5) The 25 lb pulley shown is at rest and in equilibrium when a constant 3.5 ft-lb couple M is applied. M 4 in. -8 in. 10 lb 5 lb B Neglecting the effect of friction and knowing that the radius of gyration of the double pulley is 6 inches, determine: (a) The angular acceleration of the double pulley (b) The tension in each rope ANS. a = 11.76 r/s²; TA-8.78 lb TB=6.22 lb

Below are the front and side views of the objects. Use these views to create the top view.

Two cylinders act right after one another. Each cylinder is metered, and some actions are slow, and there is a dwell between some actions. What is the minimum flow rate required (CFM) to operate this cylinders? (enter answer with 2 decimal places) Sequence of operations: Cyl. A extends with metering (takes 1.5 second) Dwell time for 2 seconds for part machining Cyl. B extend and retracts without metering (2 second) Dwell time for 10 seconds while an electric mixer is operated Cyl. A retracts quicky with no metering (0.5 seconds) Dwell time for 5 seconds while a part is placed before next cycle   Assuming the displacements of the cylinders are: Cyl. A DE = 65 in3 Cyl. A DR = 62 in3 Cyl. B DE = 44 in3 Cyl. B DR = 41 in3

LESSON: AUTODESK AUTOCAD Choose from the choices:

hand written plz Answer the following questions using the information provided in this unit. Know and Understand 1. True or False? The primary purpose of section views is to help feature exterior detail without using hidden lines. For the next three terms, match the three types of lines to the three descriptions. Answers are used only once. 2. Cutting-plane line 3. Section line 4. Short break line A. Not exclusive to section views, but needed for broken- out sections. B. Drawn thick in a view adjacent to the section view. C. Drawn thin, and usually continuous, but sometimes dashed. 5. Of the following, which is not a type of section view featured in this unit? A. Full B. Half C. Quarter D. Offset 6. True or False? The preferred dividing line between the two halves of a half-section view is the visible line. 7. An object with a number of odd features, such as spokes or holes, often has a(n) section so the odd features can be rotated around the axis into a vertical cutting plane,…

cant read and i think you need t solve for fn and ft

Orthographics: Add missing lines and complete any missing views. Draw the isometric