3. An inductor having a 50 ohms resistance and 100 ohm inductive reactance is connected to a 100 volts, 60 hz a-c source. Draw the phasor diagram and waveform diagram of the current and voltage of the circuit showing their phase an

3. An inductor having a 50 ohms resistance and 100 ohm inductive reactance is connected to a 100 volts, 60 hz a-c source. Draw the phasor diagram and waveform diagram of the current and voltage of the circuit showing their phase an

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: What is the reactance of 3.00 microfarad capacitor? What is the impedance of the capacitor in series…

A: Given: C=3 μFR=300 Ω

Q: Three identical capacitors of 25 micro farad are connected in star across a 420 volts, 50HZ, 3-…

A: NOTE: We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: A coil of resistance 10 Q and inductance 450 mH, are connected in series across a 240 V, 50 Hz a.c.…

A: Find the impedance and voltage across the resistance and coil. Phase angle?

Q: The inductive reactance of a 0.06-H coil connected to a 120-V, 60-Hz source is?

A: Given, Inductance (L) = 0.06H Frequency of source (f) = 60Hz Vs= 120V

Q: A series circuit consisting of a 50 – ohm resistor, 0.5 – henry inductor, and a 100 – microfarad…

Q: 1-Choose the correct statement for pure resistor connected across single phase AC supply. a.…

A: Resistance Voltage and current are in same phase I=V/R So both are in same phase.

Q: An inductor has an inductive reactance of 250v when connected to a 60-hz line. What will be the…

A: The inductive reactance of the inductor is given by the expression as shown below:…

Q: Three identical capacitors of 15 micro farad are connected in delta across a 435 volts, 50Hz, 3-…

A: Given Data: C=15μFV=435Vf=50Hz

Q: A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this…

A: Capacitors in series are equivalent to the resistance in the parallel. The equivalent capacitance…

Q: A 150 – microfarad capacitor is connected to a 220 – volt, 60 – cycle source. Calculate (a) the…

Q: A coil of resistance 20 Ohm is connected in series with a 60 Ohm resistor to a 500 V, 50 Hz supply,…

A: As per the guidelines, we supposed to answer first three part of the question at a time so please…

Q: A series resistance-capacitance (R-C) circuit is connected to a 230 volt 60 cycle source. If the…

Q: An RC series circuit is connected to a 240-V, 60-Hz power source. An ammeter indicates a current of…

A: An RC series circuit is connected to a 240-V, 60-Hz power source. An ammeter indicates a current of…

Q: What value of resistance should be placed in parallel with a 50 μ F capacitor in order to have a…

Q: Three identical capacitors of 25 micro farad are connected in delta across a 420 volts, 50HZ,…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: Choose the correct statement for pure inductor connected across single phase AC supply. a. Current…

Q: (a) Calculate the inductive reactance. (b) Calculate the capacitive reactance. (c) Calculate the…

A: Frequency=50HZ ω=2πf =2×3.14×50 =314rad/second (a) Inductive reactance(XL)…

Q: The capacitive reactance of a circuit is 120 ohms when it is supplied with 50 Hz supply. What will…

A: According to question: ∵XC=12πfC∴120=12π×50×C..............(1)&XC=12π×60×C...............(2)from…

Q: 15 A of current is taken by a non-inductive load at 125 V. In order that the same current shall be…

Q: Suppose I have two peak phasor voltages, V, = 100245° and V, = 75Z-60°. Circle Your Choices: The…

A: In this question we will find RMS value , frequencies etc of given phasor...

Q: An rms voltage of 22.2 V with a frequencyof 1.00 kHz is applied to a 0.290-mH inductor. (a) What is…

A: (a) Write the given values. Vrms=22.2 VL=0.29 mHf=1 kHz

Q: A coil of resistance 52 is connected in series with inductance 120mH is connected to a 215V, 50 Hz…

Q: A 25-ohm resistor connected in series with a coil of 50-ohm resistance and 150-mH inductance. What…

Q: Three identical capacitors of 10 micro farad are connected in delta across a 410 volts, 50HZ,…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: 1. A load of 50 ohms resistance and 0.4 H inductance are connected in series to 100 volts, 60 hz a-c…

A: we have to calculate capacitance.

Q: Draw circuits diagrams of different modes of three phase VSI and draw the output wave shapes of line…

A: In 3-∅ voltage source inverter, the main circuit diagram is shown below: In the above circuit the…

Q: Three identical capacitors of 5 micro farad are connected in star across a 415 volts, 50HZ, 3-phase…

A: Given 3 identical capacitors of 10 micro farad are connected in star connection VS=415 VLL rmsf=50…

Q: design concept fire alarm system by adruino (simple)

A: FIRE ALARM SYSTEM USING ARDUINO: In this project, an IR-based flame sensor detects firelight and…

Q: 28. Assume an inductor is connected to a 180-V AC line and the inductor has an induced voltage of…

Q: A 120V adjustable frequency ac source is connected in series with a resistor, an inductor, and a…

Q: 28. Assume an inductor is connected to a 180-V AC line and the inductor has an induced voltage of 12…

A: PRESENCE OF SOURCE: In the presence of sources, all the passive elements which are R, L and C always…

Q: (a) Sketch the phasor diagram for an ac circuit with a 105@Ωresistor in series with a 22.5-mH…

A: Given: R=105ΩL=22.5x10-3Hf=60Hz to find: To sketch phasor diagram average power at Vrms=120V

Q: Three identical capacitors of 10 micro farad are connected in delta across a 430 volts, 50HZ, 3-…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: -Calculate and draw the load current for the first two-period interval b-Calculate and draw the…

A: Rectifier: Because nearly every electrical appliance runs on DC (Direct Current), the rectifier…

Q: Construct a graph to represent the recurring nature of partial discharge pulse sequences under…

A: In general principle, Partial Discharge happens in zones of the protection or on the outside of the…

Q: Identify the low voltage system from the following. a. primary distribution b. Secondary…

A: A low-voltage network, sometimes known as a secondary network, is a component of electric power…

Q: load is connected across a 25,000 Volts, 60 Hz source and draws a current of 90 A rms. If the power…

Q: 2. A coil of resistance 52 is connected in series with two inductance coils 120mH and 25mH connected…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: Determine the values of the resistance and the series-connected inductance or capacitance for each…

Q: What value of capacitor will have a reactive power of 90 Vars when connected to a 70V, 60 Hz supply?

A: In this question, If reactive power is Q= 90VAr Voltage V= 70V Frequency f= 60Hz

Q: A coil of resistance 30 Q and inductance 400 mH, are connected in series across a 240 V, 50 Hz a.c.…

Q: 1. a) Sketch the phasor diagram, using current as the reference phasor, for a load consisting of a…

A: given data:

Q: What is the total inductive reactance of a 4 mH coil connected to a 1000 Hz source? 6. Your Answer:…

A: The solution is given below

Q: Three identical capacitors of 15 micro farad are connected in star across a 425 volts, 50HZ, 3-phase…

A: Three identical capacitors are linked in a star configuration with a supply voltage of 400 volts,…

Q: А 230-vol inductanc value of th

Q: The reactance of an inductor is 2.35 kohms when it is connected across a 50 Hz ac source. Estimate…

A: The reactance of an inductor of inductance L can be expressed as XL=2πfL Ω--->(1) where f is the…

Q: nusoidal voltage with effective value (73 V), and a Freque ied on a series circuit that consists of…

A: Since you posted a question with multiple sub-parts. We will solve the first three sub-parts for…

Q: coil and capacitor are in parallel, with jBL = j0.05 and jBC = j0.03. What is the admittance vector,…

Q: A 200V, 50 Hz supply is connected across a coil of negligible resistance and inductance 0.15 H…

Concept explainers

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

1. Enumerate five formulas for five series connected inductances across Vt source and draw the circuit. 2. Enumerate five formulas for five parallel connected inductances across Vt source and draw the circuit.
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. Now what is the minimum AC voltage rating of each capacitor?
An inductive reactance of 6 ohm is connected in series with a parallel combination of a variable resistor R and a capacitive reactance of 15 ohm across 100V , 50 hz supply. a. Solve for the frequency so that the magnitude of the inductive reactance is 2 times the magnitude of capacitive reactance. b. Solve for the value of R so that the total current I will be maximum.
A2 KO resistor and 30 mH inductor are connected in series, across a 120 V A.C power source oscillating at 60 Hz frequency .Calculate i) The current in the circuit i) The voltage drop across the resistor & inductor ii) The power dissipated in the circuit. iv) The apparent power & reactive power in the circuit. v) Draw the phasor diagram.
TOE This is a photo of a capacitor that corrects the power factor in an AC setup, in DC it is used in electronic board for appliances and other small devices. Tell me something about this photo.
An inductor and resistor are connected in parallel to a 120-V, 60-Hz line. The resistor has a resistance of 50 ohms, and the inductor has an inductance of 0.2 H. How many degrees out of phase are the current and voltage?
For figure (1)draw and calculate the voltages waveform across each half of secondary winding and across load when 100sin2π60t applied across the primary, then find PIV.
1. A load of 50 ohms resistance and 0.4 H inductance are connected in series to 100 volts, 60 hz a-c source. What must be the value of the capacitance to be connected in parallel to the circuit to raise the power factor to 0.96 lagging. Draw the circuit diagram.
A)For the inductive element of Figure 2 , the voltage and current in phasor form is B)the value of impedance and capacitance for capacitor in figure 2 is
A 25-ohm resistor connected in series with a coil of 50-ohm resistance and 150-mH inductance. What is the power factor of the circuit? The standard frequency is 60 Hz. Show complete solution.
low voltage systemsWhich of the following is true in pure inductive circuit? a) Current can be 90 forward or backward. b) Current in phase with voltage. c) The current lags behind the voltage by 90. d) Current stays beyond 90 ° to voltage.
60. Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V de voltage source. 61 Datermine the volto in the girRuit F Figura 1 1?