27. In an RC parallel circuit, the voltage across the resistor and the voltage across the capacitor are - a. in phase b. 180° out of phase c. less than 90° out of phase with the resistor voltage lagging d. less than 90° out of phase with the resistor voltage leading

Let's say you measure t1/2 to be 0.037  seconds and the resistance in the circuit is 68  Ohms. Then what is the capacitance in micro Farads? Answer in micro Farads.

In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage

You are working in an industrial plant. A bank of capacitors is to be used to correct the power factor of a 480-V, three-phase motor. The capacitor bank is connected in a wye. Each of the three capacitors is rated at 25 µF and 600 VDC. You have been told to reconnect these capacitors in delta. Can these capacitors be changed from wye to delta without harm to the capacitors?

The figure below shows a capacitor network. The values of the components are as follows: • C₁ = 2.71 μFarads C₂ = 4.29 μFarads • C3=6.84 μFarads C4-9.05 μFarads . . CA . V 14.66 Volts V C3

An electrical circuit with a sinusoidal voltage source, a resistor, and a capacitor all connected in series. The voltage across the capacitor: Select one: a. Leads the current in the capacitor by exactly 90o b. Is in phase with the sinusoidal voltage source c. Is in phase with the voltage across the resistor d. Leads the current in the circuit by 90o e. Lags the current in the circuit by 90o

21

Please show work

A 47-ohms load resistor is connected in series with a 10-uF capacitor. At what frequency will the capacitor reach the same value as the load resistor?

Find the equivalent capacitance for the following circuit. Round the final answer to the nearest tenth of a decimal point. Example 12.4uF or 2.7pF. 16uF 20uF 4uF 4uF 10UF 10UF