3. Evaluate the following. Express answers in polar form. a. b. 5+j30 4-j6 (28 (65°) (45-30°) 6+j8 2/15° 14+j8 APUA ISTRIBU 6 + j4 + 5/18° ribution to jefausto@mapua.edu.ph

Q: Consider the circuit given below, where R₂ = 10 KQ. Calculate the capacitance required for good…

A:

Q: What would be yielded after simplifying the following Boolean expression Y = (A + B+C) + (B+C) 1. Y…

A:

Q: Coulomb's Law and Field Intensity Prob 4.1 Point charges Q₁ = 5 μC and Q₂ 5 μC and Q₂ = -4 μC are…

A: Given that

Q: How to create a procedure to solve any DC circuit with any number of resistors

A: Let R1  R2 and R3 connected in seriesReq=R1+R2+R3Let R1  R2 and R3 connected in…

Q: 5) Prove if the following system is linear or not? y(t) = [₁ xdt + 4x

A:

Q: 6. The Laplace transfer function of a certain first-order system is 12 G(s) = 0.4s + 1* Its input is…

A:

Q: Question- (Transmission line) A transmission line has a characteristic impedance of 50 2 and a…

A: A transmission line- Characteristic impedance- Z=50 ohm, Resistance- R=0.01 ohm/m, Line is…

Q: Two generating units are online and have the following characteristics: U₁(Gas Fired) F₁($/day) =…

A: Given Two generating units with characteristicsU1(gas fired) F1($/day)=200+20P1+0.006P12 100…

Q: f(t), shown in figure is f(t)= a, +Σa, Cos nt + b Sin nt n=1 The value of ao is f(t) iw esse omnon…

A: In this question,  We need to determine the value of ao  as given in the question.

Q: Find convolution f ∗ g when f = sin t and g = t. Also verify that L{f} × L{g} = L{f ∗ g}.

A:

Q: the sensor that preferred to use for detect magnetic field intensity الاختيارات thermocouple RTD…

A:

Q: Calculate the value of Bpc = [] no units, Given the Value of Ic= 18 mA and the value of lg = 250…

A: In a BJT, Collector current, IC=18 mA. Base current, IB=250 μA.

Q: a) The resonant frequency in kHz. b) The voltage drop across the resistor at the resonant frequency.…

A: For the given RLC circuit need to calculate  a) The resonant frequency in kHz. b) The voltage drop…

Q: a) Find the node voltages V₁, V2, and v3 in the cir- cuit in Fig. P4.21. b) Find the total power…

A: It is given that:

Q: Two wire systems have the voltage at the supply end maintained at 500 V. The line is 4 km long. If…

A: 2 wire systems- Resistance of the cable R=0.5 ohm/km, Full load current Ifl=15 A, Length L=4 km. To…

Q: A N = 245-turn solenoid with inductance, L = 75.8 mH, is wired in series to an emf, ε = 60.5 V, a…

A: Given Circuit: Inductance L=75.8mH Resistance R=12.2 Ohms Emf E=60.5Volts No. of turns=245 To…

Q: Let he(t) as the impulse response of an LTI continuous time filter. ha[n] as the impulse response of…

A:

Q: Exercise | 7.2.65 (a) Find io (t) for t > 0 in the network shown below using the step-by-step…

A: In this question we need to find current io(t) for t>0

Q: 3) Find RL and maximum power transferred Μ + 1 ΚΩ 2000 Ix Μ 3 ΚΩ 4 mA 52 · 2 ΚΩ Ix Μ 4 ΚΩ RL

A: Asked to find Value of RL Pmax maximum power transferred to load

Q: A current of i = -6 + 8 √2 sin (wt + 30) is passed through a centre zero PMMC meter and a moving…

A:

Q: Given dF₁/dP₁= 20+ 0.4P₁, dF₂/dP₂ = 30 +0.4P₂, and Poss = 0.0004P2 +0.0006P² Assume the load = 1000…

A:

Q: In the demodulation of binary PSK signal received in white Gaussian noise, a phase locked loop is…

A: In a demodulation of binary PSK signal,the carrier phase is, ϕ=45°.We have to calculate the loss in…

Q: 3. Find the reactive power delivered by the current source, and the power factor of the circuit if…

A:

Q: Calculate the impedance-parameter equivalent of the given circuit where R=10 02. 20 Ω 20 Η 0000…

A:

Q: Problem #1: Use phasor circuit analysis and node-voltage analysis to find vi(t).

A: For the given circuit the node voltage VB(t) needs to be calculated by using the nodal analysis and…

Q: a) Find the node voltages U1, 02, and v3 in the cir- cuit in Fig. P4.21. b) Find the total power…

A: It is given that: We need to determine a) The node voltages V1,V2 and V3. b) The total power…

Q: It is desired to achieve K v = 40,000 for the system shown below, when G(s) O a = 2.0833 O a 3.1198…

A:

Q: Consider the circuit shown in (Figure 1). Suppose that Vdc = 375 u(t) V. Assume that the initial…

A: In these questions,  We need to determine the current i1  and i2  at the time t--> ∞ We know…

Q: 5. The electric field phasor of a uniform plane wave traveling in a lossless medium with an…

A:

Q: 8. 2/0° A -j2 n j4Q 12/0°V 202² + V₂ Solve problem using superposition.

A: According to superposition theorem the response in a circuit is the sum of the responses calculated…

Q: Problem 6 In Lec. 7, we calculate the Ohmic power dissipation of P=11² R. by using the Ay known…

A: Let's start with the expression for Poynting vector, which represents the power per unit area…

Q: Assume: Vdd=3V, P consumption =3mW, Output swing 2.6V, Overall gain 1000V/V, L=0.4um Equal Veff for…

A: Assume Vdd=3V, P consumption =3mW, Output swing 2.6V, Overall gain 1000V/V, L=0.4um Equal Veff for…

Q: Figure 3 A B B # # A C 요요 C

A: Asked to write boolean expression for given ladder diagram.

Q: A 3 bit modulo-8 ripple counter uses JK flip-flops. If the propagation delay of each flip-flop is 40…

A: The propagation delay of each FF is given as tpd-FF=40 ns.' The strobe pulse period is Ts=10 ns.…

Q: The secondary coil of a high-voltage electric generator is an air-core solenoid with length 1 = 1.8…

A:

Q: Find K (the constant) for the magnitude characteristic plot shown in Fig. P12.31, given t1 = 2…

A:

Q: Voltage across 2

A:

Q: Examples given in class such as BaTiO3 and Pb (Zr, Ti)O3 (PZT) show enhanced dielectric properties…

A:

Q: From the given figure, determine the following: R₁, R2, R3 I1, I2, I3 V₁, V2, V3 P₁, P2, P3 RT, IT,…

A:

Q: 3. Please describe the working principles of MOS in (a) and (b) in Figure 2, and explain why the…

A: In the given questions we need to discuss about the working of CMOS inverter.

Q: What is the purpose of a diode in an electronic circuit?

A:

Q: 4. When gate to source voltage of JFET changes from -3.1 V to-3 V, the drain current changes from 1…

A: In this question we need to find the transconductance .

Q: 1FZ ΤΗ voo 12 V Α 2Η 6Ω 2F 3Ω 3Ω

A:

Q: What is the power transmitted inductively in an auto-transformer which supplies a load at 161 volts…

A: An auto-transformer- Load at 161 volts, VL=161 V Primary voltage VH = 230 volts, To Find- The value…

Q: 21. Which of the following RLC circuit will have its capacitor voltage decay the fastest? a) R = 50…

A: As multiple MCQs have been asked, as per Bartleby guidelines only the first 3 i.e. 21, 22, 23 have…

Q: Consider the block diagram below. R + + I E 1 s+1 1 S+4 1 s+2 If R is a step function with amplitude…

A: Given block diagram is  The input is a step signal of amplitude 4. We need to determine The steady…

Q: (i) (ii) (iii) :4Ω Solve the circuit using mesh or super mesh analysis. Find the voltage across 802…

A:

Q: closed-loop system is shown in Figure Q8 below. Gain K, is positive. K S² +85-9 Figure Q8 : system…

A: The given block diagram of the closed-loop system is shown below. Here gain K is positive. The…

Q: The Fourier transform P() of a the basic pulse p(t) used in a certain binary communication is shown…

A: The Fourier transform of a basic signal is shown below,

Q: A 5 bit Digital to Analog converter has a current output. When the digital input is (10000)2, the…

A: Number of bits of DAC=5, When the digital input is (10000)2, the current output is 8 mA.