47. A batch adiabatic reactor at an initial temperature of 373°K is being used for the reaction, A → B. Assume the heat of reaction is - 1kJ/mole at 373°K and heat capacity of both A and B to be constant and equal to 50J/mole.K. The temperature rise after a conversion of 0.5 will be A. O 5°C B. O 10°C C. O 20°C D. O 100°C

Q: A certain reaction is first order in N, and second order in Hz. Use this information to complete the...

A: Given the reaction is first order with respect to Nitrogen and second order with respect to hydrogen...

Q: Write in details about the significance of the equation=

A:

Q: 50.00 g of water, 10.00 g of phenol and 40.00 g of triethylamine are mixed at 75 ° C. Use the follow...

A: Considered 50.00 g of water, 10.00 g of phenol, and 40.00 g of triethylamine are mixed at 75 ° C.Fee...

Q: the bottom of a pan is made of a 4-mm-thick aluminum layer. in order to increase the rate of heat tr...

A: Given, Case 1: Bottom of pan is made of a 4-mm-thick aluminum layer. Thickness of aluminum layer, La...

Q: Particle Technology - Screen AnalysisProblem:What is the total number of particles and the total sur...

A:

Q: A 2.4-m-diameter tank is initially filled with water 4 m above the centre of a sharp-edged10-cm diam...

A: Given: Consider two point 1 and 2 as shown in the figure below to apply the Bernoulli's Law; a) Ini...

Q: Determine the structure of compound C6H10O based on the following spectral data.

A: here, from the given data we can find the exact structure of compound. 

Q: Consider the reaction 4NO2(g) + O2()- 2N2Osg). Use the thermodynamic data to calculate the change in...

A: 4NO2(g) + O2(g)→2N2O5(g) Temperature= 25°C= 298 K PNO2=0.185 atmPO2=0.113 atmPN2O5=0.800 atm   NO...

Q: Suggest few methods by which we can reduce lead pollution in our environment

A: The methods to reduce lead pollution in our environment are based on replacing the lead with non-haz...

Q: Thermodynamics

A: Given data: Initial temperature of the gas = 240 0C Initial pressure of the gas = 1 N/mm2 Final pres...

Q: a) The half-life for a given reaction was halved as the initial concentration of reactant wasdoubled...

A:

Q: 2. For the reactionA + B ⟶ ProductsSome of the data (as the fraction of B unconverted at time t) obt...

A: Given data:  Reaction:  A +B ---> C CAo = CBo = 0.757 mol/s show that reaction is second order.  

Q: (a) The combustion of Pentane (C,H) produces Carbon dioxide (Co,) and water vapor (H,0). The propert...

A: Note: We’ll answer the first question since the exact one wasn’t specified. Please submit a new ques...

Q: Thermodynamics

A: Note: As per the guidelines we are authorized to answer a question at a time, since the exact one wa...

Q: Chemical Engineering Question

A: Note: Since you have asked multiple questions, we will solve the first question for you. If you want...

Q: During the phase transition the ....or... of .change abruptly. the volumetric or specific values of ...

A: The answer is based on the Chemical Engineering Thermodynamics principles.

Q: A balloon containing 50 ML of propane is compressed to 2.5 ATM what is the new volume

A: The answer is based on the ideal gas law equation.

Q: 1- An analyst weighed 9.8512g of a sample, later he took a porcelain capsule at constant weight, whi...

A: Given,  The initial weight of the sample is 9.8512 g The weight of the porcelain capsule is 114.6132...

Q: Vapor pressure is when:  Evaporation rate <Condensation rate Evaporation rate >Condensation ra...

A: Vapor pressure is something tendency to get vaporize.

Q: Oil flows at a rate of 1000 kg/min from an open reservoir at the top of a hill 400 m in height to an...

A: Flow rate of oil = 1000 Kg/min Height = 400 m Heat supply rate = 1800 KJ/min Workdone by pump= 1hp=7...

Q: kı A+B AB* k2 k3 AB* +A FA2B k4 By applying pseudo steady state approximation to the sequence of ele...

A:

Q: The principal source of the difference in the normal boiling points of the alcohols ethanol (78 °C; ...

A: The boiling point is the heat required to raise the temperature of the liquid by 1-degree centigrade...

Q: 2. A chemical reactor feeds 100 kgmol / hour A mixed with A which is recycled. Inside the reactor A ...

A: The given process is represented in the form of a schematic diagram as:

Q: Determine the phase, the quality if applicable, and the missing properties. Give the details of your...

A: (a) Water Temperature, T = 40°C Pressure, P = 100 kPa   From the saturated steam table, the saturati...

Q: Block flow chart required to produce liquid sorbitol from wheat

A: Sorbitol is a hexavalent sugar alcohol. It is a common constituent in many edible fruits. It has a w...

Q: Q2. An oil cooler consists of a straight tube of 20 mm O.D. and 16 mm I.D. enclosed within a pipe an...

A: Given: Heat transfer takes place between a hot oil and cold water; hoil = 2000 W/m2.oC hwater = 4000...

Q: 1) Complete the table given below for a closed system undergoing a cycle. Process Qnet kJ Wnet kJ AU...

A:

Q: Relative Humidity influenced by pressure and geographic location

A:

Q: Air at 1 bar and 25°C enters a compressor at low velocity, discharges at 3 bar, and enters a well-in...

A:

Q: How to solve mol% to kg given 50mol%NaOH, 7mol%NaCl and 43mol% H20

A: The mass in kg from mol% is to be calculated for the given substances.

Q: The pre-exponential factor and activation energy for the following molecular ion reaction are 4 * 10...

A: The value of change in entropy, enthalpy, and Gibbs free energy are to be determined for the given d...

Q: Q1 – A rock core sample 5.4 cm in diameter and 11 cm high, has a total mass of 0.5 kg , if its poros...

A: Given, Diameter of rock core, D = 5.4 cm Height of rock core, H = 11 cm Mass of the rock, m = 0.5 kg...

Q: Fluid Mechanics

A: Dimensionless groups to define efficiency is asked.

Q: In a process to generate iron(II) sulfide (FeS) by heating Sb2S3 with scrap iron and drawing off the...

A:

Q: For steady incompressible flow through a long pipe with a diameter of 20 cm, the velocity components...

A: Given, νr=0νθ=r2w=r1+r

Q: A solution of 20.91 % by weight H2SO4 has a specific gravity of 1.150. What is the normality of this...

A: This question is based on the concept of normality. For the first solution: Weight percent of H2SO4 ...

Q: 18. Reactant A converted into product through second order reaction with certain amount in one mixed...

A: Given data: Reactant A is converted in to product through a second order reaction. The reaction is c...

Q: Was purificaiton successful?

A: In the process, purification is one of the high rated processes for any industry. Purification is de...

Q: A 15 mm diameter mild steel sphere (k= 42 w/m°C) is exposed to cooling air flow at 20 °C resulting i...

A:

Q: You solved the first three subparts the question, please solve the rest of the problem thank you

A: As the first three sub-parts are already solved we will provide solution to last two parts.

Q: Fill in blanks

A: This question is based on the oil drilling and environmental effects subject. We will need to know t...

Q: What is the difference between the loading point and the flooding point in a packed column?

A: This question is based on the concept of loading point and flooding point.  

Q: Do research about the processes which are used to remove the heavy metals from industrial wastewater...

A: Several heavy metals present in industrial wastewater are lead, arsenic, cobalt, mercury, chromium, ...

Q: The legal workplace exposure limit for ethanol indoors is exactly 1000 ppm. In our aforementioned ch...

A: ACH is the Air Changes per Hour which means that the number of times the air is recycled per hour. I...

Q: The drag coefficient of a car at the design conditions of 1 atm, 25°C, and 90 km/h is to be determi...

A: This question is based on fluid mechanics. Data given: Pressure P = 1 atm Temperature = 25 degree Ce...

Q: If one mole of two ideal and inert gases are mixed together and their initial volume and temperature...

A:

Q: A step change of magnitude 4 is introduced into a system having the transfer.   (c) overshoot ?　 (d)...

A: Process control is the control of the process variables to get the desired output. On controlling th...

Q: draw the graph of T Celcius to phenol-water the following term;

A: Given data: % phenol and temperature data are given: % phenol % water T (C) 32.5 67.5 35 28....

Q: Remaining Time: 27 mintes, 25 secondls. Question Completion Status: QUESTION 1 The dimensions of hea...

A: • These are the one word choice questions and to solve these questions, we will use our concepts of ...

Q: A pressure gauge placed on a 300cm tall batch reactor, falls and reaches the ground at a final veloc...

A: The answer is based on the free fall condition.