5) Plants in Europe sometimes use the mineral pyrites (containing FeS, and inerts) as a source of SO; for the production of sulphite pulping liquor. Pyrite rock containing 48.0% sulphur is burned completely with dry air by flash combustion. All the iron forms Fe,Oa in the cinder or the product gas. The gas from such a furnace is passed through milk of lime (Cao in water) absorbers to produce bisulfite pulping liquor. The exit gas from the absorber analyzes: SO, 0.7%, O, 2.9%, and N2 96.4%. Calculate the air supplied to the burner per kg of the pyrites burned. FeS, + 02 → Fe,0, + SO2

Q: A gaseous fuel containing methane (CH₂) and ethane (C₂H.) is burned with excess air. The combustion…

A:

Q: 9.61. A mixture of air and a fine spray of gasoline at ambient (outside air) temperature is fed to a…

A: Given data: Ambient temperature = 298 K Rate of heat loss from the engine to the outside air = -…

Q: Blue Water Gas is obtained by passing steam over red-hot carbon enriched coal (coke). The gas is…

A: Composition of blue water gas is given.

Q: Acetaldehyde is synthesized by the catalytic dehydrogenation of ethanol: Fresh feed (pure ethanol)…

A: temperature of acetaldehyde =17.6oC

Q: CaCO3, 50% water, 5% inert). The analysis of the flue gas leaving the cold end of the kiln is 20%…

A: Basis:100 lb of sludge reaction CaCO3=CaO+CO2 45% CaCO3=45 lb moles of CaCO3=0.45  moles of CaO…

Q: A fuel composed entirely of methane (CH4) and nitrogen (N2) is burned with excess air. The flue…

A: Given, Carbon dioxide (CO2) is = 7.5% Oxygen (O2) is = 7% And the remainder is…

Q: A group of engineers is tasked to estimate the heat of vaporization (kJ/mol) of benzene at 20 °C…

A: Hello!! Thank you for asking the question. You have asked 3 different methods of calculation of the…

Q: A combustion engine has been made to use a mixture of liquid hydrogen and liquid oxygen as a fuel…

A: Given data: Length of tube = 1 m  Diameter of tube = 0.8 m Flow rate of exhaust gas = 72 kg/s…

Q: How much trichlorosilane (Stream E) is produced? How much moles of gas stream leaving as overhead…

A: Let A be the molar flow rate of HCl gas into the reactor       B be the molar flow rate of solid…

Q: Blue water gas (BWG) is obtained by passing steam over red hot carbon-enriched coal. The gas is…

A: Wet blue water gas is burnt in wet air.4.9% of Carbon dioxide40.8% of carbon monoxide49% of…

Q: A 1.800-g sample of phenol, C6H5OH, was burned in a bomb calorimeter whose total heat capacity is…

A: Given that :m=1.8 g C=11.66 KJCT1 = 21.36 CT2  = 26.37 C

Q: Shown here is a table of the vapor pressure of benzene and toluene, Vapor Pressure (kPa) Temperature…

A: The given data The variation of vapor pressure of benzene and toluene with respect to temperature is…

Q: Paper is being dried with recirculating air in a two-stage drying system at 1 atm. Air (State 1)…

A:

Q: Ammonium sulfate, a widely used soil fertilizer, is produced commercially by the neutralization of…

A: As per our company guidelines, we are supposed to answer only first 3 sub-parts. Kindly repost other…

Q: A temperature rise of 11.5°C was observed when 0.500 g of butane gas (C„H,) was burnt and used to…

A: The total heat produced is obtained from the amount of water heated, the temperature changed or…

Q: a product having a moisture content of 60% (wet basis) is dried in a tunnel-type dryer at a rate of…

A: Initial moisture content of the product =60% (wet basis) Mass flow rate of the product,mp.=20 kg/hr…

Q: (a) In the manufacture of paint, a specific solid additive is used to improve the property. The heat…

A: Note: As per the guidelines we are authorized to answer a question at a time, since the exact one…

Q: Crude petroleum oil is generally considered to be formed from animal and vegetable debris…

A: Elemental analysis of the crude petroleum oil: 80% C, 13% H, 1% N, 3% O, and 3% S.Air supplied is…

Q: Nitric acid, which is among the top 15 chemicals produced in the United States, was first prepared…

A: The standard enthalpy of nitric acid formation reaction is to be calculated.

Q: 3B.1(b) Calculate AStot when two iron blocks, each of mass 1 5 °C, are placed in contact in an…

A:

Q: Calculate the heat required (in kJ,

A:

Q: The same amount of heat is added to each metal. Which metal reaches the lowest final temperature? --…

A: heat(q)=mc∆T∆T=qmc

Q: Blue water gas (BWG) is obtained by passing steam over red hot carbon-enriched coal. The gas is…

A: Wet blue water gas is burnt in wet air.

Q: A certain product is being dried in a small chamber at 30°C wet bulb temperature and 43°C dry bulb…

A: Given information:   Chamber conditions: Wet-bulb temperature, Twet = 30°C Dry bulb temperature,…

Q: A burner uses Pittsburgh coal analyzing 14.1% ash, 2.1%N and 4.3% S. Excess air is supplied dry at…

A: Given: A burner uses Pittsburgh coal analyzing 14.1% ash, 2.1%N and 4.3% S. The stack gases analyzes…

Q: 5.0 kg of water at 70°C in a closed vessel of 0.5 m in volume are heated to 180°C and 1000 kPa.…

A:

Q: Air at a dry bulb temperature of 30°C and a relative humidity of 30% is conveyed through a heated…

A: Initial temperature of dry air = 30°C Initial Relative humidity = 30% Final temperature of the air =…

Q: The fuel in the form of biogas (65%-mol CH4 and 35%-mol CO2) is burned in a furnace. Determine the…

A: Given that, The mole% of CH4 in the biogas = 65% The mole% of CO2 in the biogas = 35% The standard…

Q: A certain mass of pure ethylene glycol, HOCH2CH2OH, is added to 2.00 kg of water in the cooling…

A: Given; The mass of water given is mw = 2 kg = 2000 g, The molar mass of water is, Mw = 18 g/mol, The…

Q: A sample of solid benzoic acid (C,H;COOH) that weighs 0.800 g is burned in an excess of oxygen to…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 100 moles of butane is combusted in an oxidation reactor producing CO2, CO and  water vapour. 20%…

A: Butane is burnt with air to produce CO2 , CO, and water vapor.

Q: A metal block with the mass of 274 g originally at a temperature of 79.3°C is submerged into 100.0 g…

A:

Q: Table of radioactive isotopes Isotope Heat generation microwatt/kg 238 U 235 U 232Th 40K 94 570 0.9…

A: Given that- Mass of continental crust of earth=2.25x1022 kg The data of abundance is given in ppm…

Q: Nitrogen dioxide is one of the many oxides of nitrogen (often collectively called "NOX") that are of…

A: The equilibrium reaction that converts nitrogen dioxide to dinitrogen tetroxide can be written as…

Q: In wine making, the sugars in grapes undergo fermentation by yeast to yield CH3CH₂OH and CO₂. During…

A:

Q: Acetaldehyde is synthesized by the catalytic dehydrogenation of ethanol: Fresh feed (pure ethanol)…

A: The initital temperature of the ethanol, T1 = 360 °C = 360+273 K = 633 K The final temperature of…

Q: A 5.00 gram sample of dry ice (solid CO2) is placed in an evacuated container °c. whose temperature…

A: Given, Mass of dry ice, m = 5.00 g Temperature of solid carbon dioxide, T0 = -78.4 °C Temperature of…

Q: A fuel composed entirely of methane (CH4) and nitrogen (N2) is burned with excess air. The flue…

A: Given that: Fuel contains, methane (CH4)  and nitrogen (N2) which burns with excess air. Basis fuel…

Q: A cubic piece of platinum metal (specific heat capacity = 0.1256 J/°C.. 9) at 200.0°C is dropped…

A: Given data: Specific heat capacity of platinum metal = 0.1256J/oC Specific heat capacity of…

Q: 8.27. A fuel gas containing 95 mole% methane and the balance ethane is burned completely with 25%…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: Calculate the total energy in kJ for 198 g of liquid dimethyl ether (C2H6O) at -48.0 oC heated to…

A: Given Data : Mass of dimethyl ether (C2H6O)  (m) = 198 g  Initial temperature (T1) =  -48.0 oC…

Q: Pyrite is reacted with oxygen (O2) to produce hematite (Fe2O3) and sulfur dioxide (SO2). If 100…

A: The pyrite reaction with O2 is given as   2FeS2 + 112O2 ------->Fe2O3 + 4SO2  FeS2 + 114O2…

Introduction and Basic Calculations in Multiphase Systems

Chemical calculations involve material and energy balance calculations which enable engineers to calculate material and energy requirements in various chemical processes. In addition to this, chemical calculations help to study the behavior and properties of gases, liquids, and their mixtures.