Answered: 32. A container has water. If the water…

32. A container has water. If the water level is 0.5 m and water density is 10³kg/m³, the pressure at the bottom of the container is (a) 4.9 kPa (b) 3.2 kPa

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Problem 20. The current I flowing in a resistor R is measured by a 0-10A ammeter which gives an…

A: Given data, Current I=6.25 A Voltage V=36.5 V Limit of error=2 %

Q: Determine the pressure difference between points A and B in kPa. Given Specific Gravities: Benzene…

A: According to the question we have a specfic gravities for the several liquids is given which are,…

Q: Find the magnetic flux of the middle leg (mWb) while the magnetic flux density in the middle leg is…

A: Given, Magnetic flux density = 1T length of the middle leg = 40 cm = 0.4 m Diameter of the middle…

Q: 4-Two rods (the first is Al and the second is Cu),the cross section area of the 1* is 12.56 cm? ,its…

Q: 2.5 m 0.4 cm a) 1374 N b) 1978 N c) 2693 N d) 3517N

A: Explanation: “Since you have asked multiple questions, we will solve the first question for you. If…

Q: A sample of cable oil has a breakdown voltage of 80kV at normal atmospheric pressure. Then the…

A: The breakdown voltage of a dielectric material (such as cable oil) is affected by the pressure…

Q: is a threat to -5 human life pollutants O energy O minerals

A: We need to select correct option for statement .

Q: QUESTION 1' a) Figure 1 shows capacitors Cl = 2 µF, C2 = 3µF, C3= 5µF, C4= 2µF, C5= 3µF and C6 = 6µF…

Q: A copper wire 1.2 m long and 1.7x10-8 Qm resistivity with a circular cross sectional area of a…

Q: Q calculate the effective following combination of vesistance between ponts A and B then find…

A: Series resistors: If the resistors are connected in series then the equivalent resistance is equal…

Q: A 20 m Cu wire 1.0 mm in diameter is joined to a 60.0 m iron wire of the same diameter. The current…

A: Let us consider the wire is made up of Cu: So, l1=20 cm and the diameter, d1= 1 mm So, radius,…

Q: The partial pressure of ethane over a saturated solution containing 6.56 × 10-2 g of ethane is 1…

A: Given data, The partial pressure is P1= 1 bar. In first solution mass of ethane is W1= 6.56×10-2 gm…

Q: 224 lb 200 lb 60° 30° 12 390 lb 300 lb

A: Given Data:The four forces of, with angle with with angle To Find:The resultant of the four…

Q: 1- A parallel-plate capacitor C=245 µF has a charge Q= 980 µC. The plates are 0.328 mm apart. +Q -Q…

Q: Problem 20. The current I flowing in a resistor R is measured by a 0-10A ammeter which gives an…

A: Given, Ammeter reading, I=6.25 A Voltmeter reading, V=36.5 V

Q: The temperature coefficient of a wire of conducting materials is 0.004/°C at 20°C. The resistance of…

A: We need to find temperature at given resistance .

Q: 2. Determine the nominal resistance values of these resistors, given their band colors, and also…

A: Carbon resitance or color code resistancs is calculated as given below by using table

Q: 2. 1V Resistor ww TKO VI

Q: Problem 20. The current I flowing in a resistor R is measured by a 0-10A ammeter which gives an…

Q: When 26 liters of hydrogen gas and 13 liter of oxygen gas react to form water at a constant…

Q: The resistance of a cylindrical brass conductor 0.5 cm diameter and 3m long are 0.0108 ohms.…

A: Since you have posted multiple questions, we will provide the solution only for first question as…

Q: A 8-volt battery is applied across a certain parallel-plate capacitor. If the capacitor was able to…

A: We need to determine the distance between the two plates of capacitor.

Q: If the gauge number of a wire is increased by 6, the diameter is halved; if a gauge number is…

A: Resistance is directly proportional to length and inversely proportional to area.

Q: uie cinarge Call be gI Q = Gnm³V¯21²w0.5. E² Where m is the mass of the cell of the battery in kg, V…

Q: How long does it take electrons to get from a car battery to the starting motor? Assume the current…

A: We need to find out the time for given charge and current .

Q: Question 2 A pump has a delivery of 100 liters per minute at 1800 RPM. Its displacement is 60…

A: We need to find out volumetric efficiency of the pump.

Q: Determine the total current on a circular wire of radius 2mm and J=500a, A/m2 6.28 mA 25.132 mA 1.57…

Q: 2. A couple of systems move electrons on conductor (a material that allows the flow of electrons).…

Q: A copper bus bar has a rectangular cross-section of dimensions 6 inches by 8 inches. Determine the…

A: Given data, A copper bus bar has a rectangular cross-section of dimensions 6 inches by 8 inches.

Q: W =Cv? The equation above describes the amount of energy stored in a capacitor in joules, W, in…

Q: 5. The temperature of a solution is 28°C. Convert this temperature to absolute Rankine.

A: In the below answer we will try to convert the temperature in Celsius to absolute Rankine as…

Q: 2.3 A metal cube has a total surface area of 690 cm2 and is to be gold-plated to a thickness of 0,5…

Q: Which of the following samples will have the highest pressure if they are all at the same…

A: The ideal gas law is given as: pV=nRT Where, p is pressure of gas V is the volume n is the amount of…

Q: H.W/assume a leg has 0.6m shaft of bone with an average cross sectional area of 1.5 cm.What is the…

A: Given that F=350NA=1.5cm2=1.5×10-4m2L=0.6mY=1.8×1010 N/m2 Although the formula for young modulus is…

Q: 0.05 mT 10 cm →y Find magnitude of current and direction of current flowing

Q: The total electric flux from a cubical box of 28.0 cm in diameter is 1.45 x10³ Nm²/C. What charge is…

A: Given data, Diameter of cubical box d=28 cm. Electric flux ϕ=1.45×103 N/m2.

Q: Calculate the magnitude of electrostatic attraction force between electron and proton at a distance…

A: We need to find the electrostatic force between electron and proton

Q: Charge per unit volume is called as Estimated Time for completion: 1 minute Ps Pv O PI

A: Given: Charge per unit volume

Q: O) Number of electrons in 1C of charge ? O Charge of 5µC passes from a given section of a conductor…

Q: Two student measure the density of an unknown metal three times each Below the data Student1…

Q: .1 During the tensile test of IRON(Fe) sample, the results in respect of load and orresponding…

A: GIVEN: A table of sample of result of load and corresponding extension FIND: (1) number of proton,…

Concept explainers

RTD (Resistance Temperature Detector)

A resistance temperature detector is a passive electronic device or a sensor. The name itself suggests that it is related to resistance, temperature, and detection. Similarly, its resistance changes when there is a temperature change; the resistance increases when the temperature of the RTD device increases or vice-versa. It is also known as a resistance thermometer. Its working is similar to the thermocouple.

Question

32. A container has water. If the water level is 0.5 m and water density is 10³kg/m³, the
pressure at the bottom of the container is
(a) 4.9 kPa
(b) 3.2 kPa

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

R₁ R₂ VDD M₁ CG Vss = 0 V RD Cs Rs Figure 1 Vout Vin
A J- type thermocouple is used to measure the temperature in a heating process. Sheath material used is SS316. The length of the sheath is 14mm and thickness is 0.3mm. Find the time constant of the sheath. Q"(kg/m³)(J/Kg K(W/m- k) |- °c) Material Platinum 21450 130 71.6 SS304 8030 500 21.4 SS316 7990 500 21.4 SS410 7750 460 24.9 Air 1.20 1005 0.025 MgO Powder 3580 877 26.8 Silicon compound 3210 800 Time constant of the bare material is, T=
question number 3
There are charge densities of 2 uc/m2, 2 uc/m2 and -2 uC/m2 respectively on the plates in the figure. The distance between successive plates is 1 cm. What is the magnitude of the electric field in region (c) in kN/C (kilo Newton per Coulomb)?
Problem 1 The plates of a parallel plate capacitor with a dielectric of Porcelain are 0.25 mm apart and have an area of 0.09 m², and 60 V are applied across the plates. a) Determine the capacitance. b) Find the electric field intensity between the plates. c) Find the charge on each plate.
SHOW YOUR SOLUTION COMPLETELY AND MAKE SURE THAT THE FINALS ANSWERS IS IN 4 DECIMAL PLACES.
Test I. Multiple Choices. Directions: Read each statement carefully and encircle the letter of your answer. 1. What will be the electric potential at the center if the square? a. Zero b. 4k 9 c. 8 9 2k d. 4 2k9 r 2. What will be the electric potential at the center of the square if two charges at the top are replaced with negative charges? a. Zero b. 4k 9 8 2k с. d. 4 2k Açeb For nos. 4-8 refer to the diagram at the right +5 V -5 V 3. If the quadrupled, how would the electric potential energy change? a. Doubled b. Halved distance between two charges is B c. Quadrupled d. Quartered 4. What is the direction of the electric field at point +10 V OV -10 V B? a. Upward b. Downward c. Right d. Left 5. What is the direction of the electric field at point A? a. Upward b. Downward c. Right d. Left
Please answer and show your solution clearly thank you!
1.1A 50 kg cement block needs to be moved, over a distance of 10m, the power available is 200 W, while the block accelerates at 5 m/s? when this power is applied. 1.1.1 Determine the work it would take to move the block over the desired distance. 1.1.2 Determine the time it would take to move the block over the desired distance. 1.2 Determine the force applied to rotate an object around an axis with a torque of 100Nm. The angle between the moment arm and the applied force is 56.44° and the moment arm has a length of 0.8 m. 1.3 Aluminium with an unknown mass and an initial temperature of 18 °C is to be melted in an arc furnace in 1 hour and 30 minutes. The aluminium has a melting point of 938 K, a specific latent heat of fusion of 458 kJ/kg and specific heat capacity of 1016.22 J/kg. C. The energy required for the melting process is 156 MJ, the efficiency of the furnace is 81% and the cost of electrical energy is 92c/kWh. 1.3.1 Calculate the mass of the aluminium.
4. Resistance of a wire is r ohms. The wire is stretched to double its length, then the resistance in ohms is (a) r/2 (b) 4г 5. The diameter of the nucleus of an atom is of the order of (a) 10³'m (b) 102ºm 6. The mass of the proton is roughly how many times the mass of an electron? (a) 184,000 (b) 18,400 7. The charge of an electron is known to be 1.6 x 10-19 coulomb. In a circuit, the current flowing is 1A. How many electrons will be flowing through the circuit in a second? (а) 1.6 х 10° (b) 1.6 х 1019 8. Two bulbs marked 200 watts-250 volts and 100 watt-250 volts are joined in series to 250 volts supply. Power consumed in circuit is (a) 33 watt (b) 67 watt 9. Ampere second could be the unit of (а) Power (b) Conductance (c) 2r (d) r/4 (c) 102' m (d) 101ªm (c) 1840 (d) 184 (c) 0.625 x 10" (d) 0.625 x 1019 (c) 100 watt (d) 300 watt (c) energy (d) charge
Please hand written solution
4, The hardness of ten steel samples was measured and the results were as follows. Sample 1 2 3 4 5 6 7 8 9 10 Hardness 90 92 95 91 98 102 97 92 95 99 Calculate the mean, median, mode, standard deviation and variance.