3. The phase displacement between phasors in polyphase system is always a) 90 degrees b) 120 degrees c) 360 degrees divided by the number of phases d) 180 degrees

Q: Which of the following is not correct about the Hata model for path loss predictions? (A) The model…

A: which one is not correct about the hata model for path loss predictions?Hata model:It is also known…

Q: a) Convert the flowing number (226)10 to binary, octal, and hexadecimal. b) Use a truth table to…

A:

Q: H.W: Find (HPBW) and (FNBW), in radians and degrees, for the following normalize radiation…

A: Since you have posted multiple questions we will provide the solution to the first three questions…

Q: f electrodynamo type water meter B. Write

A: Electrodynamometer Wattmeter : These instruments are similar in design and construction to the…

Q: E,-10V 20 R.110 www ele 2.5 k skfly skf Xc www 50 410

A:

Q: (a) FIND THE EQUIVALENT INDUCTANCE WITH RESPECT TO TERMINALS a, b. 18 u H mm a b 25 MA m вома m 15uH…

A: As per our company guidelines we are supposed to answer only first question kindly repost the other…

Q: Calculate and record the expected output of the adjustable output voltage regulator circuit + 15V…

A: The given circuit diagram is shown below. We need to calculate the expected output of the…

Q: Find I in the network in the below figure using mesh analysis. σν 6ΚΩ σΚΩ 4 ΚΩ +)24V

A:

Q: What is the dc output voltage of an unfiltered half-wave rectifier whose peak output voltage is 9.8…

A:

Q: What is the resistance of the Aluminum bus bar on the outdoor substation which has a diameter of 4…

A: In this question We need to choose the correct option What is resistance of the wire if diameter of…

Q: Y = RV R₂ Vief We wish to have Vref = (4 ± 4%) V. We choose R₁ = (2210 ± 1%). 1. With the help of…

A: Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: Direction: Create Truth Table and Circuit Design for the following expression. 1. F(X,Y)= (X AND Y)…

A: Given, 1. F(X,Y) = (X AND Y) OR (NOT Y) 2. F(X,Y,Z) = (X OR Y OR Z) AND (NOT Z) we need to create…

Q: 23. Draw a Bode diagram for the following transfer functions: A. G(s) = 10(s+3) s(s+2)(s+8) 20 B.…

A:

Q: USE NODAL ANALYSIS TO FIND U₁ AND V₂ IN THE CIRCUIT BELOW. 15 68 2.2 15 4.

A:

Q: 1 The diodes in Figure 1 both have VON=0.7 V. By using mesh analysis or otherwise, show that D, is…

A: We need to check which diode will be on or which diode will be off.

Q: For the circuit shown, Vin is a step function that goes from 0 to VIN=1 at t=0. R=1k, C=10uF Vin 1 R…

A:

Q: A motor load of a workshop and a wood shaper establish a 22 kVA power demand at 50 percent lagging…

A: Note: Only active power will be available in purely R Load Only Reactive power will be available in…

Q: Q2. a) A series RLC circuit is made up of a 628 resistor, an 8.16pF capacitor, and a 500 H inductor.…

A: For series RLC Circuit Q=1RLC   For Parallel RLC Circuit Q=RCL

Q: Example: A 2/2 dipole radiates a time-averaged power of 600 W at a frequency of 300 MHz. A second…

A: The solution is given below.

Q: Q7. Deduce the self-inductance of the toroid shown in Fig. 1. If N is number of turns, and the…

A: It is asked to deduce the expression of self-inductance of the toroid shown in the given figure. The…

Q: Two loads A and B are connected in parallel across a 2000 V-rms 60 Hz source with the specified…

A: Note Only active power will be available in purely R Load Only Reactive power will be available in…

Q: What is the average power of a 2V 10kHz sine wave in decibels? Answer in 30 mins or less.

A: We need to find out the average power for given voltage .

Q: a) draw the block diagram of the statcom b) give the operating mode of the statcom c) draw the…

A: STATCOM : Static Synchronous Compensator The operating features of STATCOM are similar to a rotating…

Q: 6) In the root locus plot of the system given below, what is the point where the asymptotes…

A: The control system problem can be solved as shown below.

Q: label current and voltage in each part of the wires

A: Given, We need to label and find the current and voltage in each part of the wires.

Q: Determine the input impedance of the circuit at w 10 rad/s. Zin 2 mF 2002 www 2 H m 4 mF 50 Ω

A:

Q: 1. A 30-ampere, 120-volt, UF cable circuit is buried outbuilding. The minimum depth of this cable is…

A: it is asked to find minimum depth of 30A,120V UF cable circuit buried from a dwelling unit to…

Q: What is the impedance of a circuit containing a 320 Ohm resistor, 0.1H inductor, and 6.2 µF…

A:

Q: 35 V + 10 Ω 5Ω www + V + 21. Answer: vo-10 V, vx= -5 V

A:

Q: Calculate v, in the circuit 10 cos (10t+ 75°) (+) 0.5 H 10 Q2 -18 F 10+

A:

Q: Question 1. a) Give the schematic diagram showing a shunt compensator on a distribution…

A: It is asked to draw a schematic diagram showing a shunt compensator on a distribution transformer.

Q: For an inductor in a sine-wave ac circuit, VL lags iL by 90 VL and iL are in phase VL leads iL by…

A:

Q: what is the 12) Consider a WSS random process X(t) with Rx (7) = e-all, where a is a positive real…

A:

Q: An RL circuit consists of a 45 Ω resistor and a 450 mH inductor. Randomized VariablesR = 45 Ω L =…

A: The given circuit is RL series circuit. The solution is given below.

Q: Exercise 3 Let's consider the system with the open loop transfer function given by G(p)=- close loop…

A: given here a open loop transfer function and asked to find the closed loop transfer function.

Q: What is the total capacitance of a circuit with 3 capacitors of .6mF connected in series?       a.…

A: Here we have to find the total capacitance.

Q: Calculate v, in the circuit 10 cos (10t + 75°) [m] 10 Ω F +201

A:

Q: Two delicate devices are rated as shown in the given figure. Find the value of the resistor R₁ and…

A: Given data: The total voltage across the branch AC is 33 V. The given circuit diagram is shown…

Q: § 4.3 Fixed-Bias Circuit PROBLEMS 3. Given the information appearing in Fig. 4.75, determine: (a)…

A: Fixed bias circuit is given  it is asked to find collector current( Ic) , supply voltage( Vcc),…

Q: 9) An analog signal contains (a) What range of sampling from its samples? up to 10 kHz. quencies…

A: Given: Frequency is upto 10 kHz Sampling frequency is 8 kHz The value of f1=5 kHz and f2=9 kHz

Q: In a very long cylinder of radius R flows distributed, distribution a current I. The current is…

A: Given, In a very long cylinder of radius R flows a current I. The current is volumetrically…

Q: 7 The input u(t) output y(t) relationship of an open loop plant is given by the differential…

A: As per our company guidelines we are supposed to answer only first three subparts kindly repost the…

Q: 22. Derive a mathematical model for the circuit shown below. R₁ + Vs R C= Vo

A:

Q: 29. For the network of Fig. 4.91, determine: (a) IB. (b) Ic. (c) VE- (d) VCE- 510 2 510 k *+18 V 9.1…

A: "Since you have asked multipart questions, we will solve the first three question for you. If you…

Q: (i) The nett charge of an n-type semiconductor is not negative, but zero. (ii) In the p-type…

A: The conduction band and valence band of metal overlapped. Metal have large number of free carrier.…

Q: 8. What is the Fourier transform of e-ltl cos(t)? (A) 1 (B) (C); 2 1+0² (E) 1+0² 1 (D) 1+ (0-1)² 1…

A:

Q: Consider the circuit below, with R = 7Ω, C1 = 0.04F, L1 = 1H and L2=3H, calculate the node voltages…

A: For the given circuit, voltage source is V=40 cos 5t-200 V Comparing with standard form, V=Vm cos ω…

Q: In the circuit below, find the potential difference (in V) between points A and B: 40.0 V- 80.0 V…

A: We need to find out the voltage difference between A and B .

Q: If you have a small internet station with high 20m, its maximum rang 2000m, the station work with an…

A: Given:  Transmitter height=hT=20 m, maximum transmitter range=2000m.Maximum distance between…

Q: Consider the circuit below, with C₁ = 2F, C₂ = 3F and L=3H, calculate the mesh currents 1₁ and 12.…

A: