3. Category 5 cable, commonly referred to as CAT-5, is a twisted pair cable for computer networks. T...

A:

Q: 7

A:

Q: Draw the block diagram of a Displacement measurement system .Also identify the names of the  functio...

A: Displacement measurement system is a system which is used to measure a displacement by an object. It...

Q: D1 V1 1n4001 T1 SR1 5kQ 220 Vrms 60 Hz 0° +, D2 TS_POWER_10_TO_1

A: We need to discuss working of given circuit

Q: ) The following figure shows a transistor-level (CMOS) circuit for some logic gate. Sketch the logi...

A: The transistor-level (CMOS) circuit is shown below,

Q: What will be the change in electrostatic force if the separation distance doubled, and the charges u...

A: Given charges Q1 and Q2  are separated by distance d1  experiencing force F1, now distance is double...

Q: A 205 V shunt motor is rated at 5 HP and 1000 rpm. At rated output it draws 29 A of line current. Th...

A: This question belongs to electrical machine . It is based on the concept of dc shunt motor . Have a ...

Q: An 11 kV feeding power system shown in Figure 1. Data of the system is provided in Table 1. Consider...

A:

Gear Motor

A gear motor is a combination of a gearbox and an electric motor. This combination of two systems is used for efficient usage of the motor. It makes a cost-effective solution for high torque, low-speed applications. These motors are used in our household as, garage door openers, alarm clocks. In commercial areas, hospital beds, cranes.