3. For the following circuit, L₁ = 15 mH, L₁ = 20 mH, and M = 5 mH. Determine the 7-equivalent circuit. Draw the equivalent circuit with the inductances labelled.↓
Q: (a) If an H winding and an X winding short together, the result will be this is a normal mode of…
A: (a) If an H winding and an X winding short together:High current flow and transformer failure:This…
Q: Consider the system described by the transfer function G(s) = 1-Write down the state equation in…
A: In the given questions we need to drive the observable canonical form and state transition matrix.…
Q: Z- 1Ω 5 mH 1 MF
A:
Q: Obtain the Thevenin circuit.
A: The Thevenin equivalent circuit has been calculated with detail explanation. If any doubt please…
Q: * Comparator (2-bit): A B Comparator J A/B A = B.
A:
Q: 2. The signal m(t) = 3 cos 20000πt is fed to a VCO with quiescent frequency of 3 MHz and frequency…
A:
Q: The following systems Y1(s)/F(s) and Y2(s)/F Find the transfer functions. Write the state space…
A:
Q: Given a 115kV/13.2kV distribution transformer rated at 30MVA with an 8% nameplate impedance what is…
A: In this question, we need to determine the full load current. We know, Apparent Power S= √3 V I V…
Q: Use nodal analysis to find V, in the circuit below. 3 mA ( 10 kn 21, 10 kn
A: The circuit diagram,
Q: 13. The maximum primary moments in unbraced frames almost always occur at the column (A) mid-span…
A: Ans 13 :- option B is correct. Ans 14:- option A is correct. Explanation:Question 13: Option b: This…
Q: Problem Represent the electrical network by a state equation www x(0) m 1. ww € www 20 x2()) я 201
A: The given circuit isWe need to determine the state space representation of the circuit.Note :…
Q: The power applied to R1 is calculated theoretically (hand calculation) and the voltage and current…
A: In this question, we need to determine the power applied to the resistance R. Power applied to the…
Q: a.RT b. Calculate I c. Ie
A: In this question, we need to determine the equivalent resistance, current I and I8 in shown the…
Q: 1) Using D-Flip flops and 4x1 multiplexers design a 4-bit register that performs the following…
A: The load control input is a 4-bit register. In this instance, four 4x1 multiplexers with mode…
Q: Good evening, Guidance on this please. Thanks!
A: Given data: -load 1−120 KVA at 0.8PF lag (wye connected)load 2−180 KVA at 0.7PF lag (wye…
Q: b) Find current using nodal analysis. ()
A: The given circuit is drawn below:
Q: find the truth table for this circuit , thank you in advance
A: The given logic circuit isWe need to determine the truth table for the logic circuit.
Q: 1. For electric field E = E₁ei(kr-wt), show that B = -V × E = ±k × E. w
A: Curl of E and cross product of wave vector k and E is calculated in cylindrical coordinates.They are…
Q: Circuit Theory: I have this following circuit but its not producing the correct output. My input is…
A: Please refer below pages.If you have any doubts please feel free to ask.Explanation:Step 1: Step 2:…
Q: How is hysteresis detected in instruments? illustrate the effect of hysteresis on a instrument? what…
A: 1. Hysteresis in instruments is detected by observing differences in readings when the input changes…
Q: What is the ampacity of this conductor
A: To determine the ampacity of this conductor
Q: An oscilloscope is to be have an in resistance of 8Mr, a sensitivity of and attenuation factory…
A: The attenuation resistance, also known as the input impedance, of an oscilloscope refers to the…
Q: Q8. The DC biasing circuit of a MOSFET amplifier circuit is shown in Fig. Q8. The parameters of this…
A:
Q: a) Use K-map to derive a minimal product-of-sums expression for the logic function F(A, B, C, D)…
A: Given a minterrms we have to simply to minimal POS expression and For given CMOS circuit, we have…
Q: ladder diagram for bottom half of a switched receptacle is to always be hot plus a duplex receptacle…
A: The objective of this question is to create a ladder diagram for a specific electrical wiring setup.…
Q: Q3) The figure below shows the small single equivalent circuit of a single stage transistor…
A: i) 6.67 uAii) 0.6 mAiii) 2.82 Viv) 1985 ohmC= 2 uFExplanation:
Q: Q. 5)A 36, star connected source feeds 1500 kw at 0.85 pf lag to a balanced delta connected load.…
A: The given data is shown below:
Q: 4. A sample of intrinsic GaN is illuminated with a 10 mW/cm² beam of light at the blue edge of what…
A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…
Q: Find I, in the circuit of Fig. 10.19 using the concept of source transformation. ΖΩ ΠΩ wwwm I 402…
A:
Q: Q2) Using Laplace Transform solve the following equation: (Simplify and pretty the solution) -2y"…
A: The given equation is shown below..We need to find the Laplace transform.Since the initial…
Q: Needs Complete typed solution with 100 % accuracy. Don't use chat gpt or ai i definitely upvote…
A: The objective of the question is to estimate the gap flux density, the coil inductance, and the pull…
Q: A line to ground fault occurs on the terminals of an alternator, sequence voltages and sequence…
A: The given data is shown below:
Q: In the circuit shown in the figure, VA = VB = 24.0 V and R₁ = R₂ = R3 = R4 = R5 = 50.0 2. Current I,…
A: Given data: -VA=VB=240 VR1=R2=R3=R4=R5=50 ΩI5=0.120 AGiven circuit: -Find: -The current I4The…
Q: 1) Without doing any math, determine the region of operation for the transistor. Fully justify your…
A:
Q: Assume that there is short propagation delay in each of the following problems. a) Sketch the output…
A: Please refer below pages.Explanation:Step 1: Step 2: Step 3: Step 4:
Q: For unity feedback, find the steady state error for unit step input if open loop transfer function…
A: The given data is shown below:
Q: please help how to know if they are given terminal voltage or phase voltate. what is the difference…
A: a) 1200 rpm, 125.66 rad/sb) Ea= 12.113 kV, Efficiency n= 90.78%c) 10kV since connected to infinite…
Q: The voltage v(t) shown in Fig. P7.85a is given by the graph shown in Fig. P7.85b. If i(0) = 0, how…
A: The power supplied by a source, such as a battery or a power supply, refers to the rate at which…
Q: Given the circuit below, what is the steady state i(t) (Hint: use superposition). Also, plot the…
A:
Q: Using the step-by-step method, find the value of the output current, io(t), just before the switch…
A: The given data is shown below:
Q: 3.17. Compute the Fourier transform of the following signals using the Fourier transform table and…
A: Please refer below pages.If you have any doubts please feel free to ask.Explanation:Step 1: Step 2:…
Q: 16.59 Assume zero initial conditions. Find v,(t) for t> 0. [et + 1.42e-0.5t cos(0.5t + 135°) V] +1-…
A: The given circuit is The initial conditions are zero.We need to determine the expression for vo(t)…
Q: Determine i(t) and i2(t)! E(t) = 60 V, L = 1 H, R = 50 2, C = 104 F. And i and i2 are initially…
A: In this question, we need to determine the currents in the circuit. We solve this problem using the…
Q: 3. For a first-order system, we can measure its magnitude ratio and phase lag for varying AC…
A: In many engineering and scientific applications, understanding the time response of a system to a…
Q: Is = 10 Arms Determine the instantaneous energy stored in the transformer wirings at t=0. The…
A: Given:with We need to determine:the energy stored in the transformer wiring at time t= 0s.
Q: 10 HE v(t) 1+ +1 ww 2i(t) i(t) ell 2 H
A: The given circuitFind the value of v(t) for t>0.i(0)=2 A
Q: 4. A sample of intrinsic GaN is illuminated with a 10 mW/cm² beam of light at the blue edge of what…
A: Power of the light is The electron mobility is The hole mobility is intrinsic carrier density is
Q: Question 1: Use properties to compute the Fourier transform of the signal plotted below: 1 0.8 0.6…
A:
Q: 2. Calculate the output current io, where v = 1.4 V. 50 ΚΩ ww 10 ΚΩ +1 V1 ww 20 ΚΩ
A:
Q: Construct the circuit in Figure 1 in the Circuit JS simulator. Note that the voltage source is given…
A: Please refer below pages.Explanation:Step 1: Step 2: Step 3:
Step by step
Solved in 3 steps with 4 images
- Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?Q19. For the series-parallel inductor circuit shown in figure B19, answer the following questions. L2 2mH 4mH L3 L4 SMHS 5mH 3.5mH L6 8mH L7 2mH L3 4.5mH e Figure B19 Determine the inductance, L3 value. ii) If E is the energy stored in inductor for current, Calculate the energy if the current value is increased twice.At 0-, no currrent flows through the capacitors because they are open, how did you combine the capacitors for the voltage divider since it is the capacitance value and not reactance, is it right? Can we just combine the capacitance value? Please explain. I did not understand..
- Let's say you measure t1/2 to be 0.037 seconds and the resistance in the circuit is 68 Ohms. Then what is the capacitance in micro Farads? Answer in micro Farads.For the series-parallel inductor circuit shown in figure B19, answer the following questions. 2mH 4mH SmH 3.5mH 8mH 8mH n2mH Figure B19 Determine the inductance, L value. If E is the energy stored in inductor for current, I. Calculate the energy if the current value is increased twice.Define what is used to determine the "steady state" of the charge/discharge phase of an RC Circuit. Which of the two phases takes longer to reach steady state for this circuit, explain.
- The picture shows three LC circuits, two of them with capacitors of capacitance C and the three with coils of inductance L, the three circuits are coupled by means of two capacitors Cc capacitors.L inductance coils, the three circuits are coupled by means of two capacitors of capacitance Cc. The currentscirculating through each mesh are those indicated in the figure: I1, I2 and I3. Using Kirchhoff's law for voltagesand taking into account the definition of current I = -dQ/dt, find the system of coupled equations for the systemand then find the angular normal frequencies of the system.4. A RC series circuit is composed of a resistor of resistance 50 ohms and a capacitor of capacitance 100µF. It is suddenly disconnected from a source voltage of 12V. Determine the time it takes for the voltage across each element is equal and determine the rate of change in the current at this time.1. Enumerate five formulas for series-parallel capacitances across Vt source and draw the circuit. 2. Enumerate five formulas for parallel-series capacitances across Vt source and draw the circuit.
- Figure 2 shows three "LC" circuits, two of them with capacitance capacitors "C" and the three with inductance coils "L", the three circuits are coupled by means of two capacitance capacitors "Cc". The currents that circulate through each mesh are those indicated in the figure: "I1", "I2" and "I3". Using Kirchhoff's law for voltages and taking into account the definition of current I = −dQ / dt, find the system of coupled equations of the system and then find the normal angular frequencies of the system.6) When the frequency of an a.c. circuit containing resistance and capacitance is decreased, the current (a) decreases (b) increases (c) stays the same 7) In a series a.c. circuit the voltage across a pure inductance is 12 V and the voltage across a pure resistance is 5 V. The supply voltage is (a) 13 V (b) 17 V (c) 7 V (d) 2.4 V 8) The impedance of a coil, which has a resistance of X ohms and an inductance of Y henrys, connected across a supply of frequency K Hz, is (a) 2π Κ Υ (b) X + Y (c) √x² + y² (d) √X² + (2nKY)² 9) When a capacitor is connected to an a.c. supply the current (a) leads the voltage by 180° (c) leads the voltage by 1/2 rad (b) is in phase with the voltage (d) lags the voltage by 90° 10) In an R-L-C series a.c. circuit a current of 5 A flows when the supply voltage is 100 V. The phase angle between current and voltage is 60° lagging. Which of the following statements is false? (a) The circuit is effectively inductive (c) The equivalent circuit reactance is 25 2 (b)…6) When the frequency of an a.c. circuit containing resistance and capacitance is decreased, the current (a) decreases (b) increases (c) stays the same 7) In a series a.c. circuit the voltage across a pure inductance is 12 V and the voltage across a pure resistance is 5 V. The supply voltage is (a) 13 V (b) 17 V (c) 7 V (d) 2.4 V 8) The impedance of a coil, which has a resistance of X ohms and an inductance of Y henrys, connected across a supply of frequency K Hz, is (a) 2π Κ Υ (b) X + Y (c) √x² + y² (d) X² + (2nKY)²